Terrible audio

hey sir what was that ebay website that buys the radios ?

Do you use the purple and green rca for back

Do you have the engine tilted up or down? I am curious, we are planning a 75 mile run down the coast.

Super helpful! Those things are $120 now!

Question? Here at Pickwick flotation devices must be worn by all while locking through. Is this for all locks.

This was so interesting. Love the sound of the go fast boat!

I have the same radio and have been trying to install in my slk, do I need a second ground look isolator for the right and left rear speakers that are behind the seats?

two zip ties and soapy water that install takes 30 s

you should put an voltage raising unbalanced - to - balanced (non-differential - to - differential) line driver in between the after market head unit and the factory bose amplifier, otherwise you will lose and least 50% of the required pre-amp line-in voltage and you will never drive the bose amplifier with the signal input strength it wants- i retrofitted the bose 2 ohm door and rear speakers and bose amplifier and LHD loom into my RHD r170 (which had only 4 ohm door speakers, no rear speakers, no amplifier when i bought it), added a now discontinued AudioControl Overdrive (not the Plus version) , head unit is a Becker 7990 with Becker iPod controller, looks and sounds as factory, its been a good setup since 2009

Hello from Australia after watching you video l purchased a JVC KD-T752BT stereo and there is no sound coming l wired the black red yellow orange and blue antenna wires to the 70-1786 Car Stereo CD Player Wiring Harness just like you did and there is no sound

they did not require you to wear a PFD? your wife?

Great detailed video, thank you for sharing

Good video, thanks for the info

This was great, really wonderful performances throughout. This is so special!!

Do you know how to access the bulb? Mine turns on, but no light comes out.

Did yours fail completely? Mine isn't spraying properly, on passenger side i'm getting no spray at all, decent on driver side though. Also sometimes i have to press the switch multiple times for it to spray.

Wow, classic use of the wrong tools, lose the pipe wrench and use a trim removal tool. Makes the job so much easier.

Thanks ,,, I have always wondered what the procedure was 👍👍😎😎

cảnh đẹp quá đi

Thanks so much for this video - very much appreciated (as I am a boater on the Upper Mississippi River) and am fairly new to locking through. 💯 🙌 👍

I’m researching a 2004 Mariner and found your channel. Would you recommend them? Are Crusader engines reliable? Thanks

Hi Dougie from a KQRS listener

Interesting. I took a canoe with two other guys early fishing season 1970-71 north of Red Wing. I cant remember the lock but it was near the town where Anderson windows come from We were ready to portage the canoe past the lock when the operator said he would lock us down river. We put in the lock as you see in this video with the line the operator had. The lock was much bigger than my 16" Grumman so I had to do a bit of paddling to the gate. .. We fished a bit (Frankly this was as dumb as it gets as we were drinking beer as well. Nothing like trying to pee in a canoe in early spring in Minnesota) We caught nothing soo headed back and were locked back upriver. An experience I am lucky I'm alive to tell. We were living in Anoka or Champlin at the time.

During the fall we would take our boat off the lake and hit the river. So much fun going through the locks up in the twin cities.

Well done. This will be very useful for new boaters.

I worked in reconstructed Ford lock and dam for about 3 maybe 4 years. All because the little boats where flipping over when filled up. Was a great job blowing that thing up.

what a butch job. seriously???

for future reference, if you use a small flat blade and pop the initial pin on those little plastic clips.. you will save yourself a lot of time and headache ;)

Interesting to watch after seeing the tows go through lock 19 at Keokuk.

Maybe you could be a instructor how to go thru the lock they could call you the lock master

My crew does it in 45 min

Love it!

Don't cleat off, correct!!! You can end up dumped out or sunk. thanks for videoing this. I appreciate when people share knowledge!!

That isn't a small boat.

Nice shirt Doug Hometown

Did you end up connecting the ground loop isolator to ground? That would have been when the GoPro died... Thx!

Tengo 1 , vendo

Awesome song to sing for Communion. Dear Jesus, Let It Be!

Why would you shut your engine off. I know you said it's courtesy I've worked on commercial fishing boats must my life and we never shut the engine off going through the lock

liked the way you showed the removal of the pump. I was wanting to know the dificulty of getting to it. Thanks

289.00 for the dealer to fix it. Never buying another Mercedes. Way to many repairs..

Question, I heard you say they monitor channel 14, would that be Marine VHF or standard c b

first screw all the slow shit they r goverment employee dont give them coke or beer they no u r a kiss ass for safety u need to wear a life jacket

Crazy to think just this morning i was listening to KQRS and you were talking about boating and this video showed up in my suggested videos have a great day Doug be safe and i love the radio adds.

Good video, i ordered the same radio and did the install. I've got audio but I've got a nasty loud click when turning the volume to zero or switching sources. Any idea what that's about?

"A Stupid Boston Whaler" Show me this stupid Boston whaler!

Excellent

You sound like a car salesman….thanks Doug.

Did you mention that the lock Master likes to run as many small craft up or down as possible at once? It takes a LOT of water to fill the chamber for the next downbound lockage, even for a 600' x 110' chamber.