Пікірлер
@timmaguiar7081
@timmaguiar7081 Ай бұрын
Do you have the part number for the seal
@robclinton9249
@robclinton9249 2 ай бұрын
An axle nut (wheel bearing) dust cap from a 2009 VW GTI Golf fits in the old seal perfectly for cleaning the grunge without getting it inside the unit.
@thatonecommie8351
@thatonecommie8351 4 ай бұрын
Just a safety thing, you should probably stand further back. Just in case.
@Cjdoc23
@Cjdoc23 4 ай бұрын
That is as long as Estes makes there launch controller.
@bonkusbot
@bonkusbot 4 ай бұрын
Good launch!
@rsonweb2060
@rsonweb2060 4 ай бұрын
My dealer charged me close to $1,000 to replace mine. Then they didn't top off the fluid.
@tractortherapy42
@tractortherapy42 5 ай бұрын
All JD bolts/nuts are metric for the last 30+ years
@grassrat4506
@grassrat4506 6 ай бұрын
Thanks for the video. I have to replace the one in the next couple weeks.
@coreyhuckins4381
@coreyhuckins4381 7 ай бұрын
Hi Chris, just wanted to say thank you for the video. I had a leaking seal in my 1023 and used your video as a "how to". It was very helpful for buying the tools and parts I needed before I started. Your video is how things usually go for me too! I was dreading removing my seal, but mine was so bad it came out in pieces. Anyway, I expected a 2 day repair but because of all the awareness you cautioned I was prepared and the entire job only took me 3 hours. Thanks again!!
@EricPeterson-w2r
@EricPeterson-w2r 7 ай бұрын
Why can’t I get your video?
@vernnelson3212
@vernnelson3212 7 ай бұрын
That's what Mechanics Do! Leave it to them.
@chrisowen9378
@chrisowen9378 8 ай бұрын
Give yourself an attaboy on that project !!! I do believe there is a vent kit option for that unit. One word of advice always replace with the factory gasket instead of silicon. Gaskets often serve two purposes. One sealing and the other proper spacing ( shiming of internal components ) don't go cheap next time !!!
@terryschlager2347
@terryschlager2347 8 ай бұрын
So do you use any type of sealer on the gasket?
@bluewall9410
@bluewall9410 9 ай бұрын
You should have taken your wifes advice my friend..😂😂
@catfish500mark9
@catfish500mark9 9 ай бұрын
I had to laugh at the hydro fluid spill.Man,we've all been there and done those sort of things.I always tell people,,,,,,knowledge & experience is cheap nor is it free.Im getting alot of almost powder like metal in my oil when I do my maintenance so I wanted to see what the inside of the hub looked like.Good video and all the best.👍👍👍👍👍
@jerrypatterson19551
@jerrypatterson19551 10 ай бұрын
Put a axle vent on it. That's probably what caused the leak. Pressure build up.