I need the covert how l get this the number item 98194
@seann802719 күн бұрын
I'm 6 years behind but super thanks for this how-to video, Chris. Thumbs up!
@CathyMcPeak20 күн бұрын
My Hampton light only stays on for about 5 seconds when motion detected. I have tried all settings and nothing longer than 10 seconds.
@abelgonzaslez210324 күн бұрын
GREAT THANKS
@Carlos-od6tjАй бұрын
Great video. Very informative. Appreciate this.
@10drowsyАй бұрын
I installed Timbren SES units in the 2021 GMC 1500 as well. Needed them for towing my loaded up 6x10 enclosed trailer (that does NOT have a Weight Distribution hitch). For the Timbrens, I installed with 1" gap and they work great. Riders cannot feel ride difference when NOT towing and the truck sits near level when towing. I recommend for folks who "load up" their pickup box and who also tow loaded up trailers. Many times, I feel the Timbrens should be factory build inclusions...
@TheMotorman116Ай бұрын
Fucking GM…
@evidencebased12 ай бұрын
I keep a heavy wool blanket in my Odyssey trunk. The problem with the Honda folding mat is that it doesn’t accommodate the split 40-60 aspect of the seats as sometimes I just want to have one side down (eg. When you need to have item not roll around). If they could split the cover and fasten the sections to the seat back it would be more useful. My blanket also rolls up and fits into one of the side cubbies when not in use. If you need water proof, I suppose you could get a tarp.
@destinyobenshain53533 ай бұрын
Thanks man, for your time 😊
@thomasmcclenan17764 ай бұрын
Thanks and I love the Redwood look
@NVVD11174 ай бұрын
This fan is Garbage. I bought it about 2 yrs ago. It does “ok” inside the house and it’s trash outside. No flow. I have it hooked up by Cord. I saw the employees at HD using it and it was blowing very good and hard. So I asked what fan is that. They showed me and I bought it. Took it home used it in side and it was ok. Took it outside and i was deeply disappointed.
@aprillewis1794 ай бұрын
Ok so I figured it out the soap holder pops up and out😂 ty
@aprillewis1794 ай бұрын
Thank you for the video, my left tank is leaking an6 idea how to acess this I'm assuming from the bottom of machine, any help will be much appreciated
@jamespolucha87904 ай бұрын
I have the same bags I had to get a sheet of aluminum and made two sheets one on the inside and one on the outside kinda sandwich the bag just to stiffen it up worked out good no more wiggle
@RickG-l3b4 ай бұрын
Great looking bike, that rear fender looks great. I've got the same scoot and just added an Ultimate solo seat. It raised you about one inch from the ground but the comfort level is off the chart. Just over $325.00 and a great investment if you're in the saddle for the long haul. BTW, thanks for your service brother, I too am an Army vet.
@elegantshells4 ай бұрын
2004 GMC Denali
@elegantshells4 ай бұрын
We just put in a new throttle body. It worked great for two days. Now it's worse than before. 😭 Help.
@kwokfaing43705 ай бұрын
Thank you so much for posting this, I was able to install mine following your video.
@LegendarySavannah6 ай бұрын
Can you show us how to do the brackets by chance? Thanks in advance if yes
@DIYwithChris6 ай бұрын
Unfortunately, we are no longer in this house.
@RickG-l3b6 ай бұрын
First thank you for your service. I've got a 2005 C50 and have been considering aftermarket pipes, video makes it look straightforward. Thanks for posting.
@mrob4562 ай бұрын
I just bought a 2006 with cobras, its loud and it sounds nice.
@aaronbrown8136 ай бұрын
What size drill bit did you use to make the holes
@pauljames55936 ай бұрын
I had the same arrive today without instructions so thank you
@LeahJackson8317 ай бұрын
I think the Hanes peeking out is cute 😂
@exitrealtyspringside83097 ай бұрын
Just as you described every step of the way. Thank you. Hoping the replacement piece stays put as I didn't feel super confident with the screws and glue.
