Hello @ehsanazadi-gw7qo! Thank you for reaching out with your comment. We appreciate your interest. For more detailed assistance, please don't hesitate to drop us an email at [email protected]. Our team will be more than happy to provide you with the information you need.

Heat trace I believe

She said 20mega Ohm's not 20 ohm's. 20 ohm's is basically a dead short.

@@joshuaboehler20 mohms, 20 ohms it doesn’t matter my guy. Read what I said.

Depends on the voltage used for testing. They most likely tested upwards of 5kv whilst this test was under 500v. You're clearly not an electrician and dont know what you're talking about.

@@champ8605 Most likely tested upwards of 5kv? 🤣. You’re sooo clueless bro..

You were also told, face mask and vaccines would help stop/spread covid from “qualified” people… moral of the story, not every “professional” gives the right info

Hi Marco! Thanks for your comment. Email us at [email protected] and we will be happy to assist you!

To find out whether wires have the expected resistance value. Insufficient resistance means the wire insulation is bad and needs to be ditched as there risk of a ground fault or short circuit which can start a fire.

Let me guess... you're asking for a friend?

no

no :(

pretty self explanatory

if you don’t know according to the IEC / ASNZS3000 it must be tested at twice rated voltage

True… so far all the cables we’ve megg have tested at 660 M ohms in all our cables we have tested / installed here at my plant, which is what it shows on the megger she’s using in the demonstration, but like they said 20 M is a pass.

Hi! Thank you for watching the video. Most Meg sheets list L1-G, L2-G, but if they pass together they’ll pass separately.

​@@BARTECglobalwhat is her IG?

Hi @ryanrahmat5980! If the cable does not have a ground braid, then one of the cable conductors might be the grounding conductor. For example, a three-wire cords contain two current-carrying (Hot & Neutral) conductors and a grounding conductor. Check the cable type and please note, for single conductor non-shielded cables, insulation resistance testing cannot be performed because low voltage single conductors do not have a grounding conductor, shield or ground plane. Hope this helps and thank you for watching!

Hi @impala1977. We are glad you found it useful. Thanks for watching!

Hi @arisan4567 You are right! We are taking notes for future videos. Thank you for watching and for sharing your feedback.

👍🏽

Hi! Thank you for watching. Please use the following link to download our design guide: www.bartec.de/en/downloads/heating-technology/engineering-tools/design_guide_iecex_final.pdf In page 36 you will find the "Tests and Commissioning" section. We hope this helps!

Glad you enjoyed it, Marcos!