Is this the one located in Bridgeville, PA? I was going to go look at it.
@brianjohnson90473 жыл бұрын
I have one and need springs for pulley
@bigd35713 жыл бұрын
What size honda is that 13 hp? Did you have to change belt size?
@christopherwilson56714 жыл бұрын
Should have kept the engine and put it in the Hummer
@aurelioamezquita98754 жыл бұрын
Ok I
@AnthonyForesta5 жыл бұрын
Where is the oil dipstick?
@0123terryb5 жыл бұрын
I purchased what looks to be the exact mower you did(mine is used and doesn't have the model sticker). Can you tell me what model the model number is on yours?
@Omegadoomship5 жыл бұрын
I'm currently fixing one of those for a friend. It blew the engine so I swapped the Kawasaki with an 18 HP Briggs Vanguard. The problem is the hydro pumps are worn out among other things and I think it might be time to retire it for good.
@paulj5416 жыл бұрын
AAAAAHHHHH-HAAAAAA I saw it backfire through the carburetor!
@paulmarado7 жыл бұрын
I've got the same one. Tires are hard to change.
@JustinIsJustout7 жыл бұрын
Got skillz!
@siTTinLo7 жыл бұрын
Thing bogged like hell....
@hilham895 жыл бұрын
Sounded like he had to turn the blades off before the more died. The motor is to small for the size if deck. I just seen one with a 60" deck with a 20 no Briggs motor. Last mower I had with a deck that size and a motor that small would not cut worth crap.
@usoafreight26962 жыл бұрын
@@hilham89 What do you mean it's too small? It's a 25.5 HP motor ... the same exact one the John Deere's uses on their 60". He was probably not up in RPM as that was mainly idle speed. I have this exact one, runs just fine.
@hilham892 жыл бұрын
@@usoafreight2696 read my comment. Read the title of the video then come back and try again.
@usoafreight26962 жыл бұрын
@@hilham89 I read before I commented very clear so to help you comprehend your own words... You: "The motor is to small for the size if deck" Me: "What do you mean it's too small? It's a 25.5 HP motor ... " (Edited on that as I meant 23hp but what's 2hp? whoopty do) You: "Last mower I had with a deck that size and a motor that small would not cut worth crap" Me: "the same exact one the John Deere's uses on their 60's... with 2more hp" You: "Sounded like he had to turn the blades off before the more died" Me: "Sounds like he was in idle to begin with so what's your problem with that?" So if you read deeper into my comment on that vs playing the typical simple victim, CHANGE YOUR BLADES and service your shit like you re supposed too. It's not the horsepower as you very much want it to be. So what on earth are you talking about with being "too small"? I have this and a Scag 70 running a 25 with a half-dead cyl I got on a big discount, cut's just fine. It's not the deck size that does anything hell the blades are like 12-14" long.
@hilham892 жыл бұрын
@@usoafreight2696 lol ok, I see how this is going, listen bud I don't have time to set here and argue with someone who thinks they know everyone's mower. This comment was made 2 years ago I have more important things to do then argue over a video with a keyboard warrior. I honestly dont care what you have or had and I don't care that you think I didn't take care of my stuff. For your info I check my shit just like I do my semi every time I run it.
@christopherabbott9918 жыл бұрын
I have a 2007 cub cadet LT1042 with 455 hours and it's a piece of shit!!
@franksrideon81878 жыл бұрын
Good job Robin, keep it up. I did a similar video called muddn
@brianmizell24959 жыл бұрын
These part numbers are for a Lesco Viper Z2360 (Kawasaki 23hp with 60" stamped deck) V belt for the PTO is 84.2" long # 01005012 Belt for blade 120" long # 01004990 Blades 20.5" High lift # 01004719
@tinahaddix52539 жыл бұрын
NEED INFO ON BELT FROM MOTOR TO DECK, PART NUMBER OR SIZE. i ALSO NEED TO KNOW HOW TO ROUTE THE BELT.
@charlesswords46539 жыл бұрын
Tina Haddix I have a lesco viper 60"cut and just bought that belt and after 2 trips to advance auto parts its an 80" belt
@tinahaddix52539 жыл бұрын
Is it a 80" by 5/8? Do you have a pic or diagram for routing? There isn't one on my mower, actually my landlords mower. He doesn't have a manual either. Thank you.
@demonking20076 жыл бұрын
I am having a difficult time finding the right PTO belt from my Ztwo 54" with Kawasaki 23hp.
@usoafreight26962 жыл бұрын
@@demonking2007 Same here, Look at the cub cadet Tank. I heard it's the exact same mower type
@lynngillespie60879 жыл бұрын
how to set the float on a 23 hp kawasaki engine
@kayemillard901410 жыл бұрын
bullet (instead of bullit)
@fredfujan395510 жыл бұрын
Umm,It might be because its Not a zero turn.
@shall586711 жыл бұрын
And that wasn't even a good demonstration of the 0 turn radius on these, unless there is something wrong with this one.
@sammyknoll5604 жыл бұрын
That’s not a 0 turn tractor 😂
@fredfujan395511 жыл бұрын
Damn! Now Everybody Knows!! LOL
@sambonig108911 жыл бұрын
do you realize that you can buy this new at home depot with a warranty for $1299