Its a powerful drone, no doubt. I still think due to how fully encased the ducts on this frame are that it is rather slow in regards to chasing. I would look at the catalyst machine works whoopmaster

.73 super and .40 expo. 741*

Emu skylion 3.5" preset!

Same.. No one is sharing pid tuning tho :(

@@guatemalamini sorry man I missed this comment! This is actually a preset skylion made me on emuflight. It's the 3.5" preset.

Check your filter adn pid tuning

@@guatemalamini any suggestions on these? I’m using inav

I have this same issue. I've heard it's the tune you have on the quad

Try the emu 3.5" preset!

Yep!

Me and my girl used to go up there, to the waterfall. It's been a long time.

These motors are great but any 2306 should work about the same

I have this one about 3 days. I need to know too 😂😂

No throttle limit needed! These are only 3.5" props so the high kv is necessary to get it to fly like this. My motors stay nice and cool and I have 4-6minute flights on a 6s 1550mah. You can even try my tune on Emuflight if you'd like! It's the skylion 3.5" 6s preset. Thanks!!

@@makomultimedia I'm putting together a Terraplane right now. Just can't figure out the motors. I couldn't figure out if the 2500kv recommendation was for 6s or 4s. I was thinking even though they're 3.5" props, since 6 blade props are normally used, 2500kv was probably 4s. Now I'm even more confused haha

@@opossumfpv so you definitely wanna use 2500kv with 6s on this build. Even with the 6 blades 4s just isn't quite enough power

@@opossumfpv This drone uses 89mm props. ~2500KV is a good 6S KV as the props need to spin faster to make the right proportional thrust. 2500KV 6S would be too much on 5", but for anything between 3-4" it will be fine. 2500KV 6S will also be too low for smaller props like 2", so you'll see 2" prop motors will have a very high KV. There is a lot more to it, but basically you need to look at how much thrust you want (in grams), then look at how fast you need to spin the prop you will be using to make that much thrust, and then you you select the stator size and KV to get the propeller to that speed.

Sorry for the late response. 30x30 but it fits both!

shendrones.myshopify.com/products/geyser

@@makomultimedia thx

are you using the dji for the radio link too?

@@makomultimedia yes i have dji radio can i conect ?

twitchiness is definitely due to servo choice so that metal gear will make a big difference

I use a connecting rod from an RC plane. Wish I could post a pic of it.

Cheater quad sir

Thanks. Was away from the hobby for a year. Now I gotta try this.

Yes

@@makomultimedia NIce. Do you real-steady afterwards to smooth it out? It seems very smooth. More-so than I would expect.

@@fpvclub7256 nope just hypersmooth

Yeah I have it on a switch in betaflight and have position set to one of my sliders as well. I need to make an updated video!

@@makomultimedia dude you're the man!!! exactly what I'm lookin for, I'm ready for that updated video pleeease :)

@@makomultimedia I'd also like to see an updated video! Are you saying that you can use both the gyro and a pot/slider? So you can adjust the tilt with your transmitter?

www.thingiverse.com/thing:3612802