The link above goes to a steroid site. Are you able to post links that identity products and where to purchase? Thanks.

I have a never-used Lily kiln if anyone is interested.

I've found using enamel adhesive then just shake enamel powder over works just fine - then fire, turn over, clean top side then treat as normal for the front. Also, you've used a domed piece, which doesn't normally need counter enamelling, also if the copper is a heavier gauge it isn't always necessary to counter enamel.

Do you have, or know where to get a manual for this kiln.

Hello can i make this usinv photopolymer plate

Yes, someone should show this thing in action!

I absolutely LOVE your work!

THAT IS REALLY COOL!

Do you have the manual for this kiln?

Please prise

Does someone remembers how much was that kiln?

Does someone remembers how much was that kiln?

Merci!

I used to watch this for ASMR

Why does KZbin reccomend me this...??

10 years later: Recommendated

how much this cost if someone need, and how can we order for that..??

Instead of wasting time on film and developer, you can just print out your design/pattern on tracing or parchment paper with a laser printer and then use a laser density booster solution to enhance the blacks.

Hi, when I tried to get in the website, it say no access, please provide with correct contact details, I want to place the order. Thx

Can one use a propane torch? How large can you go with this without cracking?

I run a commercial print shop and we always use laser toner sensitive hot foil film for making the polymer stamps (passing under card laminator) I am surprised to learn that nobody in America actually uses this even though it is the most precise technique around.

Hi, what was that Spray?!

As always - great video - is this stainless steel? and what gauge ?

can i use nail polish dryer uv lamp

Sorry...newbie here...do you still have to fire with a core to protect ring size...and circular opening?

Great idea and I think I just need to keep practicing. I'm using very small images/hand and foot prints to go on silver. I had to double the amount of developing time for the reverse art film and now I'm having trouble with the polymer plates! Question: Should I increase the time under the lamp if the images are very small? My first attempt did not work with 30 seconds! I put in hot water and followed instructions to the t, but whilst scrubbing realised that half the detail had not stuck/bonded? So stamp was no good. I"m going to have to try increasing and seeing what this does.. Will update with my findings..

thank you very much!!!!!!!!!!!!!

So you can solder with the clay?¿

Where would I purchase this system?

Can you enamel using the speedfire

PL mail me [email protected]

Where do I get this kit?

sex

Hi, it is possible to fire this enamel with the torch?, thank you

This is nice,but if s=using copper why not just first start with the counter enamel, pickle and clean one's piece, and then do the front? There's no trouble to doing that. If no pickle is available, copper cleaner works a treat.

Are these photopolymer stamps that you could ink up and stamp on paper as well? I'm a paper rafter and am interested in making my own photopolymer stamps. Thanks!

Wonderful tutorial. Easy to understand.

This looks hard, and i've beenworking with pmc for 2 years now. The only way I can see this working for me, is to use pmc flex. I have the templates, but have been too scared to try this ring.

thank you so much for sharing!!!! great tip Pam!

Thanks Pam!

how many metal clay pice can be fired at a time

can I use a normal paper to print on my art work?

Watching this with headphones gets my body ticklelish

That's a demo?

Where can i buty it?

Just a bit of constructive criticism but your website is awful it needs to be simplified

What is the sprain you use negative tell me all kits names

What is the sprain you use negative tell me all kits names