Is that a Weed Eater brand?

Can I use 98 octane fuel in this unit?

This helped me out a lot. Much appreciated.

Too bad it doesnt demonstrate actual operation. Would have liked to see how And how well it mulches

Mine's great, 3-4 year old now. Went to use it yesterday, could get more than 15 seconds running, I worked out it has a safety sensor for the oil level, if its low, it may not run. Make sure the oil level is right. Runs fine now,

No output

what's the brand name of this water pump?

Gr8 video. Can you tell me does the suction pipe require a one way valve on the far end? TIA

Hey, nice video. Can you tell me does the suction pipe need a one way valve on the far end? TIA

Thank you very much

1 NEED A AIR CLEANER FOR ONE INCLUDING CASE.

I need to replace my almost 20 year old Onga, but at a budget. Thanks for the video. I'll now get one of these.

So I had one of these unopened in a box for a couple of years, then moved to Tassie. I got it running as per instructions but the green light won’t come on. Is there a quick fix?

Thanks for the video

So I’ve followed this instruction and when powered on manual mode the unit doesn’t suck from my water bucket intake. What’s going on? I filled the filter area to prime as shown until it overflowed.

Does this have a pressure switch or do you always need to have to turn it on and off manually?

Nice video but you could’ve done a video about replacing a straddle

Need to see an example of it connected to a Water Tank. Page 10 of the manual says it is suitable to use with a rainwater tank. I have not been able to get this to work where the pump effectively allows water to flow through it even when turned off. I wanted to water my garden once a day taking water from the water tank however as soon as I open the outlet valve from the water tank water trickles through to the irrigation system which if left in that state would slowing drain the tank. I expected the pump to only flow water when operated either manually or via the timer and when the pump stops it should shup off the inlet valve. Without doing this it is NOT suitable to be connected to a rainwater tank as advertised.Now I need to return the pump having wasted so much time plumbing it in and am severely out of pocket. Useless dysfunctional produce not fit for purpose.

Need to see an example of it connected to a Water Tank. Page 10 of the manual says it is suitable to use with a rainwater tank. I have not been able to get this to work where the pump effectively allows water to flow through it even when turned off. I wanted to water my garden once a day taking water from the water tank however as soon as I open the outlet valve from the water tank water trickles through to the irrigation system which if left in that state would slowing drain the tank. I expected the pump to only flow water when operated either manually or via the timer and when the pump stops it should shup off the inlet valve. Without doing this it is NOT suitable to be connected to a rainwater tank as advertised. Now I need to return the pump having wasted so much time plumbing it in and am severely out of pocket - time and materials. Useless dysfunctional produce not fit for purpose.

Thank you! Extremely helpful.

Thank you! No manual at new property so this was extremely helpful!

Hi mate I have one of these, but ever since brand new, it has trouble starting. Maybe it's an easy adjustment fix. It starts easy 1st time every day, but 2nd, 3rd, 4th, etc starts it takes about 5 seconds to turn over, and then it stutters for another few seconds like it's struggling to turn over, but it usually always eventually starts and then just runs normal. I just wish it would start everytime instantly like the 1st time each day. I always fully charge the key start battery. Whether using the key start or pull start, same thing happens - so definitely not the battery's fault. I don't see any fuel tap or choke like on normal mowers. So there's nothing to manually adjust. When it struggles to start, it sounds just like when you forget to turn the choke back off on an old regular mower. I just wish I could see the choke to experiment adjusting it, but I can't even find it on these. Happened since brand new out of the box. Any tips much appreciated thanks cheers.

عندي بالمولد تشتغل بس ماتنطي كهربائية وتشعل كلوب احمر

that trimmers clutch has gone

I have one used it twice and now it only puts out 160 volts

Thanks mate. Just bought this from Aldi and couldn’t get it to work even after watching your video. I had to watch your video twice to realise I had not filled it with enough water to start. But she’s kicking now

Hello I want to connect this to a grey water 100lt tank, so that everytime we shower it will turn on and water the yard.....will this work in automatic mode for this?

It would help if you said which mower you are talking about!

I got a same water pump, anyhow the water cane out intermittently, prime few times, kept waiting for more than half an hour, the water still intermittently. Any suggestions for that?

do you think the pump could handle pumping out sewerage pits over flow? did you have to prime it first?

Can you please give a part list of your tap attachment?

12mm feed?! Something odd going on there. A quarter to half a revolution of winding on the reel should be much more than that.

Thank you

you very good

thanks

Why do you even need the mulching plug if the rear door closes anyways covering that opening?

Thanks for the video! This will help my old man out after buying him his first bump feed. Very informative and quick to the point. Great work

Forgot to note that indicators P and L are on in auto mode when pump doesn't stop while expected.

strong pump, provides good pressure, but automatic mode doesn't work for me. Pump has good water intake. All air is pushed out of pipe and when I close the tap pump might run indefinitely. I have to turn it off manually. By the way, 1. double checked the pipe and fittings, even that it's short run, there is no leakage. Yesterday I used pump last time and today when I opened the tap, some water came under pressure, meaning pipe, fittings and non-return valve are good and holding pressure. 2. previous pump worked on same installation and was working in auto mode OK, so it must be problem with the pump itself? Any thoughts? Thanks!