I can print them in 60-90 minutes. I am using non-dental SLA printers which are perfect and much more affordable.

Hi usually the accuracy would have been previously callibrated with a callibration cube that measures XYZ axis. If found incorrect, it can be added or subtracted in the Gcode. Also, you can adjust it in the model scale, like 100.5% or 99.5%. If properly calibrated, (most modern printers are), then it will print correctly. If by chance we use third party resin or materials, there may be slight difference, but again we can adjust this in the settings. If material and printer is not changed, the corrected settings can be used for all the next prints.

I agree! We too had a lot of problems with the Form2. For us, it was the bed levelling and lifting mechanism which had alignment problems. Also, very expensive resin tanks to buy. We have sinced shifted to FDM with the Prusa i3 Mk3 and have had good results. Print with 50 microns and 0.3mm nozzle (tooth prep, inlays, onlays etc) for precision and 100 microns with 0.4mm nozzle for larger work like full models. Really good and consistent results even with cheap Chinese ABS filaments.

PS the curing tank also broke down after 2 months and we are using UV sterilization equipment to cure our models. Real hassle and couldnt train technicians to use the curer and printer.

In our lab we use the 3Shape system but we can work with many different companies and software!

Hi there, these are from a selection of our daily work in our lab, they might not follow the exact same case from start to finish!

Hi there! The partial denture framework is made of our material PEEK. PEEK is digitally manufactured and is a medical grade polymer that provides patients with an alternative solution to chrome cobalt dentures. You can find out more here: www.dts-international.com/our-products/prosthetics/peek

Thanks a lot :))

The PEEK framework was milled or 3D printed ?

This PEEK framework was milled!