안녕하세요, [email protected] 로 연락주시면 더 도와드리겠습니다. 안부의 말,

Hello, you are reffering to PSI's for Hydroblasting. This unit can be configured with 40k psi of water pressure too. Because its a robotic platform, it can handle high pressures constantly compared to a human body. The setup displayed is for Abrasive (sand) Blasting. For sandblasting we advice a constant pressure above 100 PSI (AT THE NOZZLE). Every PSI above 100 at the nozzle results in a 1.5% performance increase. The same goes if the pressure at the nozzle gets below 100, than, you willl lose 1.5% performance per PSI, besides other increases of inefficient abrasive consumption.

Please get in touch at [email protected] and we will help you further.

Our crawlers are remotely controlled by an operator from a safe distance, the robots have 2 permanent magnet packs to ensure it can adhere to steel surfaces like ship hulls. Electric motors enable the crawler to drive in every direction on the surface.

What’s the psi? I blast with 40k shotgun

Good day, Please get in touch at [email protected] and we will help you out.

Hi Alan, Your work with the M7 has been incredible. Note that there are many V400's available at BlastOne Australia to facilitate your needs!

You can send your inquire to [email protected]

Good day! please get in touch by sending us an email at [email protected] or visit our website (www.vertidrive.com/vertidrive/) to leave a message and we will be in touch shortly.

$ price

Hello, in this video, UHP Waterjetting is used for the removal of the contamination. This machine only has UHP waterjetting capabilities. We do have other platforms that can perform HP washing, UHP waterjetting, and abrasive blasting interchangebly with medias that do not have magnetic properties as our solutions adhere to the surface through powerful permanent magnets, using an abrasive media with magnetic properties will eventualy cause the machine detaching from the surface. Check out our other platforms in case you wish to use copper slag, cleaning rust from a tank is an excellent use case for our solutions. Check it out: www.vertidrive.com/products/m7-series/

This person isn’t operating a dump valve, the pump used for this job is a small electric one that gets switched on and off at the pump itself. However, the signal going to the pump needed to build up pressure can come from our control box as well. The person in this video is checking/ observing if everything works properly at the start of the work while the pressure is at approx. 100 bar only.

With great coating adhesion comes perfect and consistent surface prep with a vertidrive unit

Hi Mahood, you can contact us via [email protected] or call us at +31 10 763 0200 and ask for the sales department