Жыл бұрын
Пікірлер
@MrCaptainSisko 7 сағат бұрын
Was thinking hard about going there instead of the DMZ at the other end of Korea and the Dora observatory cause of its remote and quietness and the East Sea/Sea of Japan at the end of it. What is the backstory as to why and how that Korean tourist got shot back in 2008?
@Mr572u 10 сағат бұрын
Why not just put a half inch ratchet in your tool pouch, and leave it.
@MTBPlanB 9 сағат бұрын
I did that.
@youngboone1 Күн бұрын
Do you think this will work on a 2020 transit? Thanks
@MTBPlanB 19 сағат бұрын
That’s a good question but I don’t have experience with that gen of vehicle. Maybe someone else can chime in below and verify.
@JoshHall-r4y 2 күн бұрын
I cannot seem to “repeat the same procedure” on the tank side panel. The sliding tank lock and the tank valve do not allow me to push the panel forward like I did on the side opposite of the tank. Do you have any extra tips or videos on removing the side panel on the tank side?
@sigmaman721 2 күн бұрын
Gosh.. You've just dismantled the whole thing down. Didn't You try to clean the pipes first ?
@MTBPlanB 2 күн бұрын
Yes cleaned everything that was possible, but since it was entirely blocked, couldn’t run de scalar through the system.
@sigmaman721 2 күн бұрын
@@MTBPlanB I got the same issue with little DeLonghi but it's gonna take me the whole day to do that job 🙃
@spoole96 6 күн бұрын
Did that fix the humming noise?
@MTBPlanB 5 күн бұрын
Yes. The fan was making the noise.
@spoole96 5 күн бұрын
Thank you for the great video and response. I feel confident that my GE Cafe has the same issue. Just need to prove it like you described and then fix it. Thanks again.
@MTBPlanB 5 күн бұрын
Very common problem.
@AWB69420 8 күн бұрын
could've been 8:02 mins shorter
@deags6664 11 күн бұрын
I have a 2T Beta 300rr I’m about to go take my test with 😅
@MTBPlanB 11 күн бұрын
Nice and good luck!
@imanidiot4193 13 күн бұрын
Any idea what the distance between the cones is?
@MTBPlanB 11 күн бұрын
12ft. I practiced with 10ft.
@CyrusSassanid 14 күн бұрын
Do you think one can change the evap temp sensor on these without pulling the dash?
@MTBPlanB 11 күн бұрын
Not really. That sensor is also part of the climate control housing. The recommended procedure is to swap over everything to new climate control housing.
@quintaviusnelson9742 15 күн бұрын
Man this was a great solution seriously my screw was stripped..
@2006steel2006 21 күн бұрын
Cool 😎 Thank you 🥰
@pepegarduno 24 күн бұрын
How change the Blower transit 2015
@MTBPlanB 24 күн бұрын
On my 2019, There is an access panel directly under the glove box. Remove those screws to access and remove the blower motor.
@RONALDGreene-ur3oq 26 күн бұрын
Been nice if he'd had shared what the hell he was doing, what he was using and ultimate plans... sorry, worthless to me
@MartinGulich 29 күн бұрын
Great description, thanks you very much :) Any tips for what to check when AC is working fine and cold air is coming 16:26 on passenger side and in the rear but not in the front and at the driver’s seat (just air)? It’s a 2017 Ford Transit “Tourneo”.
@williamjones3603 Ай бұрын
You should finish all of your videos the same as this one. So funny 👍
@user-je7hp5kd3m Ай бұрын
Some have 2 torque screws to remove the signal assembly. Sorry don't know what size that is but it's very small.
@ryanbradley3855 Ай бұрын
Was the module the you installed factory?
@MTBPlanB Ай бұрын
Yes Ford OEM tow module and wiring harnesses.
