10 ай бұрын
10 ай бұрын
10 ай бұрын
10 ай бұрын
Пікірлер
@jorgeguzman9955 Күн бұрын
Very good
@davebates7910 3 күн бұрын
Rich, where was the location of this SDR receiver that you streamed ... ??
@luolin2 3 күн бұрын
I just got my KX2. I am learning from scratch about antennas. So you put your counterpoise using a mini banana plug and a wire? I have the same antenna set up and was wondering where to put the counterpoise. I have seen some use the side panel screws. I am still confused about the ground and counterpoise situation. Your video was the first I have seen up close. I am also going through the KX2 manual. Thanks for the video.
@mrtechie6810 7 күн бұрын
Did you try Thetis?
@HamRadioAdventures 6 күн бұрын
It’s good to hear from you and thank you for commenting. Yes, I think that’s the one I’ll be using most. 73 and good DX!
@adekyou 4 күн бұрын
Hello,, Can thetis be used with e.g. RSPdx + FTDX10? Or is it only dedicated to apache labs?
@HamRadioAdventures 4 күн бұрын
sorry no, it is for Hermes and ANAN
@KD9ZHF 8 күн бұрын
So you run IQ out of the ICOM 7610 to HDSDR?
@HamRadioAdventures 7 күн бұрын
Yes sir!
@CC-hk6vy 9 күн бұрын
Not a fan of new GT2...
@HamRadioAdventures 9 күн бұрын
@@CC-hk6vy there’s JT alert. Have you used that one? It works well but if you’re using HRD logbook that alert feature they have would work and take the place of it.
@luis.s.martin 9 күн бұрын
ThanX so much Rich for such good info!!
@HamRadioAdventures 9 күн бұрын
Thank you!
@bakayattila2968 10 күн бұрын
Hi! Am HG5OGU Can you help me in HDSDR how i can change the vertical rato between RF/AF display? I need bigger RF waterfall.. Thanks ant the upload too. 73
@vnonkwinn6233 11 күн бұрын
mitch McConnell? the cornel
@vnonkwinn6233 11 күн бұрын
Some of these's guys are very old and some are kinda racist. (fuk it)
@philipchandler330 12 күн бұрын
Thanks so much. I need your help. I was just gifted a KX2 by an old Elmer who was CW solely. I can't get the KX2 to operate in SSB via phone. When I talk I get ERR TXC error message.
@MegaRtty 13 күн бұрын
Thank you!
@HamRadioAdventures 13 күн бұрын
After you install it, is it missing in Device Manager? Is that the trouble you have?
@HamRadioAdventures 13 күн бұрын
My email is good on qrz.com. If you send me an email with “HDSDR, please help” in the subject line. I’ll find it and will respond to you.
@2e1paw Күн бұрын
Yes
@2e1paw 13 күн бұрын
Hi I’ve tried so many times now and I just can’t get it to go ……. I install everything plug usb in and turn on radio but it’s never in the BUS CONTROLLER SETTINGS , can you help
@mikehartman9809 14 күн бұрын
Thanks OM Great Vid...Just subscribed...all good stuff! Nice and easy. Good Job! 73
@HamRadioAdventures 13 күн бұрын
Thank you so much for commenting! Glad it helps and thank you for subscribing! Best 73 and good DX.
@HamRadioAdventures 14 күн бұрын
The IC-7610 offers exceptional performance, with excellent sensitivity and selectivity, ensuring clear and reliable communication even in challenging conditions. Thanks for the video! 73 de K0PIR
@mikeramsey9747 15 күн бұрын
Great video and I feel confident the conflict between HRD and WSJT-X (both trying to use Com port 4) will hopefully resolved when I receive the Programming cable that you recommend. THANK - YOU!
@HamRadioAdventures 15 күн бұрын
Thanks, Mike and I found that cable comes in handy. I’ve got two of them one for the house and one for the camper. Best 73!
