5 жыл бұрын
5 жыл бұрын
5 жыл бұрын
5 жыл бұрын
5 жыл бұрын
5 жыл бұрын
5 жыл бұрын
5 жыл бұрын
Пікірлер
@lukebrindley2585 5 ай бұрын
The camera’s too far away to see what you are adjusting
@holly8010 10 ай бұрын
Hi the glass of my pool gate has dropped at the latch side, any tips on how to correct this?
@Bajaguy75 Жыл бұрын
A close up view would be helpful. From what i can gather, you have to pull a pin out before adjustment, but i can't pull the pin out on mine. If you showed a closer view of what you're actually doing, it would be easier to understand the process.
@Bajaguy75 Жыл бұрын
For those who have the same issue as me, I found a video that shows clearly what you need to do: kzbin.info/www/bejne/g53FZmBjhclsbqc
@bobyazdani4885 Жыл бұрын
thanks a lot
@Benb55 Жыл бұрын
Hi, My problem is the gate doesn’t close anymore. I have to lever the hinge with a screwdriver to be able to close the gate. Do I need to loosen or tighten the tension in the hinge in order for the gate to close properly again? Do I do what you’ve shown in this video to fix that problem or is there something else I need to do? Cheers Ben
@jasonterrill3056 Жыл бұрын
Hi Ben, there are a few possible reasons why the hinges are not closing. The hinges could be out of alignment, they must be square and on the same plane so there is no friction. The hinges could be at the end of their usable life and need replacing. One or both of the springs could have failed or rusted inside the housing. A simple way to test them is to remove the gate assembly and check the operation of each hinge and see if you can tension the hinges with no load. If the spring is rusted or broken the hinges are a sealed unit and cannot be replaced. I hope that helps
@Benb55 Жыл бұрын
@@jasonterrill3056 Thanks for getting back to me Jason. I have. Feeling the whole gate frame has “moved” a few mills and that’s caused the problem. I think I need a professional to come and sort it out. The screws are impossible to shift on the latch itself. It probably 10 years old. I’m in Sydney.
@sapaypa 2 жыл бұрын
Hello what is the needed spacing in between spigot if i have a solid 385cm glass width?
@gertsy2000 3 жыл бұрын
Eventually your slamming shuddering gate will break.
@davidruse3292 3 жыл бұрын
Thanks for the video. This is the only I have found so far that mentions the importance of the gate closing at such a small distance from the latch, as you showed in the example at 01:52 . Wish I had seen this before I had my pool barrier inspected. Thanks
@jasonterrill3056 3 жыл бұрын
Hi David, building inspectors have to know the details of hundreds of building elements and systems, as long as the basics are covered and it’s safe that’s what counts. Thanks for the feedback and happy we could provide an answer.