@ronagarage512 please let me know what I need to do

Typically they return to center

www.amazon.com/dp/B07Q7VSVBY?ref=ppx_pop_mob_ap_share

www.amazon.com/dp/B07ZMNXSQR?ref_=cm_sw_r_apan_dp_0MFBXVJ0A30KCDTB0V50

Yes! Does it have a motor attached to the steering column currently?

Any of them can be converted as long as you buy the right kit. If you flip it over look for a motor at the bottom of the steering column. If there is, buy the kit linked, if not itll require a little more modification but they sell kits for it

I don’t believe it does. It doesn’t have a radio either.

Mine has that is electronic, front lights, horn, forward/reverse. One rear wheel motor. I’ve tried to upload pics but it won’t let me.

Im getting ready to do another one this week for a family member, I might mount the battery like that on that one

@@ronagarage512 I got the 24 volt motors with the Milwaukee 18v battery. Still 12v controller lol if it fry’s it I will upgrade that to

Yeah i usually upgrade those right off the rip now. The first one i did the board caught on fire after about 2 mins of running

@@ronagarage512 damn, The only thing He did was break the gear in one of the 12v motors. I will have to watch that

Its in the description of the video, but here it is as well. www.amazon.com/dp/B082X9J2WT?ref_=cm_sw_r_apan_dp_GD1M74X527B1XKEF57BC

What do you need help with?

If you are using this kit and keeping manual steering, just zip tie the wires out of the way. You won't be able to steer from the controller, just forward and backwards. If you're converting to power steering they make this same kit that will come with a steer motor to install

Absolutely

It will work. There are different kits on amazon. Most of the power wheels have power steering, if it does, the kit I used will work. If it doesn't have a steering motor you can buy a kit that comes with one

@@ronagarage512 only the rear wheels have motor not the front

I've yet to look into this, but I like the idea. My youngest can't drive his gocart one yet. Let me look into and do a video on that one.....stay tuned

All good lol I've never seen mine spark but if they are a brush style motor that's normal

It’s the stock drive motors that was in it and I used the same 24v motor you recommended in the link. Thanks for everything

Yes sir. The milwaukee battery will be around 21 volts fully charged but even when it drops to 18 it will still power it fine.

I have another video on my chanel about this. Mine did the same thing and circuit board melted. The other video shows how to upgrade it to 24 volts and has link for board

Thanks man!

Yes sir!

We are currently trying to convert our land speeder. Were you able to do it? Any advice?

@@paigeseibert3873 I didn't get a chance to buy it. Dude up the road was selling one for $50 but I didn't pick it up because I didn't have a place to store it/wasn't fast enough on asking about it. Haven't found another in my area unless it's new unfortunately. But the logic is sound what he accomplishes in this video.

$50 is a steal. We were lucky to get ours from a friend for free. Just the cost of driving 25 hours round trip to pick it up. Well wish us luck trying get it converted.

@@paigeseibert3873 let me know when you get it working! I'll definitely be on the lookout if you are able to get it to work!

Before

@@ronagarage512 hi sir. So connected a bosch 18 v 1,5ah + fuse 10a + rx30 b + 2 motors 12v . When the kid press the pedal it burns the fuse. Is too small or something else happening? I tried with the original 12v and without fuse it works normally...

Yes it will work for any power wheel

They came on the power wheel

@@ronagarage512 thanks! I guess the new model doesn't have spacers they just made the drive motor longer. For anyone doing this upgrade I used 3/4 pcv cut 1" between the motor and bracket to make it work. Also the rx30 doesn't like less than 18v for me. I give it the full 20.5v and use the speed setting on the controller. Everything is working great thanks again!

I'm not sure, I think you'd need to upgrade to a 12 volt battery as 6 volts would be too low to turn on the controller but the 6 volt drive motors should hold 12 volts just fine. The controller is usually the first part to go with higher voltage

Bought a used 6v car. I’m going to need to put this harness in because it needs a remote control. In addition, the 6v runs very slow in the yard and want to upgrade from 6v to 12v battery. Will this same harness work with a 12v battery upgrade?

@lauriecox2689 yes! It's made for 12 volts. So it should work perfectly

Yes just a single m18. Frest battery voltage sits around 21volts, levels around 19 volts

@@ronagarage512 thanks for the reply! Any idea what the minimum voltage it would still run at? I'm planning on using an m18 battery with low voltage cutoff and voltage controller to regulate the max speed because my kid might not be ready for full speed yet. Would dialing the voltage down to 14v be too low for the rx30?

@sactime 14 volts might be too low, I've seen it go down to 16 volts and it was moving pretty slow then (in comparison) you should be able to dial down the voltage and get a safer speed out of it, just not sure about 14 volts

@@ronagarage512 thank you! How is 16v compared to stock? Still too fast for a 2 year old?

@sactime shouldn't be. I put my 18 month in it will full juice lol but we used the remote to control him. 16 volts should be good. Not sure if you have a high low speed switch on the power wheel too but you could use that to slow it down some more on 16 volts if need be

This should work for any 12 volt power wheel with an electric steer motor

This guy is taking a ride on car already designed for electric steering and basically re-adding it. Most real powerwheels brand cars do not have electric steering and trying to make clearances for a motor and gearbox is huge project. He adds it to one car and acts like it will work for any car. The motors forward/reverse/brake can be added relatively easy however. But if you want full remote control and your car doesn't already have steering, you're prob better to save the headache and buy another brand unless you are extremely capable and have free time.

Its actually really easy, if you buy the kit with the steer motor. Ive done 2 where we had to add the steer motor and not alot of modifying was needed. Ill try to pick up another power wheel without it and do a video soon. But it can be done to any powerwheel

We have one yhat does not have a remote controller, when buying the equipment I need to get one with a steering motor​ correct? Wanting to adjust the one we bought for Christmas! @ronagarage512

Same controller will work. It has an additional spot to plug in another motor

@@ronagarage512 link is dead. And I'm can't find one that looks the same

They sell a kit that comes with a power steering motor. You can literally convert any of them just like this, but in your case you'd have to add the electric steer motor

weelye Kids Ride On Car 12V DIY Modified Wires Complete Set of Remote Control Circuit Borad Wires Switch Gearbox with Motors,Children Electric Ride On Car Accessories a.co/d/gLwqMS0

I'm having the same issue with my 69 el camino. I cut them down and still not fitting.

www.amazon.com/dp/B082X9J2WT?ref_=cm_sw_r_apan_dp_GD1M74X527B1XKEF57BC

Something is backwards negative to positive possibly

Yes this is a 12 volt kit and will require at least 9 volts

So I have the new 12v battery on but nothing is happening

Doesn't power up at all? Maybe check and verify the charging Potlatch is connected correctly as that is the ground side of the battery

I think it’s the controler in the car since I put a inline 10amp fuse and it keeps blowing every time

If the controller in the jeep is the same as the one in the new kit then you won't need to swap the harness

@@ronagarage512 there is no controller came with it the kid basically have to knw how to drive it but my nephew is only 2

@remixz23 by controller I mean the box mounted under the seat. The brain box if you will. If that is the same style you won't need to swap all the wires, just that box

@@ronagarage512 yes it is same style however i dont work with wires and its confusing 😭

weelye Kids Ride On Car 12V DIY Modified Wires Complete Set of Remote Control Circuit Borad Wires Switch Gearbox with Motors,Children Electric Ride On Car Accessories a.co/d/gLwqMS0

How do I know if I need a steering motor?

Not that I'm aware of. Since the voltage has to go through the controller. They may make a controller that would do that but I haven't seen one