Thank you, you just saved me lots of time and grief, great video.
@dovidas8028 күн бұрын
New 5403 all you do is lift up the and twist the clear cap.
@lonshelton221 күн бұрын
Hey, thanks for this information. I was able to safe my self a coupling and use a piece of 1"1/2 plastic extension tube. Perfect fit i cut it the length of the coupling, and the water supply would clamp down on it to keep it in place FYI 👌🏽
@NeilIves25 күн бұрын
Thank you for this video. Although I have inbuilt Satnav in my car I use my old Nuvi on my motorcycle. The battery is obviously bad. I was not able to figure out how to get the case apart. Thanks again!
@sylvesterromero471027 күн бұрын
Thanks so much 🙏🏼
@AndTodaysProjectIs28 күн бұрын
great hack! thanks!
@carlschnurr8483Ай бұрын
I had difficulty finding a PVC adapter that would fit over the flush valve post. The 1" PVC adapter shown in this video would not fit over my post.. The video showing the PVC coupling installed, doesn't seem to fit as well I'd I would like. When looking down the inside of the PVC coupling hole, I'd expect to see the grey pipe engaged into the bottom half, but I can't. The post post measured 1.33", but the specified OD of 1" Schedule 40 PVC is specified to be 1.315". You may get lucky with the tolerances and it might fit, mine did not. 1.25" CTS pipe has a specified OD of 1.375". Fernco coupler P/N 1056-100 is a rubber, flexible coupling with metal hose clamps. It fits 1.25" CTS pipe, and Qty 2 were available at the closest hardware store for my 2 toilets. I found this fit nicely without the hose clamps (If I get seeping through the seam, I can always put one on) I adjusted the float to put the water level as high as possible, and slid the coupling until the water line was just below the top of the coupling. Also make sure the waterline is well below the top of the styrofaom tank insulation. The original height of the waterline from the seal was 3.75", and used 4.8 litres per flush of water. The coupler increased water height by 20% to 4.5". So I expect my toilet is using 5.8lpf. This is still significantly lower than the 7or 8 lpf of a standard toilet. In fact, the flush is so strong I'll likely reduce lower the float slightly.
@earthmombooksАй бұрын
Thank You!
@brianmcvicker829Ай бұрын
You are my fricken Hero!!
@bert1913Ай бұрын
I will never buy another American Standard toilet again
@jakjensen710Ай бұрын
just bought a 40k fifth wheel and have lived in it for 3 months now it needs a thermostat a leveling computer and the fridge wasn't getting cold. for 3 months I've been using a bulky mini fridge and you just saved me from a 1600$ quote from the RV repairman🙏🙏🙏🙏
@dotarsojat7725Ай бұрын
LOW FLOW toilets are just that.
@IceBreaker1127Ай бұрын
Do yourself a favor and replace the AS flush valve with something like the Fluidmaster 3" Flush Valve w Flapper. Less than $20 and solves the weak flush issue among others. The toilet works well without the terribly designed AS parts.
@TheISNetworldConsultantАй бұрын
Thanks sooo much for making this video. It was driving me crazy on how to adjust this flapper. Once you showed me the trick, I had my toilet working in less than 2 minutes. I used setting 10 and that is perfect. Thanks again.
@kimberlybowen8930Ай бұрын
Anyone know how to pull pdf. It’s not working
@rockyhayles7693Ай бұрын
Thank you so much for being so detailed. You are awesome. So helpful. I appreciate you.
@macicamerlo19552 ай бұрын
Thanks from Italy
@jaimetriana3382 ай бұрын
hello, I have a problem that for sure you can give me tips. My Norcold does not work with gas when I am traveling even that it looks like is working. With electricity is working perfect.
@frankwalker75843 ай бұрын
Thank You!!! Problem solved
@LeeB-t9f3 ай бұрын
Thank you ! Thank you! Thank you!
@ZooK_Studios3 ай бұрын
All wrong. All you need to do is pull the clear plastic back away from the detent and rotate it to the correct t dial setting. Simple.
@davids20093 ай бұрын
when i checked the temp, 64 came up vs. your 26. i ordered a new thirmister hopefully thats the trick. thank you for this video.
@randymccomb31583 ай бұрын
I did the same. The Thermistor's threshold is set too high. had to bypass the thermistor for the my fridge to work, now it gets too cold
@payne515583 ай бұрын
Thank you!!! Set to ZERO (0) from the factory?! WTH. Thought my toilet needed to be replaced ;)
@not4weak3 ай бұрын
Fine the junk company!