@adrian23927 ай бұрын
Mines too on my 2018 Buick regal
@xman22297 ай бұрын
Poor explanation and DARK!
@Louis-z8z8 ай бұрын
Where can I buy Cobra exhaust for my 2008 Suzuki Blvd c50
@nickvictor5778 ай бұрын
Thank you! Very helpful video.
@marccanales26308 ай бұрын
Nice work although am worried about clown show vandals who may dick around with your wiring.
@natashat29309 ай бұрын
We have installed this pull out system with soft close , but I have to pull kinda hard to open the door. The first few inches you have to pull hard, as if something is holding it back, (I feel some resistance), but once it's past that point it glides easily. Is there any adjustment that can be made to make it open without any resistance?
@BlueShoeMagoo10 ай бұрын
I noticed that this light fixture didn’t include insulation to protect the wires from the heat of the bulbs. Is that considered safe?
@heyitsbroski10 ай бұрын
Replaced the throttle body on my wife's 2012 GMC Terrain SLT and a day later it came back. This truck is a major POS.
@ismaelsalgado03268 ай бұрын
Did you get it fixed?
@katejohnson45710 ай бұрын
I'm clicking on the links for the plans and they are broken links. Can you help me find them on a good link?
@DIYwithChris10 ай бұрын
diywithchrisdesigns.etsy.com/listing/1270845937
@curtismoorehead105011 ай бұрын
Thank you good brotha !! That really worked I followed your step by step and cleaned it the throttle box and Wah!! 👌🏾🙌🏾 drove it a few miles just too check engine light went off and it’s also driving back normal again
@sdufg11 ай бұрын
handsome man
@AA-zq1sx Жыл бұрын
Thank-you for the video, it was perfect... saved so much time from the confusing instructions!! <3
@AA-zq1sx Жыл бұрын
It doesn't even come with a blade anymore... you have to buy your own 10" blade!!!
@PhilipHuston Жыл бұрын
Chris, I used the spare when I had a flat on the freeway. It had never been used on this 2022 Odyssey and the aaa guy put air in it to mount. My problem is putting back into the well in the car. it does't seem to settle all the way down and I can't turn it at all to put the wing nut back in. It does not settle in enough for the board to be put in correctly to be flat. Do I need to deflate it a bit for it to have room to turn for the wingnut and also be low enough for the board to fit flat? Thanks, Philip
@DIYwithChris Жыл бұрын
I did not have to deflate the tire at all. It is definitely difficult to get back in and sit flat.
@schwame Жыл бұрын
Great video, thank you! Been having an issue with idling. 2018 Equinox, 40k miles. After cold start, while idling, needle moves around, sometimes as low as 4k rpm. Then for first few minutes of driving it feels like less power. Problem seems to go away after driving a while but I've been thinking about cleaning the throttle body. I may try this.
@ConMan-gp7sc4 ай бұрын
Similar issue, did you figure it out?
@olheghtt Жыл бұрын
Nice video, thanks man. The bars I bought did not come with bolts. What is the thread for the upper-right bolt?
@michaelirizarry4881 Жыл бұрын
Dam good training video. The longer the video the better.
@AnthonyGonza Жыл бұрын
Gu😮yo
@923mercury Жыл бұрын
You probably should not have used oil. Soap and water is what the instructions say.
@carlyyy93 Жыл бұрын
Soap and water did not work. I used what functionally worked for other people and it worked. I also disclaimed this and that it is not recommended. Thanks for your concern for safety.
@Ukepa Жыл бұрын
thanks, this is just what I needed (cheap and works great!)
@migggyboy Жыл бұрын
My kit doesnt come with those channels at the back. Is it okay to install this roof rack without it? Thanks for the help.
@migggyboy Жыл бұрын
Bro those channels at the back of the moulding is it okay if i dont put it? Thnks