Great video! This weekend I am about to change the exhaust system of my MT07, what I am a bit worry is about the Exhaust Studs, I do not have a dynamometer, so I can't tight them up with the optimal pressure, so I need to do it manually, so my question is, should I give it like an inch or so after I feel the stud tight enough? I don't want to overtight them, but either have them very loosen...
@-mike922717 сағат бұрын
I can see how that will come in handy. And I suppose once “unlocked” the stud remover will be easy to remove from the stud.
@kwood11124 күн бұрын
Great video - thanks! You are one of the few who mentioned the adjustment at the engine too, which was key for me in getting mine sorted.
@motomecha53019 сағат бұрын
Glad it helped!
@bikehub70595 күн бұрын
Which fuel is used in your country
@mrcoconut92058 күн бұрын
I have a 86 Honda 450sc with tires from 05 still running them☠️
@motomecha53019 сағат бұрын
Nice!
@person.X.9 күн бұрын
Great video. Clear instructions and visuals of the procedure. I was completely bamboozled before I found your video! 😵💫 Thanks!!
@motomecha53019 сағат бұрын
Great to hear!
@fritsfelix84239 күн бұрын
Nice setup. Do you need a ECU flash for this exhaust?
@motomecha53019 сағат бұрын
Ya, that would be a good idea.
@jessicalee548710 күн бұрын
Thanks to you I didn't have to fork out $100 in labour fees. Although it took me a little more time than your video. May I ask what is the red jello you put on? Is it lube or some sort of anti rust? I put on some WD40 to remove the slight squeaky sound.
@paulspurlock59910 күн бұрын
Do I need a center stand too or can I just use the rear stand?
@motomecha53019 сағат бұрын
Just a rear stand works fine.
@saulparra461510 күн бұрын
10 out of 10 perfect.....😎
@motomecha53019 сағат бұрын
Thanks!
@albertjohnson630512 күн бұрын
And it only costs you an arm and a leg😂
@gustavoenriquez129912 күн бұрын
Simple, but very usefull. Thanks man.
@FernandoAcosta-dx5kh12 күн бұрын
I have been looking at that one myself price is not a factor I own A Mac and Milwaukee stubby 3/8 so it’s more of a thing to have then a thing I need
@BlackMountainCycles12 күн бұрын
*AND…* they make a great roach clip.
@FromTheHood2TheWoods13 күн бұрын
This crackhead put my chain too tight! I drove about 12 miles with it super tight. Do you think I caused any permanent damage? 2019 Kawasaki Versys 1000… just bought this damn bike can’t even enjoy it, all the motorcycle shops are too busy to work on it. Don’t wanna leave it there for two weeks. I’m out here in the Smoky Mountains. Just want to enjoy the summer! So aggravating.
@motomecha53019 сағат бұрын
I'd say do a proper adjustment and see. I'll bet it's ok.
@FromTheHood2TheWoods9 сағат бұрын
@@motomecha530 yea it was fine. I have a habit of catastrophizing every time something goes slightly wrong. It’s from growing up in a crazy household as a kid.
@rotbuster15 күн бұрын
should you replace both tires or you can do just rear tire when front is tire tread is still a bit thick? I have soft compound tires now on my mt07 and its not old tires yet
@motomecha53019 сағат бұрын
Ya, that's ok and common. A lot of times people go through two rear tires for one front tire.
@FREE_PUREBLOOD33317 күн бұрын
Simple pre ride checks would alert the rider to that. Poor maintenance..no excuse really.
@DogMania18 күн бұрын
Do you happen to have the links for both kits? Wanna do that for my 2015 700! Thanks so much! Love your channel!
@motomecha53019 сағат бұрын
I'm looking but I think I go it from an online seller from over seas. I'll keep looking...
@MT-09_SP19 күн бұрын
I apply some silicone lube around the fork tubes with cloth, then I compress the forks a couple of times which pushes the dirt out and wipe it off with dry cloth.
@DarksideSleemo19 күн бұрын
My poor rear tire is a slick and my front tire looks like a dry lake bed.
@slothmarathonpromotions247020 күн бұрын
After I had my front tire changed out I put my wheel back on and now when I hit the front brakes I get a pulsing feel like it grabs for a half second then lessens for a half second. Any idea what it could be? Maybe my brake pads aren’t set right?
@motomecha53019 сағат бұрын
Did one of the rotors get bent somehow?
@slothmarathonpromotions247014 сағат бұрын
@@motomecha530 that’s what I’m wondering maybe they bent the rotor or dropped the rim when they were changing the tire. I’m going to have to take it back off and have a look at it all. You are San Diego based correct? I’m in La Mesa.
