@@DavidBarkes Pretty good my friend, somehow tripped over your post, what a surprise! Given the age of the posts I was not sure if you monitored!
@Mikemitchell-uf6yyАй бұрын
How do we connect via PM on youtube?
@DavidBarkesАй бұрын
@@Mikemitchell-uf6yy I don't know if you can. FaceBook? Are you on any other platforms?
@Dot_CompositionsАй бұрын
I was so close to doing this - bought a used 2001 - stutters a bit when simi low on fuel.. long story short.. I dropped the fuel tank only to find a hole where there previous owner did this exact thing. lmao
@DavidBarkesАй бұрын
LMAO!!!!
@llnnie2 ай бұрын
I’m dying laughing at this
@naelair4 ай бұрын
Thank you.
@theportraitrealityshow66298 ай бұрын
He has really matured since i saw him on high school musical
@kervinrodriguez13019 ай бұрын
Wanna get a measuring tape instead of guessing
@habibkooljab11 ай бұрын
We watched your video and just finished cutting the hole to remove the fuel pump, great video thank you so much!!
@geethadorairaj3492 Жыл бұрын
Take it out!!!
@monotheis6889 Жыл бұрын
After watching the video, and reading the comments, I'm just going to cut out a much larger section to have total access to everything below. Some hinges, a gasket and some flanges welded in will work nicely. I have a 2000, AND 2002 Windstars. Thank you for finding out where to start, tho. I looked underneath at the tank and almost torched the whole van just to be done with it... 😂
@mitchweber7868 Жыл бұрын
I just followed this on my Windstar today. Only reason I did it is because I could care less about the carpet and I didn't even remove the carpet, I just cut sections out that will be filled with something else later and covered with something. I think it's worth it because I've seen a lot of guys cut holes in the floor to remove fuel pumps. The only thing I would tell you to watch out for is you're probably going to have to cut a little channel past where you cut the square hole to give the wire harness enough room to wiggle out of there because I knew I didn't want to cut that harness like he did and rewire it. I don't know why, I just don't want to do that lol. So I cut the s*** out of my floor and I cut the s*** out of my carpet because I could care less about this van. I'm just mad that they charged me $10 extra dollars for a total of $25 on Amazon to get the pump here in two days.
@quevicular Жыл бұрын
I wouldnt weld too much, you may catch on fire. Maybe spot it in a few places then spooge on some slicko flex
@quevicular Жыл бұрын
I Like it a loooooot. Tired of getting under vehicles to work on them My 2000 rear REM pooched because the thing got soaked and fried out because the rear window leaks down on top of it, so if you guys have problems with a variety of blown fuses happening, well this thing dead shorts and causes all sorts of problems. Vehicle will crank but wont start and various crap on the dash wont light up and no door locks and and and.
@CurlyQLink2 жыл бұрын
I have the exact same 2001 Windstar SEL. (P.O.S.). I bought this vehicle brand new and it has been, hands-down, the WORST vehicle (34 total) that I have owned. I will NEVER EVER buy another FORD. They are $HIT.
@chrishampton59152 жыл бұрын
Thanks brother, I was just figuring out that there wasn't a access panel to get to it. Right on man and thank you
@karlitoswwe2 жыл бұрын
biancas sewing machine after making her elimination chamber gear :
@AbdulWahid-xn2mt2 жыл бұрын
How is this made
@guiruffini2 жыл бұрын
Man, this version is unbelievable.
@jagerzaku91602 жыл бұрын
What is this
@DavidBarkes2 жыл бұрын
Proof of concept for a "gag" for a children's TV show.
@jmitch67642 жыл бұрын
Good for you. I hope you have learned to stay away from Ford Windstars . I could share many lessons.
@Arunkumar-ex6yt3 жыл бұрын
After seeing cinerella(2021) I'm here
@autisticpressurewasher74043 жыл бұрын
Is it the same for a 1996
@aver7973 жыл бұрын
more bullshit from a cop
@lorriepriddle86043 жыл бұрын
Loved his version of A case of you!
@JL-rt5iv3 жыл бұрын
What is the reason?
@DavidBarkes3 жыл бұрын
Rough proof of concept test footage for Children's TV show.
@JL-rt5iv3 жыл бұрын
@@DavidBarkes But why it was exploded?
@DavidBarkes3 жыл бұрын
@@JL-rt5iv I made it explode. The script called for it to explode. This is a test of me making it explode.
@JL-rt5iv3 жыл бұрын
@@DavidBarkes Thank you! I asked because the capacitor of my sewing machine exploded.
@Kimchi-cy1qj2 жыл бұрын
@@JL-rt5iv what happen when it exploded? My sewing machine smell like something is burning, and now I'm scared to use it T^T
@iceyu22353 жыл бұрын
This is exactly the alternative I was looking for! My car's rusty straps and bolts really appreciate being left alone! Thank you!
@harryw39103 жыл бұрын
Which well back seat?
@DavidBarkes3 жыл бұрын
Hello. I think if you use the raised rib pattern and the black cable wire guide you should be able to locate were this is in the vehicle if you remove the carpet. It is the forward seat I believe, It was a long time ago,
@harryw39103 жыл бұрын
Hello using you idea but having a hard time locating where to cut
@eztomcat3 жыл бұрын
The CBC radio version is a skipping incomplete version.
