Can only cringe at thinking about how much the repair parts now cost 5 years later in biden's marxist economic plan
@gaminawulfsdottir325311 ай бұрын
Step One: Have your cameraperson turn the phone sideways.
@philliphall5198 Жыл бұрын
Some old ford trucks 800 series used this same pump. I save 3 for my old ford tractors
@mikeprice1816 Жыл бұрын
Same on ford 2000
@mikepursell2883 Жыл бұрын
I feel like I've been to Ford Tractor school and had the in depth course on power steering ! Wonderfully done !
@DanHarrip Жыл бұрын
Awesome video Dan thanks heaps exactly the video I’ve been looking for 👌
@j.b.1855 Жыл бұрын
Tip: Before removing the reservoir cover take a marker and draw a small line across the pump onto the cover. This will give you a point of reference when installing the cover to line it back up exactly where it was.
@mikeprice1816 Жыл бұрын
Everything but what kind of fluid do you use
@waynepitts21542 жыл бұрын
Talk talk.
@justinclinard20003 жыл бұрын
Did you use ATF for power steering fluid
@joshlismore3 жыл бұрын
is this how they leak back into the block or is the leak to the block caused by a o ring fail on the drive assembly of the pump?
@j.b.1855 Жыл бұрын
You would have to pull the pump from the engine, and replace the seal behind the gear that drives the pump.
@jessemixon57643 жыл бұрын
Nice job sir, of carefully explaining how to assemble the parts so as to avoid damaging the parts and fittings
@gregwiese26423 жыл бұрын
wearing rubber gloves .......... thinking HARD .... ? something is MISSING ... I don't get it !!!!!!!!!!!
@cloudyeight4 жыл бұрын
Thank you for the video! This helps a lot.
@joshnaranjo46914 жыл бұрын
Good video. Thanks. I've changed the other hydraulic filter at bell housing. haven't done that one because I didn't know a filter existed there.lol
@michaellohre14704 жыл бұрын
I really appreciate the detail and care that you put into the work and the video. May God bless and keep you in all your work and service, Dan. You really have a nice looking Ford there and well cared for. It makes me want to do better on my 63 Ford 4000.
@danelliott20395 жыл бұрын
The wire that connects to the oil pressure sending unit should just snap on unless the connector is damaged.
@Theearswe5 жыл бұрын
How did you get the cable for the oilpressure to stay put? I Dont get it?