nice job dude the way it somehow coughed made it better

does the display turn off or is it suppose to show the time all the time/?

How do you get the white cover off of the timer? Thanks!

I'm glad she's not the only one . ❤ She has changed many men's life's

What is the pressure reducing valve supposed to be set to for the filtration ?

🔥🔥🔥

You skipped over the power portion. Does it just plug into a standard 120 V receptacle?

That is Absolutely Hilarious!

Did not cap the old line or the leak ???

It looks like the drip leg is before the valve, it should be after so you can service it. Also in my state you have to have a CPVC or Copper to dump from T&P valve.

Seems like people said just about everything. Couple of people should have watched the video a second time… 🙄 just cause it hasn’t been said I’m gonna say not enough air gap in the t and p. Also not seeing the pan draining to anything so it’s basically useless. Also no foam pad under it

😂😂😂😂😂😂😂

😂😂😂

1/2" water line when it should be 3/4"

I'm a plumber and I approve this message 😊

No earthquake straps required for water heater in your area?

Damn shes an expensive tool too. But damn i love her and what she does.

Agreed she’s my ride or die

Maybe you could have oriented the shut off valve on the cold side further away from the ground connections so that it could function easier

Usually I push excess into the wall instead of cutting it short

You need to raise your water heater on a stand cause it's gas

Gas flow has to hit the wall of the tee before going in?

Gas heaters are supposed to be on a stand?

Relief line needs to be hard pipe?

Very insightful

I would have made the lines 3/4 a little higher

Press tools sound like a turtle fucking/dieing.😅

Expansion tank can't be supported by the pipe,and its upside-down.

Is that half inch on the copper?

Houston requires sediment trap at appliance, t&p needs to be cpvc/copper discharge in a drain or outside and looks like your vent baffle wasn’t seated properly

In Texas water heater water lines or in 3/4 not 1/2”

Yes....using pro press

Yeah, you have no idea how to use a pipebender, too many fittings.

Is that pan plastic? Hard to tell but if it is, it’s incorrect.

B setting is way too hot 😂 plus expansion tanks now have to be facing up and 18” away from vent

In Utah the expansion tank needs to be mounted in a bracket on the wall, the saddle valve should’ve been replaced with a tee and angle stop

you may need to support your expansion tank.

In Connecticut it’s against code to put expansion tank upside down. Needs to be mounted on wall and piped too. Super annoying

I'd say its missing a hammer valve.

Succesfully neutered the entire house's hot water capacity by undersizing the cold feed AND hot supply water lines?

Did you tighten the hot water side?

Onions?

Didnt reconnect what was connected to the saddle valve?

Looks good, but OSHA would have a field day with all the safety violations.

Nice how-to 👍🏻

Full video: kzbin.info/www/bejne/eIC4qGqnf5iBa8ksi=MedmqEh4xUSA4P96

this song just showed up in my feed as i was listening to other vids Blue Boy - Remember Me

😂

😂😂😂

So, I always install the tank with the Schrader valve up. My logic is that the bladder inside the tank won't have the weight of the water on it. Now some would argue that entrained air will gather beneath and cause corrosion. So with that in mind, I always replace the tank when I replace the water heater.