How do you load tpu into it? I have a Tronxy xy-2 and overture tpu but cannot get it in the printer. Pls help...
@Lixiimm2 Жыл бұрын
We did so good!!❤️
@spamattack123 Жыл бұрын
Great job!!
@sparklyspam12333 жыл бұрын
Heheheheehehehnsrj rjfntjf
@sparklyspam12333 жыл бұрын
Helloooo
@spamattack1233 жыл бұрын
Thanks
@chrisalton14 жыл бұрын
much appreciated
@cheyennef.29354 жыл бұрын
A
@cheyennef.29354 жыл бұрын
Do you remember the print speed, temp, and infill of the puppy I was thinking of getting some flex filament for my engineering class.
@spamattack1234 жыл бұрын
Speed was 40mm/sec temp 240c 12% infill density
@cheyennef.29354 жыл бұрын
Thank you
@markklemens11009 жыл бұрын
Learning to fly - Foo fighters
@sungbae_vvs22349 жыл бұрын
song's name? and nice video bro !!
@sleddarcheddar10 жыл бұрын
Why are you flying so close to radio towers? That's a big no-no.
@spamattack12310 жыл бұрын
The owner and I wanted to verify orientation of the radials from the air and there was nothing even close to the 2.4 or 5.8ghs range
@sleddarcheddar10 жыл бұрын
Oh, I was under the impression that the noise floor would be elevated being so close.
@bchervenyakov10 жыл бұрын
Did you find what was the reason? Why the quad didn't enter in FS? What about forced FS?
@spamattack12310 жыл бұрын
Nothing was found wrong mechanically I assume controller failure?
@1avocado15 жыл бұрын
hahaaha keep budda singin songs like this and he'll never get a chance to sip on that beer i am SO pleased to see this! can you tell?
@1avocado15 жыл бұрын
wow the audio comment thing is new to me. i should have written something far more intelligent. wink wink. whoever did camera rocks. you got a good natural response out of budda and it was a great angle.
@1avocado15 жыл бұрын
budda sounds sooo good! great job everyone! wish i was there, i would have danced for sure -maca