@RogelioLuna-rv9vl3 ай бұрын
In my donde go to 25 😢 my go to 50
@PureToneMusic4 ай бұрын
I used half of what you said and the other half was me breaking off the little red plastic notches from turning it so hard and being frustrated as hell lol. Thanks for the info!
@nash27964 ай бұрын
this AS model is a pc of shiiiiiiiit, got this problem since the first day I got it
@MapleTaylor4 ай бұрын
Has anyone got the ER code in part 6 of diagnostics? I’ve checked all the screens and there are not other codes or faults . This worked a few times but now it won’t
@MapleTaylor4 ай бұрын
Has anyone got the ER code in part 6 of diagnostics? I’ve checked all the screens and there are not other codes or faults
@PayChekk9034 ай бұрын
Actual help thank youuu
@reynaldolopez12484 ай бұрын
Thanks so much
@Brett-nc7hi4 ай бұрын
Bullshit
@TRKVSports5 ай бұрын
Theres the problem a broken blue wire...thank you
@GoingSane5 ай бұрын
This video got my house sold
@LiquidNS5 ай бұрын
I was fiddling around with this for a while. Finally had to look it up! Thanks for showing us!
@MelodyMoon369-5 ай бұрын
Actually it’s meant to just turn like dial . I know cause i did it with ease.
@davidwhite31005 ай бұрын
I agree that there is nothing wrong with the toilet. It is mind boggling to me that there is this much controversy over this. Just hold the handle a second longer and there is no problem. Mine works great.
@George-dm4uf5 ай бұрын
The blue gaskets on these Champion 4 toilets never fail to fail. They develop little blisters which allows water to drain out of the tank. In the last nine years I have had to replace them more than a dozen times. I have run out of patience and will replace with a Nuflush valve the next time it happens.
@volcom21d6 ай бұрын
Mid 2024 and still taking people to school. Thank you
@walterzurek77636 ай бұрын
Thank you, thank you, thank you!!My parents put up with this problem for a couple years. This quick fix did the trick, and they are so Happy with the results. This fix also saves gallons by only flushing once!
@MortySalch6 ай бұрын
This worked for my fridge as well. Thanks for posting
@DavidJohnson-rl8hc6 ай бұрын
I have an older off brand 3/4 (water saver) flush toilet, never done any repairs 15 years, the American Standard is a piece of expensive junk we have had to replace the flush valve/washer twice in the last two years and leaks constantly! I always have to flush it at least twice when there is Biden in it, so am I "saving water", I don't think so. But on a positive side this seems to do the trick, but this is last high dollar toilet I ever buy!
@darrenpaches37316 ай бұрын
Hi, thanks from Edmonton Alberta
@netw0rks506 ай бұрын
I found that my issue was similar, but the main wiring harness had come loose. Thanks for this video!
@connielee75596 ай бұрын
Thank you do much! It worked with my frige
@dalemihocik47326 ай бұрын
There isn't a problem with the Champion toilet, it's the people flushing them. All that's needed is a split second of patience. When you flush hold the lever down for a split second before releasing hand pressure. In the video he lets go too fast before the water can leave the tank. These toilets cut my water bill by 40%, this "fix" will not help you.
@walterzurek77636 ай бұрын
Do not agree. My parents put up with this problem for a couple years. This quick fix did the trick, and they are so Happy with the results. This fix also saves gallons by only flushing once!
@Darlajw6 ай бұрын
Trying to figure out the need to have 4" of water always on the bottom of the tank?
@dalemihocik47326 ай бұрын
@@Darlajw Call American Standard and ask, I'm sure you'll get an explanation that will leave you scratching your head or make perfect sense.
@andyignacio678510 күн бұрын
@@DarlajwI’m with you. I just installed this last weekend. I’m dumbfounded with the water at the bottom of the tank. The only reason I can think of is maybe the velocity of the flushing water is faster because it’s 4” higher. It’s so odd.
@davidfalcone45686 ай бұрын
Thank you sir. You saved me from dropping 4 letter words.
@JennerJ21037 ай бұрын
This worked for me! I turned a/c and breaker off, reached up from inside and wiggled all the cords. Turned it back on and could hear it kick on. So happy!! Thank you!
@schweik19187 ай бұрын
Great idea, thanks a bunch. It's a simple but brilliant solution!
@leticiatorres44227 ай бұрын
Thank you so much for your video. It was working great then had to shut off all electricity and it would only cool in the freezer. I just found your video. Praying it works.