@ryanbradley3855 Ай бұрын
@@MTBPlanB I have some questions for you. Is there a way I can contact you? I'm trying to get a customers transit trailer wiring to work
@MTBPlanB Ай бұрын
@ryanbradley3855 Here or FB messenger.
@LiveLoveCHXBeach Ай бұрын
Appreciate this upload. Able to gather what I needed prior. Purchased $14 Amazon RLB-Hilon seller cover. I used a wooden flat spatula to pry the bottom mirror off. Easy to follow process.
@LiveLoveCHXBeach Ай бұрын
Oh and I didn't remove the heater wires. I laid the mirror in the mirror wing hole. Was concerned I F that part up
@gruntlife0341 Ай бұрын
Thank you for the video. You just saved me about a hundred bucks!
@michaelcolbert5797 Ай бұрын
Love the wheel color! Did you torque the lug nuts to spec? Didn’t see that in the vid…
@MTBPlanB Ай бұрын
Only wish I had put two more coats of clear coat. I torqued offline.
@colewilliams7941 Ай бұрын
I just got my permit a week ago and was looking for a video like this! Thanks for the info🤙 just got my first bike since I was 13, its a 2021 klx 230
@MTBPlanB Ай бұрын
Glad you’re back on a bike! Enjoy.
@jovanygomez2043 Ай бұрын
Thank you for sharing this video. I learned a lot by watching you fixing your GE refrigerator.
@youngdoan3465 2 ай бұрын
There is no froth on my coffee one touch. How can I fix it? Thanks
@stefanoreghenzani1904 2 ай бұрын
I'm doing this upgrade right now on my son's Oset 12,5r...from 2x SLA lead acid 12v 10Ah batteries (in series, so 24v total) to 2x LiPo 6s 7000Ah (in parallel, so 14Ah in total). I will use exactly your configuration with the harness (to use also SLA batteries if needed), XT90 connectors and 10awg wire. Thanks a lot for your guide.
@MTBPlanB 2 ай бұрын
Awesome, he will enjoy the additional run time and power delivery!
@ronscopes 2 ай бұрын
I did my own test without a pressure sprayer. I used Mold Armor concrete formula and I actually waited 10 to 30 minutes and it worked a lot better than LAs Totally Awesome that I sprayed at 5-1 concentration and over a period of 35 minutes scrubbed the surface repeatedly with a brush broom in 90 degree directions 6 to 10 times. LAs doesn't seem to be able to eat away at the mold like Mold Armor does.
@MTBPlanB 2 ай бұрын
That’s good information. I will try this next time.
@wallyo7777 2 ай бұрын
I got the same refrigerator but my water button doesn't switch over to it, so I can't get water. Any idea?
@MTBPlanB 2 ай бұрын
So it won’t brew coffee either? That would help narrow down if water is coming into the fridge vs being an electrical panel/button issue on the fridge.
@danieljewell285 2 ай бұрын
So did the sensor replacement take care of the ac issue?
@MTBPlanB 2 ай бұрын
Yes it resolved half of the issue. The other half was the evaporator was freezing over.
@gregoryaparker 2 ай бұрын
Right babe... yeeaahh ...lol. That's a nice car you have. I'm glad to have helped building it :D
@matthewthomas8156 2 ай бұрын
Thanks for this saved me a fortune on a new shock
@philipsayre7668 3 ай бұрын
I’ve got a 2018 250. Air works pretty good upon start up but after an hour or so, air slows to a trickle out the vents. Replaced the blower motor. But nothings changed. Any ideas?
@MTBPlanB 3 ай бұрын
Does it exhibit the same behavior with heat or vent fan with no a/c?
