Thanks

That is absolutely correct and the whole point of this video. 👍

Thank you!

On a different battery bank (200aH Yinlong) I was using a single 5 amp Heltec balancer. The cells would consistently be around 25mV within balance. I added a 2nd balancer to that bank and it kept it in balance within 5mV. When I first built this 160aH SCiB bank I used the QNBBM balancer because I already had it laying around and it was rated for 10 amps. Once I determined the QNBBM balancer was faulty, I just decided to go with the 2 Heltecs based on the scenario I had with the 200aH Yinlong bank.

I bought a 2nd BHG-WM and I am planning on doing a comparison video between the two units along with a DMM and AC clamp. I was not aware of this but apparently they have a v1 and a v2 watt meter? Another commenter stated the v1 was not very accurate. He also said I had a v2 watt meter. Again I was not aware of that when I purchased mine. Regardless of that I will be doing that comparison video when I get everything set up and can provide a good comparison between them all. I am also going to be purchasing an SMD AMM-1 in the future and do that comparison as well. Thanks for watching and thanks for the input!

Thanks for watching!

Me too. I have seen some test video comparing it to other devices. I am going to do some of my own testing with it against the Termlab and also against the SMD AMM-1 when I get the time and resources.

@@jeremywilliams8558 I seen them too hifivector and Parker. It was pretty close

@@jeremywilliams8558the v1 is incredibly inaccurate & I’m being shipped a v2 to test. You can see my comparisons on my channel, great test on this Orion hopefully the v2 is more accurate then the v1 of the bhg. Subscribed to watch more 🎉

I am not sure which versions I have. I actually bought the last one that Big Jeff had on Ebay so I could have one to test in vehicle to compare with the Termlab clamp. Thanks for the info!

@@jeremywilliams8558 You have the V2 I can tell by the sensor in the video. 👍