Пікірлер
@anthonypropst1818 10 ай бұрын
I was quoted $235 for that.
@southernmarylandmike4373 Жыл бұрын
Thanks for the great video. I am way behind on services for my 2014 Pro-4x. Time to play catch up.
@carltongossett2282 Жыл бұрын
Does my 2005 nessan extra Transmission have a Filter in it please nessan Dealer told me that it did not have one
@carltongossett2282 Жыл бұрын
Does my 2005 nessan extra Transmission have a Filter in it please nessan Dealer told me that it did not have one
@beardumaw24 Жыл бұрын
Nissans are great cars at least the older ones ! My 06 Xterra 4x4 is great ! One of the best reliable 4x4s ive had ! The Zs were great also.
@rud8051 Жыл бұрын
Is there an additive you can add to the rear diff when you do the fluid change that will help make it a little less noisy? Maybe a Lucas product?
@johncrux5975 Жыл бұрын
Great video! How many quarts of transmission fluid did it take buddy? Thank you
@nonamebrojones5545 Жыл бұрын
A couple of errors here. Didn't use a torque wrench. Didn't measure fluid and just kinda "winged it" which is not smart with a potentially SMOD transmission. Not super accurate, I would hate to have a service tech miss these obvious elements of the job that's actually a paid service.
@waypasthadenough 2 жыл бұрын
So if there's grease or oil on the outside there's probably a bad gasket?
@lesrinehart933 2 жыл бұрын
Good work
@armany3213 2 жыл бұрын
🔥🔥🔥🔥🔥🔥🔥🔥🔥
@genericdude6551 3 жыл бұрын
I guess I should take the fill plug back out and put teflon tape on it. But I haven't experienced any leaks.
@genericdude6551 3 жыл бұрын
My Xterra maintenance schedule says to replace the filter every 150,000 miles. So, I won't be taking my pan off anytime soon.
@genericdude6551 3 жыл бұрын
Since I don't have one of those hydraulic lifts to get my SUV high enough, I can't get enough leverage to remove the bolts. I'll have to invest in an impact tool to get the bolts off.
@georgealm27 3 жыл бұрын
Get a 3 ton jack and jack stands at harbor freight. I got a nice Daytona one for $150. You can also just buy ramps, hell you could also drive the fron wheels up onto a curb.
@michaele.6749 Жыл бұрын
To generate torque to remove it, you can put a pipe over the end of you socket subject to the room that you have. Torque is force times the length of the lever arm.
@sopar10 3 жыл бұрын
I have nissan Xterra But there is no dipstick a/t transmission , Do you have the part number? Or your VIN number so I can buy it, Thanks
@JMPWILLIAMS 3 жыл бұрын
A lil OD, drain and fill usually works for me !!! You did a great job 👍🏼
@waltersmith3165 4 жыл бұрын
Great video! Im gonna do this job for my dad's car
@HaenaKauai91 4 жыл бұрын
Pretty sure he shit his pants at 5:03
@jdunker31 Жыл бұрын
😅😅
@jackrock1313 4 жыл бұрын
What kind of transportation is Nissa using? Is it a cvt made by jacko?
@chris74ify 4 жыл бұрын
This a common method when doing a nissain xterra dealership transmission flush?
@nicholasrapose196 3 жыл бұрын
This is not a full flush it’s only a drain and fill which only removes about 60% of the fluid or so. Then you can drive around for a couple months or so and do it again and it’ll be about 80% fresh fluid. Then you can do it again and again until you’re satisfied. 2-3 total should be plenty for about 30k miles at the least
@bikeman1x11 3 жыл бұрын
Dont ever flush your trans if you want it to last drain and fill
@volodymyrbuchak1852 4 жыл бұрын
These 2WD Xterras going dirt cheap now a days
@bikeman1x11 3 жыл бұрын
who wants a 2wd suv- makes no sense
@khaledalghanim8247 4 жыл бұрын
How many liters
@iraqiiraqi6767 4 жыл бұрын
thank u soooo much for this informative video i follow u from iraq
@Razor_36 4 жыл бұрын
I have the same C200 diff in mine. I think I'm going to try 75w-140 that goes in the M226 xterra off road diffs
@paulwebber504 4 жыл бұрын
You should always measure the fluid when removing it. Much easier to refill.
@lorettacaputo6997 4 жыл бұрын
A good trick for gasket installation is to use Permatex gasket sealer on the matting surface of the pan. It is tacky and dries fast. Position the gasket on the pan, match up the holes and press in place. Once set you caninstall the pan without worry about gasket shifting during bolt reinstallation. Best trick for any gasket install. I coat only one side so any future removal will be easier with gasket only sticking to one side of the pan or pump.
@TheFastrider76 4 жыл бұрын
Hi there, only issue is the risk of having a small amount of sealing material intrusion into the transmission.
@BertCollins 4 жыл бұрын
Never ever use a sealer on your gasket.
@kolbietafoya1672 4 жыл бұрын
seems pretty straight forward. Plan on doing this around the 100k mark for my 2011 nissan xterra. Thanks dude!
@mikevaia5661 4 жыл бұрын
Great video! Simple language, I’m not mechanically inclined, but feel confident I can “get r done “. Got a kick out of the sped up part, and appreciated the honesty about forgetting the magnets.Anyone can make a mistake, not many people are willing to admit it. Thanks and good luck.
@tboone8680 5 жыл бұрын
What brand and part number for screen?
@emileHD 5 жыл бұрын
What did you end up doing about the silicone around the fill plug? Did you scrape it off? Did you reinstall the drain plug with the crushed gasket?
@thermobollocks 4 жыл бұрын
@@deberrydiagnostics4169 Dumb question since I just did mine, why would you prefer teflon tape over silicone? Is it just that the person who used silicone didn't clean up their work?
@mosesg.5359 5 жыл бұрын
Great video, detailed, direct and to the point. Except, that at the 4:50 minute portion, that sound threw me off a bit. Lol...