Thank you

That's counter clockwise to remove.

Getting as fluttering noise from my intake on my 2013 Fusion 2.0 eco boost. Not sure this is normal but when you lightly accelerate and let off the gas you hear a fluttering sound from the intake. Is this normal with these cars? its not loud at all but just converned. Thank you in advance. (No check engine codes)

What circular saw blade you were using? Was different from than wood blade?

They could add a dipstick instead.🤬

Thank you!!!! I had such a hard time figuring out what part it was because of the name

Good job brother. 💪✌️💙🏇🏇🏇

I always start the spline on top and then the bottom while pulling the screen down firmly but not too tight and then doing each side the same way. Use the concave wheel side of the roller and press the spline into the channel holding the roller at around a 45 degree angle away from the good screen that you dont want to cut. It seats it in the channel. Works great on round spline, even flat. Ive had perfect results this way, nice tight screens but not guitar string tight, still a little give, no wrinkles. Works perfect for me. And Im a little more liberal with the excess screen. I find it makes the job much easier. Pro tip, use metal clips that are specifically made to hold the screen in the channel instead of tape when you begin to make it alot easier when working alone. Sometimes tape wont stick depending on the weather conditions like higher humidity.

Thank you

Great video but you didn't say how to check the oil dip stick that the truck had to be in Park or neutral on mine it says to check after normal operating temperature but in neutral is this true?

Thank you for sharing!

Wear fo you get spring from what are they called

Omg does anyone have video with proper wire set up.

I have a question I have a 2013 Chevy Cruze my car just cuts off for a short second and then when it comes on it says service stabilitrak and goes right off. No engine light or nothing when I use the code reader no code comes up where do I go from here

Bro used math and everything

Worked perfectly, thank you so much

How would I clean out my mower deck? It doesn't have a cleanout port.

Thank you 🙏 Didn’t see how to install the gate, probably you don’t have on in this case?

Great video... until it got to the wiring connection.... then it became the worst

Exactly what I was looking to see done. Thank you! 👍🏾

THANK YOU! My Cruze is getting old but is still in amazing shape. I will die before I have another car payment. This exact thing was happening and bc I took your advice, isn’t any longer. Ty!! ❤❤❤

Please do a video on how to do the gate on the vinyl fence. Thanks!

Thank you so much for this video. We lost our old wood fence in the hurricane last week. My husband and I are going to try to replace it ourselves. The fence outlet gave us an estimate of 1800.00 for just one front panel and one half panel with a gate. CRAZY! We looked at that same product at lowes yesterday. You're a lifesaver!!😊

Very good bro. I will be installing one next week. Question, you don’t really need to install those stoppers on the sides of the garage door, right?

Great video u just saved me alot of money lol

Did you really use 10 oz of sealant?

Bro, I followed your tutorial and was able to replace 4 of the bigger panels within 3 hours minus a lunch break. You just earned me some brownie points! Thanks!

My car is still shaking after I changed the plugs and coil packs. It still says service stabilitrak and traction control

I had 3 sections blown out form Milton the Monster. I wasn't sure if I could do it myself, or not. I watched the first 5 minutes of this video, went out and did the entire repair job. Thanks so much for explaining how to do this in such a relatable and concise manner !!!

Thank you! I'm renting and my rental insurance has a $1k deductible. Hurricane Milton really messed up my 3rd floor patio screen. Can't wait to try this!

I did that And still doing the same thing

After reading the Yamaha manual it says to tilt the motor to drain all the oil. The position you showed would allow used oil to remain.

No farming for subscribers, look how much I got!

Thanks so much for the video and “how to”. I had no idea how to get access to two of the plugs. Your video made it possible for me to get all the plugs changed - Thank you 🙏

Thank you! I'm going Pennzoil Ultra Platinum 5W-30, since I'm in a warmer climate year round. Went with a Mobile 1 M1-104A filter. All with the help of chatgpt. Only thing different is the flutes on the filter..mobil 1 has 15 flutes instead of 14. Guess I'm gonna need a clamp device to get it out. Anyways, here goes nothin! Wish me luck 🙏

Why didn`t you use 3 screws for the filler strips to the post or lock the rails in with screws under caps? Locks it all in.

THank you❤

What if I only have two wires (ones blk and the other is red) coming from the ceiling were my light fixture was. What do I connect the white wire to?

If it had two tags on the diff one of them is for the limited slip additive, and yea they break all the time. Also if that fluid doesn’t come out a little red then whoever serviced it last made a mistake. Looked nice and red immediately.

The best instructions! Thank you.

THANK YOU! It's been sitting dead for months! I purchased several items off your list to support for saving me such a hassle! Im a software engineer, cars are so hard to understand though 😅

This is the easy part in repairing a damaged fence the hard part is straightening the fence post that are leaning.

What happens if you have no engine light but still have stabilitrack error

Valeu me ajudou muito!!! Montei o meu vendo seu vídeo.

Martin Jason Johnson John Martinez Michael

well, at least you didn't shoot your pathetic neighbors for leaving that disgusting wood fence up

Fantastic video. Also looking for protection for my KeyWest because getting it into the garage is a mission.

Is this the same as the engine filter or?

So do u think putting sand in the post about 2 feet up will help keep the post in place in the event of a hurricane, my fence stayed up during Milton but I was worried about it because it went down when Ian came through, my post broke off at the ground level they were set in concrete too.

Thank you sir .. answered my exact questions after Milton 👍