Спасибо за видео.

Slide the drivers seat back first maybe?

thanks for the helpful video, I removed the 2 screws that hold the console to the 10 socket with extension, lifted the rear of the console as far as I could and tightened the cable with a 12 spanner, quick and OK

Three clicks? That was far more. Seven is the average requirement for MOT. Realistically you should check the brake pads and brake disks, the pistons must be working correctly too. The handbrake uses the Calipers pads and disks. The rear wheels should be raised to ensure the wheel rotates freely after adjusting.

Cheers chap, exactly as described. . Thankyou 👍

Any clue where is the location of parking brake switch? My i10 parking brake indicator was always ON after the brake released

The reason why that seesaw bracket is sitting to one side is because the right hand side cable is stretched. The left side caliper will lock more than the right side. New handbrake cable will bring that back to normal and sit even

if you both weren't sitting on the seats,the console lifts up past the seats easier,you sitting on the seats flatens down and pushes the seat edges towards each other,narrowing the gap the console has to get out,good video though mate,thanks for the warning about air bag control panel

Thank you so much! You are the only on KZbin who shows how to get to the airbag control unit of an i10. That what I was looking for!

Is this the same for a 1998 hyundai accent L hatchback with rear drum brakes? I can't find a video for my car

BRILLIANT MATE THANKS 😊 👍🏻

No need to remove the console completely. Access to nut can be gained by lifting console up a couple of inches. Thanks for the vid.

Why your console doesnt have 12 volts socket?

i took the cover off and i cant put it back, thanks for the vid :)

Good

Very helpful Thanks 👍