@philipsayre7668 3 ай бұрын
@@MTBPlanB I honestly haven’t tried heat yet. But I may have commented too soon in the video. After watching to the end, I think it may be the evaporator? The AC does make a louder hum from the engine bay when it’s on too. Like the fan but louder than normal
@christinejustme3521 3 ай бұрын
I have an 8E1 error code. However I replaced the vibration sensor and I’m still getting an 8E1 error code. I’m about to lose my mind!!! It’s been down for 5 months now. 🥴😵💫🤦🏻♀️ 🤯🤬😭 I replace the bearings and seal, the spider arm is in great condition I replaced the shocks, and now I’m still getting the 8E1 error code. Please if anyone can help I would be so grateful! 😊 Thank you Samsung WF56H9100ag/a2-00
@jeurycisneros17 3 ай бұрын
How do you replace the front silver engine mount with the subframe in the way of the bolt ? Thank you
@sirredofx587 3 ай бұрын
Im trying to remove the water filter side, however it is not detatching. Any tips?
@reparalbas.l.albacete1505 4 ай бұрын
Thank you very much ""AMIGO"" , the video was great for me, thanks for your help, greetings from Spain
@MTBPlanB 4 ай бұрын
Glad it helped!
@mikebishop6095 4 ай бұрын
You make great content
@MTBPlanB 4 ай бұрын
Thanks!
@mikebishop6095 4 ай бұрын
And could t you use that 7100 in your tranny as well as
@mikebishop6095 4 ай бұрын
What engine oil did you use
@MTBPlanB 4 ай бұрын
I use Motul or Liquimoly 10w50
@StephenHerman-zi9cb 3 ай бұрын
i got liquimoly off amazon $60 for 4 liters
@StephenHerman-zi9cb 3 ай бұрын
did you re torque the head bolts at the first service? i havent got a straight answer from anyone yet . the manual says to tighten them at 3 hrs
@YOURBOYJAIME 4 ай бұрын
Why did you remove that green plastic part under gas cap ?
@MTBPlanB 4 ай бұрын
It eventually will fall into your gas tank and likely cause another problem and you’ll have to fish it out. I just replaced it with an external check valve.
@YOURBOYJAIME 4 ай бұрын
@@MTBPlanB thank you
@Al_W_On_The_Trackz 4 ай бұрын
Great video! This is an awesome reference for maintenance.
@Wicker888 4 ай бұрын
I keep getting p0662 can't figure it out
@MTBPlanB 4 ай бұрын
Check the intake runner control valve sensor.
@Wicker888 4 ай бұрын
Yeah I have both in Conjuction. P1077 and P0662
@Wicker888 4 ай бұрын
@@MTBPlanBwhat did you use the vacuum for?
@MarioALopez-wt2yu 4 ай бұрын
Thanks 🙏🏻
@bonitabromeliads 4 ай бұрын
is this legal?
@raymondsiewert2720 4 ай бұрын
Nice simple video 😊. Man the oil didn't look bad at all.... especially the tranny oil .
@t-reva151 4 ай бұрын
Did updating tire size change when transmission shifts? Thanks
@MTBPlanB 4 ай бұрын
I didn’t verify but don’t think so. I did however reset the tcm for the adaptability relearn for my driving habits. Couldn’t really tell a difference.
@RAZIAR 5 ай бұрын
Why don't just use the google wifi mesh in access point mode , disable the wireless in the original fiber box and still use it as the primary router ?
@MTBPlanB 4 ай бұрын
That box needed a reboot every month. Straight into Google Wi-Fi puck has been more stable with zero reboots needed so far.
@user-zc8nf7bi5q 5 ай бұрын
Going from 235/65/16 to 245/75/16 @ 70mph on speedometer your actual speed will be 76mph. I believe ford locked out the calibration in the software to make the change in 2014 for transits. So i went with 225/75r16 and its 3mph off at 70mph (73mph actual)
@douglascushing9199 5 ай бұрын
have same exact fridge with same exact problems they just don't make'm like they used to...😢😢
@MTBPlanB 5 ай бұрын
You got that right!
@douglascushing9199 5 ай бұрын
Nice helpful video
@Danpungip 5 ай бұрын
thank you for the clickbait