number of the ball give the cut shot : 8 is 8 /16 , 6 is 6/16 ; white object ball is full (zero), you can read it also with chalk mark on the side when moving, object ball when object ball is on the spot (middle of line of diamonds 2 ), each diamond cost 2/16

your cue stick is in the line of contact points

@@zzgt09billard Cool... thanks from NZ 👍🇳🇿

you aim with your feet, and you are on they are on a // with the pocket that is what i show with the cue stick, contacts points on OB et QB are on 2 // line, lime of aim pass half ball in front contact point of Object ball(OB)

you put your cue stick in the line of contacts, not center ball. this is your new zero...

if you have a 8/16 cut shot (26°), 8 is the number you have to get with sum of each fraction of QB and OB, 8=0+8 or 4+ 4 ou 3+ 5 etc

zzgt09 thank you so very much, I will check this out, I have my own table, it’s a ten foot regulation snooker 🎱 table , and has very small pockets. It was purchased from a pool room, the pockets were made smaller, to make the table harder to play on, sort of like the twelve foot tables. We play snooker 8 , 9, 10 ball🎱 We use regulation snooker balls, for snooker,. We use the larger regulation pool 🎱 balls for the other games. Now with the smaller pockets , this makes the pool 🎱 games much harder to play. However, this makes those games more difficult , but more enjoyable. When I play in a pool room, now the pockets look like barn doors. 😃🎱🎱🎱 thanks

you have to line your stick from th the part of the pocket you want to enter and the object ball, this give you the contact point on OB to touch, far edge from the pocket. Then draw a line // to the first line and going throug the center of the Q ball, only one is possible , il gives you his contact point to touch, close edge from the pocket. you have to aim so this 2 point collide. you can use you right foot looking to the back of the pocket (or a line // to ) and then fall down your left foot to be in the good line of aiming (not line of contact). remind you have to aim the double you want to touch because of sphericity of the balls. in fact it is a felling of //

Benjamin Kelwon try it for blind cut shot when the Qball is on the internal side of the object ball

@@zzgt09billard I think to fully win a game you need to have to master several techniques and pool basics and this is one of them...either CTE or ghost ball technique or Division of the object ball into fraction. I mean at least knowing them is also important

​@@benjaminkelwon8939 hello, i agree with you and i would say that because of your eyes, your stance and your stroke a (cut) shot on the right side or the the left side of the table is not exactly the same.

@@zzgt09billardhello. That is true and by the way it also takes perception. I mean how you perceive until you land on the shot line.

sure, but for certain shot this can correct undercut due tu cut induced throw

look the diagram , you want to adrees OB in the upper right pocket the number on the table give you the n* 1/16 value for a perpendicular line between OB et QB the string give you the value for a oblic shot 1/16 is nearly full, 8/16 is half ball, 16 is finesse on my other videos this is described

l 'idée est d'arriver directement dans la ligne de visée avec ici le pied gauche qui reste parallèle au pied droit ce dernier visant le fond de la poche, ou plutôt le coin métallique du billard selon les angles le repère visé par le pied droit peut être différent

@@zzgt09billard Merci. Donc une astuce de placement des pieds pour jouer facilement la parallèle type Mosconi, c'est çà ?

oui , Mosconi a d'ailleurs écrit un petit livre sur le pocket billard ou il décrit sa façon de voir. cela vient de loin avant lui

yes, you aim with your feet

points of contact are on // lines, if you have one line you get the other line

yes, and you can aim in the line of the cut , not only center ball

Jack Ridge yes ,contact points on edge of the balls

@@zzgt09billard Balls only make contacts on opposite sides/parts. The edge of cue ball cannot make contact with the contact point on the object ball unless it is exactly the opposite side/part of the cueball. The edge of the cueball can only make contact with the EDGe of the object ball. That's their geometry. Unless one ball is bigger . 1/4 of the cue ball can only make contact with the opposite 1/4 of the object ball. 1/8 to 1/8 and so on.

yes, when balls touch them you have the same fraction of ball on contact on Q ball and on object ball 1/4 of Q ball can only cut 1/4 of object ball, 1/8 with 1/8 , 1/2 with 1/2 etc.. when you aim you make this equal fraction corresponding by visualising "le bord externe" (the edge) of this fraction of balls you aim for that . either with the tip in the center of the Q ball or either as i show if the cut is not too thin with the tip alligned with the line connecting this contact points "sur le bord"( on the edge) of the Q ball. you use the "circonference "of the Q ball , and "la corde des arcs de cercles égaux sur OB et QB"

contact point on the back of Object ball is on a line opposite to the place you want to go in the pocket, this give you a line A the contact point on the front of Q ball, and the center of Q ball give you a second line B A and B are // so you can see contact point on Q ball you have just to connect this points to make the shot

you choose a line you know close from your position , you see the parrallel were ou are, you aim in the middle of this difference beyween this 2lines on the rail center ball , soft, no side or very few of outside english ( if the table is "short") for example your position is about 3,4 diamond you know the 3- 1,5 line the middle betwin the 2 lines will bring you on 1,7 without any calcul or knowing this nomber. easy speed, rolling ball. 3 lines to begin: 2-1, 3-1.5, 4_2 etc ..