@charlieoscar09 18 күн бұрын
Why are the Americans using the the term " Line " there are no lines that finished in the 50's and the telephone exchanges .....I'm confused
@HamRadioAdventures 17 күн бұрын
Yeah Charlie!
@wt9u 18 күн бұрын
What about change bands? Is there a way to automatically track?
@HamRadioAdventures 16 күн бұрын
Thank you for commenting and I am setting up. CW skimmer on a new computer. I’ll be doing update videos. I’m sorry, but I don’t understand the question. Can you elaborate?
@wt9u 16 күн бұрын
@@HamRadioAdventures I would like to use the wideband capabilities without having to change settings in HDSRD and CW Skimmer when changing bands. I may be stuck with 24kc BW otherwise.
@RichKielbasa 18 күн бұрын
I was trying to work Roberto but no luck. I couldn't here myself in the pile ups. Luckily, I made a good QSO on 7.182 with Paul out of Spain. He gave me a 5-9 and I'm 90 watts and a wire. 🎚️🎛️ 📻
@YaLatifuYaLatif 19 күн бұрын
so how could i use this to hang out with my grandpa? what's the way to have an all day conversation with him using the direct radio to radio earth connection method?
@YaLatifuYaLatif 19 күн бұрын
oh but then everyone would be listening and they would get annoyed.
@YaLatifuYaLatif 19 күн бұрын
wait so if i wanted to bug my granpa in puerto rico from florida i could do that walkie talkie style at all times? hahaha
@YaLatifuYaLatif 19 күн бұрын
oh wow i get it so you use the global magnetic energy to tune into the same global frequency out there
@YaLatifuYaLatif 19 күн бұрын
that's so coooool 😄
@seanplynch 24 күн бұрын
Nice!! 👍
@HamRadioAdventures 23 күн бұрын
Thanks Sean
@joelbahl6830 24 күн бұрын
Dang popups cover your content.
@kg5pte 28 күн бұрын
Hello using this same Amp (AL-811) Not the 881H. With my Yaesu FT-710 and MFJ 989C Tuner and KIO Hex beam antenna. I noticed that the Yaesu FT 710 only goes to 25 watts max on AM but goes to 100 Watts on SSB FM CW or RITTY. And only goes as low as 5 watts not to zero. I been learning how to tune up mine. So you say start on with the radio (Exciter) at 25 watts tune up then go to 40 watts and tune up then go up to say 60 watts and tune up. Yes I know you do not want to exceed 700 on the plate current nor 150 mA on the grid current. Thanks for the video it does help to know adjust plate first then grid. And wait a few seconds between adjustment. I am making notes on my settings for the frequencies I talk on, I did notice this amplifier does not do 28 MHZ. Thank you.
@HamRadioAdventures 23 күн бұрын
Thank you for commenting and I’m sorry I missed your reply earlier. The important thing is not to go fast. Speed in tuning will pick up later. It’s important to re-tune the plate. W6LG has a good video on this using an LB4 amp. There are different ways that people tune these up, but essentially they’re the same. Good luck 73 and good DX!
@petersorensen9440 Ай бұрын
Ten Tec Omni A
@GilbertBaron Ай бұрын
How to record serial number. or snatching that changes. W0MN.
@HamRadioAdventures Ай бұрын
@@GilbertBaron That’s an excellent question and I can’t answer it off hand. I should get on the contest. Sri, 73 and good DX!
@hamlive7923 Ай бұрын
Very professional video production here!
@HamRadioAdventures Ай бұрын
Full atricle: k0pir.us/icom-7610-no-fill-spectrum-scope-waterfall-improvements/
@HamRadioAdventures Ай бұрын
Full article: k0pir.us/icom-7610-firmware-upgrade-v1-42-digital-pre-distortion-dpd/
@HamRadioAdventures Ай бұрын
More to come as I am uploading a new video on this. HDSDR has changed some. #hamradio #hdsdr #icom7610
@bobhs1605 Ай бұрын
I’m extremely new with ham radio. I’ve built and owned several sw radios but know very little about ham. I bought one of those Chinese ats25x2 units. I have an 80 foot long wire antenna. I live in Taiwan and I haven’t ever ( in 4 months picked up any ham conversations). I get lots of sw from many different countries, but why can’t I get any ham?
