How did you remove the glass part. It cant be seen in the video

Excerllent thank you 16:38

cant really see what you are doing there iside the wheel arch.

🎉i give you 24 black label for weekend

Hi do you have video from rear bumper?

Great video tutorial, thank you.

Comment savoir ou foré sur octavia 2018 ? Merci

👌🏽👌🏽 I have the same problem in my golf and I tried to found that hoses 👌🏽👌🏽

Do you know where the RDC module is at. saw this video because some say it's behind the bumper. but I didn't see it in this video.

Thanks for the video. I had to guess where you were taking screws. Video ended too early. I needed to see the panel with the soft panel removed.

Hi my nearside front fog light plastic mount is broken, do you think i can get to the back of it to replace it by undoing just the passenger side arch trim and bumper and levering it forwards slightly without undoing the offside trim and taking off the bumper completely ? I think i have radar sensor in the middle of the bumper also . Regards.

Do I need to take the window out with change the locking mechanism?

Does this work on a 2018? Can anyone help?

I may have this leak. Can you tell me where was wet in your car? I have a small wet patch under the front of the drivers seat. I have felt the underlay and it is wet in a larger area than the carpet. I found a new spot today where the front left bolt for the drivers seat is too. Thanks in advance!

Cheers Thanks John!

Thank you it was helpful

It was needed to cut out the windshield?

Great video. I have a 2021 GTI. In the states theres is a spray called Fluidfilm, which is basically linseed oil, and it is a great rust inhibitor.... I think I will do this project soon before the winter.... thanks so much!

Best presentation on you tube .....💪💪💪

I appreciate all the audio and explanation of what your doing 😆

И как потом эту косу засунуть обратно?)

Stopped watching as you didn’t show what you were doing

Dans le pare-choc sans capteurs avant il y à les emplacement pour les ajouters ? Merci

Hi John, why no sound or explanation of what you are doing?????

Thank you, any ideas on the fix if it keeps pulling out after doing the fix ? Regards

Do you have to remove the tail lights.

Water coming up from the drivers side footwell - exactly this problem on my 21 polo. Cheers!

very helpful video, thanks!

is this enough to replace the headlight? Thanks

Thanks for the video. You helped me take my front bumper off to replace the damaged grill ...one hour off one hour on... but don't forget to wire up the wiring loom before you screw it back up.... like I did 😆 😆

Appreciate how thoughtful your demonstration was👍

Did this job on my Octavia last week. You could grow spuds in the dirt build up on this Golf, my car had very little, unless someone had cleaned it out before but I doubt it. Took the whole liner out and cleaned behind, then sprayed area with Dynax UC. Removed sponge, which seems to hold water at the bottom and haven't replaced it. Haven't noticed any increase in road noise inside the car and have driven through some heavy rain with no apparent problem of water going where it shouldnt.

Cant see fuk all underneath what yur doing

should the sensors just automatically work again? Ive done it and even changed the old sensors to the new bumper but its not working

Kuga MK3 is exactly same job or different procedures?

Be careful when removing the small plastic cover on the newer models (2023->). The cover has two additional plastic "hooks" on the inside (top/bottom). The two additional hooks will likely break when you pull or reseat the cover. Those hooks are just very fragile. It's properly advisable to replace the cover. Also may want to push the plastic brackets (under the screws) a little upwards/downwards before tightening the screws. This will ensure that the taillight is more firmly held in place so that it does not rattle in its socket. It tends to be a little lose as it is only fixed by the two screws at the end of the taillight.

Eso es un twingo???

Was going to do this at pick and pull to get main dash harness. You convinced me the $200 on eBay for one pre pulled is worth it! 😆

Il mio baule quando premo tasto baule sul baule si sente che scatta per aprire ma poi devo premere sulla lamiera sotto al tergi con forza X farlo scattare e così apre ..qualcuno può darmi un aiuto?

Thank you, nice explanation.

Hey, awesome video! Is there any way to just remove the front grill without taking the entire bumpre off?

Can you do for a troc?

Спасибо, очень подробная инструкция!

Can you please make as many videos on the Skoda Enyaq? It's super interesting to me. There are not many creators that do these teardowns on them😊

4:37 He broke something

Me ha servido de gran ayuda. Espero no romper nada, como has nombrado en el vídeo. Gracias

i broke 2 clips taking wing arch trim off

Please may you tell me if it is simple to remove and replace the grill once the bumper is off? Is it held in place by clips or is it welded? Thanks so much for your help.

There’s a screw under the door handle horizontal section so you have to remove the plastic plate and then undo the screw.

Very clear job 👍