@@dino11216 I would say I drained approximately half of a quart from the old cooler. I then laid the new cooler flat with the fittings slightly inclined and slowly added the fluid to the new cooler before I installed it back into the jeep. If you get the denso unit, double check the new fittings because the ones provided on mine did not fit the OEM lines. I had to swap the old fittings onto the new cooler.

So I used a set of turbo headers that I had to modify. There is a cross over pipe going across the top of the engine. I relocated the coils to each side of the throttle body. The pipes from each bank are 2.5” and merge into a 3” out the back just under the alternator. My computer is down right now but hopefully I can get the other vids posted showing the completion and the exhaust.

Haha!! It bugs me too! And it’s not left handed either 😂 i need to go to the bolt store and get one

I’m still learning the camera and editing stuff that’s for sure. Now I just need to figure out if shorter or longer vids are better

@@Left-HandThreads I would say compress it. That's just me though. Other audiences will have more impact than me. I did like the trans tunnel angle!

Im almost too old to do all the climbing!! but i still have the 6.7 to work on too

I’m a little slow at editing but I’ll be dropping a lot more soon.

Haha!! The mysterious vanishing 10mm!!