Same here I’m just looking at the princess auto catalog today n I can’t seem to figure out the sprockets n in the pictures they don’t look like the ones in the video at all can PEi let us please know like all part numbers etc or are the sprockets need to be welded on to the weld-on hubs bc there’s different like are you PEi guy in video ment to say weld on hub and weld on sprockets or do they already come as a one peace ya know what I’m saying here also what does a thrush washer look like ???? 2:03

Nvm about the sprockets I just figured that out after I said that comment now I’m only stuck on thrust washers so the sprockets n weld on hubs do need to be welded together first other then the thrust washers I have everything else figured out also how many of the thrust washers we need ??

Racing vehicles usually use no differential anyway lol

i could imagine a race modded wheel horse 8 or 6 speed trans it would be heavy but bulletproof!

THAT IS A FACT FELLA !!!!@@111455

I have this same trans. It's forward and reverse only

Pulled one of these eith the 1 inch shafts for the same thing. Can't be much difference

buy the parts off of e bay and figure it out. worst thing is dragging all the nasty old grease out of it.... lots of rags and a cardboard box to throw the rags into. i wud put STP oil treatment in the gearbox before final sealing up. up to the bottom of the axle shafts so the oil doesnt leak out of the axle shafts.... STP OIL TREATMENT is generally tooooo thick to leak out of axle shaft. oil /grease the input needle bearings too on the input shaft tower as they need oil/grease. 2 of the 1/2" collars with allen head set screws blue thread lock on final assembly on those grub screws when u get it all together finally. the part # he gave for the bearings is ... are 12mm or 1/2"... axles are 3/4" or 1" on the HD models. so need 3/4" bearings for the axle if have 3/4" axle shafts... or 25mm/ 1" bearings for 1" axle shafts. they are made in the US so the axles should be US standards????

Input shafts and gears vary somewhat from model to model. Although all are 5/8 input shafts, some are machined down to 1/2" on each end. I prefer the full size shaft as the keyway in the 1/2" is very small and likely to fail with any amount of power. I use 3ft keyed axle shaft from Princess Auto. The 719 will not have provisions for ball bearings.

@@peilawntractorracingclubin7053 Alrighty thanks, I'll take this information and see what I can do with finding the proper length - size at princess auto, are you saying for the 719 model, they won't accept the ball bearings? Did all your keyed axle shafts come straight from princess auto;

@@jordon756 axles are available at Princess Auto. You'll see when you open up the case, the 719 model isn't machined to accept bearings like the 717.