Thank you very much🙏🏽Your lesson helped me a lot

Thank u so much sir

Master analogue control. Three vfd control. Mukhtalif speed. One analogue set.

Please i have a problem, the simulator run bar does not blink it is just staying at one position. what could be the cause

Why did you use K7?? For Ch0 and Ch1 you Take From instruction K5 and K6, they have logic but you didn’t take Ch2 why you use K7 by skipping TO instruction for CH2

this is okay or no

How to convert ascii value into integer or real number

❤❤❤❤❤❤❤

What is the Maine usage of negative (N) and positive (P) command ....that you were show us in lecture no 4....plz I didn't get that Thank you 😊

sir in simulation of analog input programming, why does output gives 100 ( max) when slide was in middle position ?

Hi, y need to communicate a Mitsubishi PLC with remote analog module Delta DVP06xas. i'd like to connecto using RS command. Did you do something like this?

brother thank you so much we get so much knowlegde about s7300 plc

THANK YOU VERY INFORMATIVE

Pls how to do adjust offset and gain in output modules

very good video and well explicit, thank you for sharing

Thanks Sir!

Good job subscribed

there is alot of things which is not understandable like how and why we are selecting values of sub add multi,divi like d10 d12 d15 what is that

Hi. I have a question sir?

What is the full form of Simatic ET200, ET300

What is the full form of Siemens S7

Good

Thank you for your video. Very well presented. I appreciate the use of the data sheet to reinforce your points.

any possible way to force M1 or M11 (general memory) ?

How do you put an internal relay in simatic? Like Tia portal and any other plc.

whats the CPU number stands for ?

can you give the wirimg plc diagram y0 is pp y1 is np and how about the opc and

Traduction Arabic

You are great thank you so much

Good explanation. Using the data sheet helps figure out what you are presenting.

Sir, could you make one video about delta plc pid control in wpl pls

what if i need data with value more than 33000, how to use Data Register "D" with 32 bit ?

Thank you so much sir!!❤

Why I cannot find "E" device in my GX Works 3? Do I need to change the settings?

Very helpful

kzbin.info/www/bejne/l6HEp3afmMefjbM

Nice explained sir

God bless you sir 🙏🏻

Floting hota kya h

Sir robot aur cc link. Ka bnao

Hello : S7-1200 CPU 1211: 2 modules S7-1200 CPU 1212: 4 modules S7-1200 CPU 1214: 6 modules S7-1200 CPU 1215: 8 modules what do you mean here @5:02 by 11 module ?

Assalamualaikum, good afternoon bro... from several videos on KZbin, including on this channel, there are no videos that make a Fatek PLC to VFD tutorial and how to program it... Please enlighten me, thank you

Best

Clear explain thank you 🙏 your valuable teaching

Copilot referred your video🙂

Do i need to download hardware if i change curent output to voltage output after saving the changes?

Dc inverters compressor driver chala sakte he is per?

Sir 🎉

Sir servo Drive Deltha me plc servo me kya kya parameters used kare

Plz make video on job’s regarding plc and automation field