@HamRadioAdventures Ай бұрын
What frequencies are you listening to?
@RickandGabe Ай бұрын
Nice video, very helpful and I'm sharing! 73!
@HamRadioAdventures Ай бұрын
Greetings to new subscribers! Welcome and thank you for liking and subscribing.
@HamRadioAdventures Ай бұрын
Greetings to new subscribers! Welcome and thank you for liking and subscribing.
@HamRadioAdventures Ай бұрын
Greetings to new subscribers! Welcome and thank you for liking and subscribing.
@HamRadioAdventures Ай бұрын
Greetings to new subscribers! Welcome and thank you for liking and subscribing.
@HamRadioAdventures Ай бұрын
Greetings to new subscribers! Welcome and thank you for liking and subscribing.
@HamRadioAdventures Ай бұрын
Greetings to new subscribers! Welcome and thank you for liking and subscribing.
@HamRadioAdventures Ай бұрын
Greetings to new subscribers! Welcome and thank you for liking and subscribing.
@peterspero4692 Ай бұрын
Nice video, thank you. My parents and I used to tent camp in Ocala when I was a kid. I'm looking for a spot to tent camp that's secluded, and quiet (without RVs if that's possible), and near trails and wildlife. Can you make some recommendations? My ultimate campground would have lots of forest between campsites. Thank you in advance for your thoughts.
@HamRadioAdventures Ай бұрын
It's nice to hear from you and thank you for commenting, it really helps me. Out of the places in Florida I have been, the Apalachicola National Forest was the best. I liked the large camp sites and there are a few campgrounds to choose from. I don't think you can go wrong there. GL and good DX! 73 de K0PIR
@jeffdo9195 Ай бұрын
How are you getting audio?
@HamRadioAdventures Ай бұрын
Hi Jeff, audio comes in the USB Cable from the transceiver to the PC. Is that what you meant?
@HamRadioAdventures Ай бұрын
I'm working on DPD in the new firmware. It looks amazing!
@christianpersico2957 Ай бұрын
73+f4hgp christian very good tks
@hamlive7923 Ай бұрын
73 OM
@richsabo1 Ай бұрын
I don't use rig control, can ACLog still work with WSJT-X?
@HamRadioAdventures Ай бұрын
Hey, thanks for commenting and it’s good to hear from you. I don’t always use my rig control with my logging programs, but I do use it with WSJT-X. I hope that answers your question. 73 and good DX! 😊
@richsabo1 Ай бұрын
@@HamRadioAdventures what i was trying to ask, can I use this software for logging not using rig control. I do not, cannot use rig control, so will this still log my contacts?
@HamRadioAdventures Ай бұрын
@@richsabo1 RR In ACLog, transceiver setup, disable(stop) polling. Or, just don't setup Transceiver control in ACLog and it won't start polling. Polling means it is trying the connection to the rig. I use it like that with WSJT-X. WSJT-X copies over the freq., mode, etc. GL and hope to catch you on the air! 73!
@richsabo1 Ай бұрын
@@HamRadioAdventures Thank you much my friend.... I am going to try it! Yes hope for a cantact.....73!
@n5pa Ай бұрын
I updated my 7610 from Version 1.30 to Version 1.42 this afternoon and it updated everything Easy-Peary! I used 16GB SD cards instead of a USB Thumb Drive.
@HamRadioAdventures Ай бұрын
Good to hear and I want to check out the pre-selector functionality. Best 73 and good DX!
@TallyTechandTroubleshooting Ай бұрын
I don't have a 7610 (Yaesu FT-710), however your detail and "care" for others says it all! -73 KQ4KIO
@HamRadioAdventures Ай бұрын
Thank you my friend! Best 73 and good DX!