Excuse me, are you using the original O2 sensor or replacing the sensor?
@aohage Жыл бұрын
I removed the genuine o2 sensor and installed the PLX wideband sensor in the same place.
@farmerjohnson4086 Жыл бұрын
@@aohage ok, thank you very much for your reply, because I use the SMARTMOTO O2 sensor to replace the original one, it will cause the engine failure to light up
@farmerjohnson4086 Жыл бұрын
My PowerTronic has not adjusted the oil map, using the PowerTronic factory setting
@aohage Жыл бұрын
It is recommended to measure and adjust the air-fuel ratio while using the base map. I made my own basemap through the chassis dynamo Then run and fine-tune
@farmerjohnson4086 Жыл бұрын
@@aohage ok, thanks for the advice, thank you very much for your reply
@farmerjohnson4086 Жыл бұрын
May I ask which brand of ecu you use?
@aohage Жыл бұрын
It's a powertronic
@farmerjohnson4086 Жыл бұрын
@@aohage Powertronic can break the rpm speed? The original speed is only 10000rpm
@aohage Жыл бұрын
Rev limit can be extended I have it up to 12000 rpm However, in reality, it shifts up at about 10000 rpm without turning that far.
@farmerjohnson4086 Жыл бұрын
@@aohage I also bought it, but encountered some problems when using it after 8500-9000rpm, the car will start to vibrate and the original quickshifter cannot be activated.
@farmerjohnson4086 Жыл бұрын
@@aohage Excuse me, can the original quickshifter work normally after you use the powertronic ECU after 10000-11000rpm?