Indeed😅

I believe they have the same transmission, the 6f35, maybe this solution might work for you.

@@luenyoni6603 Thanks bro my mechanic said that's the same thing that needs to be changed. I will take it Thursday.

No problem, best of luck!

What would you like me to fix exactly?

I sped up the video, I think 😂

😅Thank you!

About a week, I took my time with it. I’m sure it can be done a lot faster

Hi, sorry for the late response, I did the repair in spring of 2021. Nope, I didn’t have to do any reprogramming or flashing of the computer, just disconnected the battery before I started working on the car, no issues for me so far

@@luenyoni6603 love it! Thanks

Thanks man , I did not add any loctite onto the bushing if that was the question. I didn’t see any one else doing it in my research, I might be wrong though

@@luenyoni6603 there is a tbs that says it needed for the repair, check it out it's Ford tbs 16-0043, also check makuloco video again to see it. Another question, how is the vehicle doing now? Any leaks? How long has it been since the repair?

@@justlg3359 Hey, sorry for the late response but I'll look into the loctite requirement. It's been almost a year since I did the repair and no leaks yet and I'm a delivery driver so I put a lot of miles into it.

@@justlg3359 You're absolute correct, I rematch the video and he put loctite on it, mine seems to fine so far without, hopefully it holds.

@@luenyoni6603 I did the exact repairs with the help of a mechanic, and I use the loctite 648, that loctite is to hold it in place so it doesn't move. Mines is good too. Also does your escape have bad idle vibrations at idle while AC is on? Also when u did a drain and fill of the trans how much did u add in?

Good tip! Thanks

Thank you!

Thank you very much

Yeah, I think I remember a rubber/foam like material

@@luenyoni6603 it’s actually the torque converter bolt cover, did you remove that at all? And if you did was there fluid behind it?

@@Swamprunner92 Hi, I didn’t replace mine, I think it was a bit torn up too, but I don’t remember it having any fluid

Thank you very much🙏🏿, amazing that you were able to do such a big job at that age and time👏🏿, a lot of the resources I had may not have been available then

Ooh man, that sucks. I’m not experienced enough to know how the shifter cable could be causing gear slippage. Check your transmission fluid make sure they didn’t mess with that. I would take it back them

Hi, thank you Sorry to hear about your installation troubles but I’m honestly not too sure if the installation tool is necessary, my part came with it and I figured I should use it😅

If you get another part and it doesn’t come with installation tool, I would add some threadlocker and torque it good

Yep, still driving it, I use it for delivery and that repair is holding up

Hi, luckily for me, in the 2.5l four cylinder you don't need to remove the exhaust to get the transmission out.

I'm not too sure about the V6 but if you have to, apply some heat and have a drill in case they break off, good luck 👍🏿

It's very similar, especially if you have the 4 cylinder. I used repair manuals for the 2008 versions on this 09

Hi, thank you, I found a free repair manual for the 2008 escape (close enough to the 2009)on the internet, very sketchy websites though, I can't find them at the moment. I can send the PDF if you'd like.

Thank you🙏🏾

Yeah😅

I think it works fine, nothing has come loose yet 🤞🏿

Thank you very much 🙏🏾 I appreciate that

Wow amazing unbeliveable

Hi, so unfortunately the 09 to 20012 escapes, the fuel filter is apparently integrated in the fuel tank/fuel pump. So not really serviceable unless you replace the whole thing

If you look under the rear passenger seat you should find an access port for the fuel tank. I believe it's integrated with the pump, so you'll need to replace the whole unit.

It’s integrated inside the gas tank, it’s really hard, I recommend just putting injector cleaner in your tank every time you fill up, unless it’s necessary to do now