The damper pedal of my CLP-330 doesn't completely cancel the damping effect when I release it. Is there any fix to it? If there is any, please let me know.
ใช้ แบตเตอรรี่ 3.7 v รหัส 361-00086-00 ได้เหรอครับ เห็นของเดิมใช้ 3.8 v รหัส 361-00086-10
@NOPPADOLSUD24 күн бұрын
ได้ครับ
@nawatninpluek219222 күн бұрын
@@NOPPADOLSUD
@ChrisMetropolisАй бұрын
I'm curious if all the cells could be replaced with 50S - would the charging and operation still work? Thank you!
@NOPPADOLSUD29 күн бұрын
No need to replace all cells. Since I have replaced the dead cells, the unicycle still works and charges normally.
@ChrisMetropolis29 күн бұрын
@@NOPPADOLSUD Oh for sure in your case! I'm fantasizing about having all 50S batteries in my V10F! Since 50S are a different spec battery from the original, do you think they would work with the existing BMS and charger? Thank you!!
@ChrisMetropolis28 күн бұрын
Actually, my brain wasn't working, as I actually know the 50s is a different size and wouldn't fit! Duh
@NOPPADOLSUD25 күн бұрын
All battery cells should be the same spec and better to be the same brand.
@medialcanthus9681Ай бұрын
Ice tray dropped out . I pushed it back up many times but dropped again and again. Your video showed the tray can turn upside down, so it means there must be a hole and the tray must have projecting part. I fitted that back into the hole. Now all okay. Thank you so much for your video.❤
@juthathronngooycharern4313Ай бұрын
ขอบคุณมากนะครับ วันนี้อาการแบบนี้เลยครับ
@mauricerobillard612Ай бұрын
Thanks for this video. I have a full 500 liter tank. When i turn on the water supply, the pressure switch keeps turning on and off at a rapid rate until the demand for the water supply is turned off. Is this normal the pressure switch works this much to keep up pressure??
@NOPPADOLSUDАй бұрын
Your pressure switch works abnormally. Normally, a pressure switch is set as standard pressure value. In your case it indicated that the pressure valve of the switch is reduced so you need to adjust to increase the pressure valve.
@mauricerobillard612Ай бұрын
@NOPPADOLSUD thank you for your reply. Turns out the pressure switch is fine. The problem was that the bladder of the holding tank was too full and could hold enough pressure. . I drained the tank and restarted the pump. The system is working normally now. But thanks for trying to help.
Types of waterproof glue, what materials, where it is made and brand names?
@yodmedaychar60342 ай бұрын
เยี่ยมมากของผมกำลังมีปัญา.ค้างไม่ลง..ต้องลองทำดู
@paes74782 ай бұрын
NO PIERDES LA RESISTENTE AL AGUA ???
@NOPPADOLSUD2 ай бұрын
Apply sealant.
@faridouanes16632 ай бұрын
Hi can you help me please. My V10f doesn't want to switch on. I can charge and she switch on but when i unplug the v10f its switch off automatically. Thanks for your help
@NOPPADOLSUD2 ай бұрын
Some battery cells have dead and need to be replaced. See this video kzbin.info/www/bejne/faKQfYeZnJ6so7c
@bariskahraman962 ай бұрын
Hello, i have yamaha clp 625 piano and sustain pedal not working. Actually, some times working but when i change the pedal the notes get longer. What should i do ?
Hard or No Start: ค่อยๆ เข็คตามนี้ครับ battery, alternator, mass air flow sensor, coolant temperature sensor, fuel pump, injector circuit, ignition circuit, idle air control valve circuit, immobilizer system, crankshaft position sensor.
Silly old man. I scrolled down reading other viewers, and I believe I will try it.😆
@calvinatwood53763 ай бұрын
Good morning. Thank you for your video. This morning, I installed a new Mitsubishi WP255R. The new pump is turns on every 30 seconds and runs for 2 seconds. I cannot find instructions in English. Would this be the correct adjustment as well? Calvin Atwood, Phitsanulok
@NOPPADOLSUD3 ай бұрын
Yes, you can follow the video procedures.
@matheusfilipe64283 ай бұрын
HI My V10F suddenly stopped self balancing, it's as if the handle kill switch is engaged. I also noticed that the headlight won't turn on. I've ran diagnostics and everything comes up fine. I've tried all the troubleshooting tips like toggling transportation mode and handle mode on and off. There was no physical damage and it hasn't gotten wet. Is there a way to do a hard "reset" or something?
@NOPPADOLSUD3 ай бұрын
There isn’t a hard reset. I think the battery (some cells) should be replaced as my case.
@matheusfilipe64283 ай бұрын
@@NOPPADOLSUD I understand, but it turns on normally and all the diagnoses are showing as positive in the application, this happened twice and I managed to fix it and walked normally, but now it happened again.
@NOPPADOLSUD3 ай бұрын
I think that the diagnoses in app can’t check the batteries.