Spot on thank you

Do you have for BMW F10 to?

Would this work on vw Passat 2011 b7 ? Connect 12v to rear number plate light, car battery is disconnected with locked doors then closed bonnet arghhhhhh 😢😢😢😢😢 emergency plastic key doesn’t do anything when turn right or left. Need to find away to get in to open the bonnet & connect the battery again… help

كم السعر

The engine CANNOT BE REPAIRED. Machine shops: 😂

💥 *Promosm*

I took one of these for a test drive (Sydney, Australia around 1992, I think) and decided not to buy it. Have regretted it ever since.

Would it go perfectly with an m6 f13?

Habe eine Frage, ist bei dem 323 im Video nur der endschalldämpfer geändert oder auch andere teile der Auspuffanlage, Krümmer oder Katalysatoren? Beste grüße

Hi, can you please let me know when I can buy the tool you used on @1:26 ?

Not a fair comparison, because of the fan noise in the first part.

I thought this was fixed after the n20...

When money is not a factor...

not helpful.....i dont need to see it in fast motion. I need to see it slow motion and from the inside

Not everything has to be a fart can and just be noisy/loud This keeps the original note while being a bit louder and a bit more aggressive. Perfect for this car

Come Fix mine it’s looks good just need some engine work like an alternator and battery

The cost for fixing the leaking air spring and the compressor is outrageous and ridiculous. I hate BMW now. 😕

Just curious how do you make the car rev at place ? Cant figure out mine yet, always turns the engine off even in sport mode.

Nice car but it's a pity, that's not the original whiles...

Can you open the boot/trunk in this way? Took out the battery to charge it, and closed the boot/trunk and I have no manual button in the car to open it without power

is this black or dark blue?

hallo was würdet ihr für einen Jaguar s-type 4,2L v8 Automatik empfehlen die Green sind schon mal raus für mich weil die zu viel Dreck machen also lieber die red oder yellow stuff?

Can I hv ur WhatsApp number

Perfect ❤

BMW 850 CSi - DREAMS CAR!!! BMW 850 CSi - SUPER CAR!!! VERY, VERY BEAUTIFULL CAR!!!

BMW f10 n63tu motor what’s the rod bearing torque specs

perfect for my m340i

Just ordered this setup for my 750i . Can’t wait !

this language sounds like the sims would talk like

I would take Melissa for a ride if you know what im saying

How to fix … aber wir zeigen euch im Video natürlich NICHT wie 😂

Just change, Zimmermann diskes for the second time on a M5 because of worp... 😢 customer is furious

10% off on Zimmermann at Schmiedmann.com until the 17th of April 2024 11.59 PM GMT+1! Don't miss out!

Measure Vanos backlash then engine is in operating position. then you rotate engine it will change reading little bit. Just a tip

N42b18?

Ist der noch da

Would this fit in a 318is 1998?

My car battery is dead, I need to jump start it, but it's locked and the doors are not responding. Nothing is responding

Bro when you go to the barber please ask for a low skin fade or a low taper. This will change your life

This was my manifold. I sent it out for coating with Jet Hot 2500. That was a good idea because few details are available about these manifolds - I found 2 people who had installed them and both used shops so these people did not know much. You have to cut away the heat shield that runs from under the alternator to just over manifold runners #1 and 5. This shield insulates the turbo oil drains and the wastegate actuator for the bank 2 turbo as well as the compressor housings. You could sleeve or wrap the drains and actuator as an alternative. Does not make the engine sound like a throaty V8. This retains the cross over between the banks, which is better for performance. Have to buy a M550ix if you want no crossover - some prefer the sound but performance is less. Expect nothing dramatic. Pick the low hanging fruit for mods first. Tune, down pipes, E85 mix or meth, turbo inlets. The manifold costs about half a built engine. I’d put the money towards that instead. I plan to build one in the next year or two and think the manifold will go well with it. If I had to guess on power gains, I’d say it adds a little efficiency. That means you can get a little more out if your parts before reaching their limits. But those parts had overhead before the manifold. I’d say gains are minimal at power levels the stock motor can hold. Maybe it’s like secondary down pipes - 15 rwhp on an otherwise stock motor with a tune. But that is just a guess. This is really more for an 800+ rwhp built motor.

What do you mean by metal flakes? Copper or bigger chunks of aluminium? There is nothing what you can see on the video.🤔

Renault kango 2010 posible??

@schmiedmann wie heisst das alte „we are schmiedmann“ video mit dem e46 m3 am Anfang? Wo findet man das ?

did it throw any code, because you removed the second cat ?

Genius 😎

For its price maybe one of the best choices now that tuningwerk cancelled their productions!!

Same

The best car ever made 💯

Does it go fast