@chaziztheman21 күн бұрын
Anyone else have an issue where the midpipe fits too loose on the y/splitter? It’s not on backwards, everything lines up properly but no matter how tight I get that clamp the midpipe is loose on the splitter. Far too loose for provided firegum/rtv to make up for the gap. Worried I might’ve got a wrong/defective part
@motomecha53019 сағат бұрын
hmm, take pictures and contact the manufacturer. sounds like its missing a gasket.
@Wtfinc22 күн бұрын
No more running lose chains
@JordanEmede_37622 күн бұрын
Whole new motor...or just the clutch cover 😂
@mcmuphin22 күн бұрын
That's what I was thinking, those cases can be replaced
@non-wx8qm22 күн бұрын
What kind of bike is it?
@zachmetcalf389222 күн бұрын
Cracked the case on my 400ex. I run a chain saver now.
@Fomogarage22 күн бұрын
It looks like the links of the chain further down are kinked up to like it has not been properly lubricated and cleaned either.
@kawiman291622 күн бұрын
They're not called "case savers" for nothing.
@Goat-_-60922 күн бұрын
My bike just did the same thing
@Massacheefa24 күн бұрын
How did you remove the pin that comes stuck under the footpeg I always scrape in the twistys
@motomecha53018 күн бұрын
it should unscrew
@Massacheefa18 күн бұрын
@@motomecha530 I tried unscrewing it but I couldn’t get it off it’s on there pretty good 😂😂
@DieselTechJess25 күн бұрын
Milwaukee all day in power tools
@sleepyrasta1482027 күн бұрын
My bolt that attaches it to the frame is completely rusted its like the bolt and the threads on the frame have rusted together
@chadhamann831527 күн бұрын
Can you use this style on 530 chain? I'm not sure what size chain you were working with in this video.
@ashtonwakkinen98742 күн бұрын
Most big bikes are 530
@brandnamejessx536128 күн бұрын
The larger diameter o ring that is thinner, what does it go to? I notice you didn't use it. Is it for a different setup? Perhaps the o ring it replaced wasn't bad and so you just didn't put the new one in? I can't find any information from they who sell the rebuild kits, as to what the parts are to where they go. Awesome video! Very helpful, Thank you so much.
@bag_full_of_scrubs77029 күн бұрын
Awesome dude! Congrats on the upgrade!
@himanshugautam5235Ай бұрын
Will more clutch freeplay reduce mileage?
@joeheadley6024Ай бұрын
Sorry to say someone gave me a set. The didn’t last 6 months. Floppy
@Lil.D3BАй бұрын
Hi, I just got my ninja 400. Is there any other maintenance I should look for besides oil changes, and cleaning of the chain
@kakodaimon_4 күн бұрын
1. Make sure your chain tension or slack is in spec every time you clean and lube your chain. Correct spec should be written in the bike's manual, and adjust when needed. 2. Spark plug condition and gap should be checked. Correct gap and service intervals are in the manual. 3. Air filter must be cleaned and replaced when needed. Check manual. There are many other maintenance items for any bike. Read the owner's manual.
@loredanatafuro7826Ай бұрын
1,6 mm mindest Profiltiefe.
@kenchristopher5479Ай бұрын
I would like to see a dino before and after.
@trynagetredpilled7941Ай бұрын
I have a 2012 fz8 that i dropped need new but cant figure out how to replace pegs
@robertsebastian787Ай бұрын
My owners manual says 10 years
@motomecha53019 сағат бұрын
Hmm, interesting. What bike?
@robertsebastian78712 сағат бұрын
@@motomecha530 2022 Honda Shadow VT750
@billystuart2184Ай бұрын
Do you have to take the tank off
@TheKringer00Ай бұрын
absolutely not, it just makes it a little easier but not worth it in my opinion...mechanics like to do a lot of "extra work" just for the actual job to be even slightly easier cause they can bill the "extra work" from the customer...
@motomecha53019 сағат бұрын
not necessarily, tho it only takes about 2. minutes to remove the tank, making my job way easier.
@roadwarrior8560Ай бұрын
It's amazing all the money we spend on gear and the thought that goes into buying tires but we never even think of suspension.
@mattb6646Ай бұрын
Just changed my back tire this afternoon... what a lovely pain in the ass it was
@JohnnieVАй бұрын
Do conventional motorcycles have 100k mile lifespan? Or is this number over zealous? I mean just with regular oil changes.
@motomecha53019 сағат бұрын
I believe any bike can last 100k with proper maintenance and not redlining the bike everywhere like and idiot.