la règle représente le triangle rectangle dont l’hypoténuse est la ligne joignant les 2 billes, l'angle de visée est la valeur en degré de arc-tangente ou ATN sur la calculette du rapport coté opposé/ coté adjacent

pour calculer un angle sans rapporteur il faut sa tangente , d' ou le triangle et quelques proportions faciles a retenir, si l'on prends un pont de contact sur la bille visée ne pas oublier que le point de visée est le double

on peut aussi prendre un point sur le tapis correspondant au centre de la bille fantôme ,mais de loin ou pour certains angles il y a des problèmes de perspective.

In fact you use the overlap of QB with OB, the adventage of this is that if you use side you aim the same considering QB go straight wathever the place you hit QB. you dont aim with your tip(procédé) This is correct for short medium distance with a very fluid stoke and the cue parrallel to the table. if you shoot hard you have opposite deflection of QB, if you raise the but of the cue you you have a curve of QB on the side of the impact witch is the opposite of the deflection.

the avantage of sighting the overlap between Q ball and object ball is when you use side . because in this case you dont care of the difference between the center of the balls and the position of our tip on the Q ball. you have just to allow a small amont for (opposite) deflection caused by side spin.

je pense qu'il faut pivoter selon le coté ou on veut aller, on garde ainsi un supcon d'effet vers le cote souhaité

on peut aussi dire que l on pivote toujours vers l exterieur

pour une coupe mince ont peut s'aider d effet interiur qui va deporter plus fin la blanche

sur chaque horizontale la quantité (pour empocher)à une une mouche de la poche est fixe , la 2 eme mouche sur la même horizontale rajoute 4 et 2 ensuite pour les 2 mouches suivantes. par exemple toute bille située sur la première horizontale et dont la ligne de contact passe a une mouche de la poche nécessite un cut shot de 12/16 (bille 12) c'est a dire un quart de bille, quantité 12. le programme fait un calcul décimal d'après les coordonnées avec une pondération selon la position sur l'horizontale (plus loin= plus gros)

je commence le billard et ne connais pas les termes techniques. Je ne comprends pas. Merci bien salutations

en fait cela correspond apprendre 16 quantités de billes différentes du plein à la finesse chacune espacée d'un 16e de bille. Pour apprendre ces quantités utiliser les coordonnées sur la table comme expliqué dans mes premières vidéos. Sur une même horizontale la quantité à prendre pour empocher une bille située à une mouche de distance latérale de la poche varie peu surtout si on est loin de la poche

c'est vraiment pas clair. Je ne comprends toujours pas mais suis sur que c'est un excellent système. Envoyez moi un schema sur l'adresse e mail : [email protected] . merci

regardez ma video shema 8

on each diagonal for a perpendicular attack the cut shot is the same fraction of object ball. on each horizontal line each diamond from the upper right pocket (here)has a different value(12=12*/16 from center of Q ball= 12/16=3/4 from the center soit 1/4 hit on object ball) the numbers tells ou for how many 1/16 off the center of object ball. for example the main diagonal from the upper right pocket to the low lef pocket is for a half ball hit (8/16=1/2) for a 26 degrées shot. you trace a line across object ball and Q ball and you look how many diamonds from the upper rignt corner (in this case). On the half superior part of the billard you can see that if the first diamond cost X *1/16 the second diamond cost X+(4*1/16) and the third one cost 2*1/16 more and again 2*1/16 more for the forth and last diamond

cela dépends du type de queue de billard, ici une prédator , environ 12-13 cm pour le pivot point, voir la video , , pour une flèche très rigide , type bois plein, le chevalet devrait être plus court, il faut tester.. le "pivot point" est indiqué par le constructeur pour chaque type de predator

ici on part d'une position du procédé qui serait un 3/4 de bille sur la blanche , soit centré sur la moitié du rayon, ce qui fait un bon procédé d'effet (comme cela on ne tient pas compte de la taille du procédé et des définitions variables..)

on the same line the cut is the same

16 fractions of cut on object ball to learn each one can be retrieve on the table with a simple trigonometry calcul for example half ball is a1/2 ratio on the table.. this for geometry after reed what Joe Green said..