@@SBarnatLTD yes thanks for your review. Let us know what other technical video content you’d like to see.

Thanks for your feedback. Let us know what other technical videos you'd like us to provide.

There may be no reel back tension due to gravity or machine infeed.

@@ELEKSoftware Got it. Thank you.

Thanks for your questions. 45 A is given, it’s the rated current of the motors. The power factor is incorporated in the simple Vc constant for voltage drop as either 1 or 0.8. You should use software for better accuracy-see the link to ELEK Cable Pro Web above.

It’s a constant related to cable impedance for the cable from the standard AS3008. Other standards may provide different constants with different units to Vc but the principle is the same.

Thank you for your feedback. Jayson.

You're welcome.

elek.com/electrical-software/elek-cable-high-voltage/

We do both HVAC and HVDC

Glad it was helpful!

Select the appropriate Phase setting in the software.

Yes thank you German.

Hi Antonio, we really appreciate your interest in trying our product. The codes we include are AS/NZS 3000, AS/NZS 3008, BS 7671 and IEC 60364 so far. I think the fundamentals of all the LV electrical standards in terms of design are quite similar. You can email [email protected] and we can organise a meeting time which suits.

Thanks for your quick response. I will be in contact this week.

Thanks Sumit

One month ago. I was doing a transient stability study where downstream MCCB with Thermo magnetic PD shall trip on 3 phase SC fault and upstream ACB shall not trip. Incoming source is a DG. When I did the relay coordination study then I observed a definite time gap between tripping of the downstream MCCB and incoming ACB. However during the transient stability study downstream MCCB did not trip due current decrement factor and excitation control in the DG. If I lower the current settings in the MCCB then it crosses 125%of full load current criteria. Eventually I added micomp120 relay instead of thermomagnetic protection. The window of thermo magnetic protection gives problem while using transient stability with a DG.

Thank you very much for your feedback Marco. We are continually improving SafeGrid based on our users requirements and their feedback.

Marco that’s great you are doing that. Thanks for the feedback. What new videos related to earthing would you like to see?

Thank you Tim. I'm glad it helped you.

Thank you Marco. Have you downloaded the free trial?

Thanks!

Great! Thanks Peter.

Hi Tim, thanks for the feedback. Yes that's a good idea. Just note that in the bottom left of the screen there are step-by-step messages given to the user for guidance on using each of the drawing functions. Reach out if you'd like further guidance or have more feedback. Thanks again.

Thanks for the suggestion - we will create that.

Thanks!

Thanks for your question. Please try the software Cable Pro Web and you will notice that ON or OFF means that part of the time current curve will be present or otherwise. Hope this helps.

Appreciate that.

Thanks for sharing your experience Sumit.

visit www.elek.com.au

Thanks a lot!

Thanks Dominique. Yes very important to reference the tables in the Standard - which the software does also!