Ford kuga changed 3 times since 2013 to 2020 this isnt bad info but the bumper changed 3 times so different processes
@theincredibleboggy19 сағат бұрын
There are TWO plastic wingnut fixings on a ford focus estate 2015. It could be a very expensive disaster if you only remove one of them and try to prize it off.
@shabazz18Күн бұрын
DO NOT tighten anything to 57-75lbs. WTF guys? Just throw in a random stock absorber torque spec?
@supabenbenКүн бұрын
Not for 2011 V6 3.0l. I guess this is for 4 cylinder.
@IGRAFF09Күн бұрын
How you turned that bolt 180° I have no idea. I barely managed to get it 90°
@timstoth4271Күн бұрын
What is the right size for the sump plug removal
@yassinedria6530Күн бұрын
So no burping necessary ? The tank can be closed without allowing trapped air to escape ?
@hossamtaha9588Күн бұрын
The bleeding coolant must be done from down or its ok from the bleeder screw which is up because in my ford its only one screw from up left side.
@donleebarnett2 күн бұрын
Just a question, instead of putting the truck on a lift dropping the tank a bit draining the fuel then putting the tank on the ground to change out the fuel pump why didn't you just pull off the bed or at least pull back the bed where you would have easy access to the top of the fuel tank? Is there a reason to not do it that way? I have plans to do that in the next few days, and a reply would be appreciated. Thank you. I bought my first Haynes manual when I was 16 and that was 40 years ago. I have a manual for every car that I've ever bought.
@letsgoviral7772 күн бұрын
Thank you!!!!!!!
@skeate9992 күн бұрын
this is P21W and W5W ?
@user-sq9td8nu9i2 күн бұрын
SURELY YOU CHECK FOR A SPARK ON THE PLUG/S BEFORE BUYING A GAS CAN AND DOING A FUEL TEST - SPARK ON PLUGS IS THE SIMPLEST TEST
@user-kt6ne3fx6u2 күн бұрын
Can you make a guide on the older models of cavalier?
@Doppo692 күн бұрын
Just did this on a f56 2017 RHD, mine was by the clutch foot rest, I didn’t remove the foot rest it was easier as the door didn’t come fully off then you can pull the door and up gently so it rests on the foot rest abit, it’s abit of a dumb design as don’t know if the bottom filter is properly set before putting top filter in! I pulled off the left hand side and the panel under the glove box and wondered where the hell it was 😅 Then looked at the right hand side you can see the filter door peaking at you over the panel! You need a T20 torx Good luck it’s not that bad took 10 minutes once I finally found it
@k12rising2 күн бұрын
wHERE ARE THE SPRINGS?
@motologist19173 күн бұрын
what is the battery capacity
@kevinb98753 күн бұрын
No help really looking for 2020 nissan versa not 2019 or below
@brianredmond49193 күн бұрын
Definitely one that was prepared earlier.
@BRZY-il9tx3 күн бұрын
Crazy how the truck was lifted with a jack and jack stands then all of a sudden it's on a lift
@YouTubeIsRunByMarxists3 күн бұрын
I have a Honda Civic Si, 2012, and the rear brakes are NOTHING like this.
@volt86843 күн бұрын
Awful design for a consumable item
@moonlee98983 күн бұрын
nice, looks simple, few springs.
@KnightOfNight34053 күн бұрын
Is seat leon 2015 same way?
@ramseyebryant3 күн бұрын
This video was pointless
@brisvegas8594 күн бұрын
I have done this multiply times, its a pain but what else to do, pay someone....
@johnmitchell92704 күн бұрын
Hey anyone has an idea why after changing coils/spark plugs engine somewhat starts have to keep pushing gas pedle to try keeping it going she poops(quits)?Shes getting gas tou smell it!Im confused 😮(2010 Sentra posible 2.0 or 5 whatever.
@FRJON924 күн бұрын
Just did it on my 2016 and it was painful but this guide helped! It was not as easy as the guide make it look though 😅
@r.m.8094 күн бұрын
Worst video ever! No mention of the insane amount of clips and bolts you have to remove just to access the bulb housing. Smh.
@mrdufenshmirtz11395 күн бұрын
well explained
@DoopyBooper5 күн бұрын
the Oxygen Sensors I bought to replace my old ones don't look like yours, I bought 2 Bosch 15659 Oxygen Sensors for the upstream and 2 Bosch 15658 Oxygen sensors for the Downstream? but neither look like the oxygen sensor you installed in the video? did i get the wrong Oxygen sensors or is it just the way Bosch makes theirs and it'll work fine?
@vlarep25 күн бұрын
07 to 12. Not to 19.
@prosptsfitness5 күн бұрын
Hi do you have courses for petrol engine please let me know , as I have petrol car and I want to do the head gasket job,
@wkhoe5 күн бұрын
no need to bleed the system?
@martinsitumorang78895 күн бұрын
Posisi oli power steering dimana?
@YTChiefCritic5 күн бұрын
Many people want to change the fuel filter because the car WON'T START yet these idiots are telling you to start the car to relieve the pressure in the fuel line. Useless rubbish.
@markevans22805 күн бұрын
When they bringing out a Haynes manual for a Tesla lol, will take 10 years to figure out how to do a repair, will just say “take to dealer” on every problem 😂
@yong-chunwang34965 күн бұрын
Thank you for sharing this videos, basic, clear and useful
@stefannagy93456 күн бұрын
thanks man.very usefull video.
@amazonbmw6 күн бұрын
big thanks
@theautomaticfiend6 күн бұрын
Wow. That's some incompetence.
@dropship1236 күн бұрын
Looks way too easy, he didn't even have to take the wheels and sub frame off
@seanfordham6 күн бұрын
Who would thumbs up this video.... Rename this
@bdanca436 күн бұрын
This is the best video I have seen on replacing the alternator. Great job
@kmcdowell66226 күн бұрын
Good showing. But why in the world would you install a used plug?
@opraiderman9046 күн бұрын
If only my connector came free so easily!
@jjpopnfresh68226 күн бұрын
'The fluid in the reservoir will raz'
@agent7pl.6 күн бұрын
I did it without removing the wheel arch from the engine cover and dismantling the air conditioning compressor. Everything from the top.
@johnrusselsmurf48427 күн бұрын
Highly recommend spill free funnels with radiator adapters. Cheers. PS. Bought a 05 Frontier from my late uncle. He love Haynes Manuals. The truck has its own in the back door pocket.
@richcan227 күн бұрын
Three wire connector is a pain still working on it