@casualna54773 жыл бұрын
Do not listen to this man. Just drop the tank. It is easier than it sounds.
@DavidBarkes3 жыл бұрын
Do you see the moss growing on my hunk of shit 2001 Ford Windstar at the beginning of the video (Ford badge)??? Winter time, no place to jack it up on jack stands, over 50 years old, rusted underside, raining. Drop the tank on a $500 Windstar? Pfft.
@casualna54773 жыл бұрын
@@DavidBarkes you seem like you know what you are doing and this worked fine for you. But to someone with minimal knowledge this can be very misleading and dangerous if done wrong. The fuel tank to this van is held up by 4 supports bolted with 13mm bolts. It just seem like the safer and easier route is all.
@paulbrownman73073 жыл бұрын
I'm with you sir. This particular video was a waste of my time
@dennisbaut8873 жыл бұрын
David..i have a 1998 windstar with what i think is an intermittent fuel pump problem. Sometime the car will not start unless i cycle the ignition on and off a couple of times. Then it runs great..high speed, pass gear..no hickups. Fuel filter ok. Not a spark problem or injector problem. Before i cut a hole...where is the fuel pump relay located so i can check that? When i turn the key on but before the starter i can hear the hum from the pump. It starts then quits in about 3 seconds. Coming up to pressure. Appreciate any words of wisdom..thanks
@DavidBarkes3 жыл бұрын
Hello Dennis. I am sorry that I do not know the location of the relay and I no longer have the old windstar. Nor am I a mechanic. I do think that you are correct trying to find something other than the fuel pump however. If the pump itself runs and comes up to pressure sometimes, I think that the problem may lie elsewhere. Sorry I do not have a better answer for you. good Luck.
@dennisbaut8873 жыл бұрын
@@DavidBarkes thank you..i'll keep you in the loop
@FishOnIsMyHandle2 жыл бұрын
@@dennisbaut887 Hi Dennis - what resolved it? Ours is doing the exact same thing, Thanks for any help !
@tuxnoel3 жыл бұрын
These ads are made by manual hacksaw manufacturers
@michaelbruns4734 жыл бұрын
Thanx! Your hack works perfecly ! Saved a lot of work.
@ducks_love_bread4 жыл бұрын
Is this the same on a 98?
@DavidBarkes4 жыл бұрын
Sorry I do not know anything about other years. Perhaps someone else will comment.
@CaspianWint4 жыл бұрын
The pigs sure put emphasis on “brain injury”, that’s a violation of his privacy rights
@veganvocalist47824 жыл бұрын
🤣😂 his laughing set me off
@veganvocalist47824 жыл бұрын
Well done guys 😃 was holding my breath while you did it lol 😂 your so kind 🙏♥️🕊
@rotorway1334 жыл бұрын
Any code available ? My 2 first lines repeat on the last 2 lines. Where did you get the 40x4 library ?
@DavidBarkes4 жыл бұрын
Hey Eric. Alas, I do not have the code or library any longer. 7 years ago when I posted this video I would have been able to help, but my computer files no longer and my memory is of this project is nearly non-existent. Sorry I can not help you out. :-(
@WrenchBurner4 жыл бұрын
what the fuck is this real
@mike70448634 жыл бұрын
Ive dropped the tank in the middle of winter out in the street soak and wet and cold .......Its not that much to do if you have an almost empty tank its much easier . . Also , drop tank from passenger side leaving filler tube connected and you still have room to get in there and do the job .
@rickyabarez71144 жыл бұрын
Excelente pero debió ganar jaquie le
4 жыл бұрын
He's so hot. 🔥🤤
@jewelm39605 жыл бұрын
You did WAY more work than it would take to drop the tank! Not to mention cutting a hole in your floor for something you'll probably never need to replace again! What a waste of time and effort!
@nicolasjax86843 жыл бұрын
i dont mean to be off topic but does any of you know a method to log back into an Instagram account? I was dumb forgot my password. I would appreciate any assistance you can give me.
@thomaskyler88373 жыл бұрын
@Nicolas Jax Instablaster :)
@nicolasjax86843 жыл бұрын
@Thomas Kyler Thanks for your reply. I got to the site on google and im trying it out now. I see it takes quite some time so I will reply here later when my account password hopefully is recovered.
@nicolasjax86843 жыл бұрын
@Thomas Kyler it did the trick and I actually got access to my account again. Im so happy:D Thank you so much you saved my account!
@thomaskyler88373 жыл бұрын
@Nicolas Jax glad I could help :D
@TraceyMariexx5 жыл бұрын
My all time favourite Queen song and James is the best cover I've heard to date. .
@lisaperry89195 жыл бұрын
I dropped the tank and I need to know how to get the new fuel pump back int the assimbley
@johnyc98565 жыл бұрын
crimial officers as they are crimials
@stomper-rpg49685 жыл бұрын
I will share with le world
@heavymechanic25 жыл бұрын
The floor pan was sealed for a reason, it keeps fuel vapors out of the car. Some imports have a cover that has a tar seal. This is just bad advice.