Appreciate your videos and comments, I’m build in CT now, footings in at this point walls next week.

Man, you got inspections without some sections of vertical rebar? They must be leanent in your region.

Cutting the floor joist/trust you should have put hangers to support the bottom part where they were cut. This will keep the integrity intact and transport stress to the wall from the floor and stabilize the flooring.

This looks awesome! What thickness of boards did you use for the ceiling in the bedroom? Is it pine or cedar?

5:36 the physics of open web trusses is amazing.

Flash and batt insulation can be very risky if the spray foam is too thin, depending on what zone you're in. Using an interior vapor barrier makes this worse with closed cell foam because the moisture in the walls needs at least one side that is vapor permeable so it can dry. There is a vid out there of a couple who built a new home in Iowa, I think, that did a thin layer of foam with batt insulation. The foam being too thin caused in-wall condensation in the winter and it was so bad that they needed to remove all exterior wall drywall, remove all insulation and start over. They ended up foaming the cavities to the max. They did flash and batt to save money but it cost them way more later. Do not use an interior vapor barrier with closed cell foam or if using exterior insulation that is non vapor permeable, like Zip-R or XPS. If code makes you add an interior vapor barrier, use a smart membrane vapor barrier that can allow for moisture to escape.

I thought the top trim board goes first.

“Little bit of an update,” the shade you tossed on Oscar was some Karen-ass foolishness. Does your inadequacy run so deeply that you found it somehow appropriate to behave like a third grader? If you have beef with the man, take it up with the man, like a man, and leave this petty crybaby business to the tea party between you and your significant other.

Hooo YES !! Big updateS 👍

Excelente y muy hermoso trabajo felicidades 👌👌

Good job!! Lots and lots of hard work!!

The whole purpose of using the Zip sheathing system is to help prevent water from getting into the interior structure and causing rot. That's why seams are taped and nail holes are caulked. Did your masons remove and caulk all of those screw holes as they added the next course?

Excelente trabajo saludos 👌👍

Excelente video saludos y mil bendiciones 👌👌

Excelente trabajo saludos 👌🧱⚒️👍

We need more videos about floor truss framing and make long-videos more, please!

Excelente video saludos 👍

Your kids are precious! Reminds me of when i was their age and my dad was building my childhood home. I’m about to start this same process on my new land and researching. Great videos

Doesn't these framing contractors know how to read the prints, looks like they must not read the prints

your wife's bashfulness is adorable. Put her in front of the camera more often. Great build!

Thats a big house

Hi. I am curious about your span length, truss height, and spacing. Best I can tell are those 24” tall trusses 16” OC? Also what’s the longest unsupported span in your layout. I am considering a similar design but worried about the floor feeling bouncy even though the trusses may be rated for the span.

How much did those trusses run you?

Are the soffits going to stay open

We have brick ties inspection here in some parts of Texas

Sure hope they use brick ties

The truss manufacturer is not upto par on the manufacturing and reading plans

Excelente trabajo felicidades saludos y mil bendiciones 👊💯👏💪👌🏻

Excelente trabajo felicidades saludos y mil bendiciones 💯👌🏻💪👏👊🧱

Learning a lot from you videos. Thanks

Amazing video. Thanks for sharing ..

Buenas tardes excelente trabajo saludos 🧱💪👌🏻

ᵖʳᵒᵐᵒˢᵐ 🤭

Excelente video saludos 💪💯👏👌🏻🔨🔨🔨

I been watching all of your videos loved all of them you have a lot of wisdom your home is going to be beautiful all the extra things you do is a good peace of mine

They needed another power trowel and to wait about two more hours.

I think the truck-driver that delivered the floor-trusses could have spent a few more minutes gently placing he trusses on two or three 4x4's. I hope you go back and beef-up those sections of the modified trusses just to be over-kill. If I were rich, my house would have two levels of floor-trusses, opposed to each other at 90 degrees. One extra-day of work at the most and you would have twice the room for insulation and utility-lines, and space for secret holes in the floor to stash valuables.

Once the adhesive is cured the fasteners are not really doing anything. Screwing the subfloor before the adhesive sets (or just screwing instead of nailing) will ensure the subfloor is pulled as tight as possible to the joists and give the adhesive the best chance at doing its job with no squeaks. Some people swear nailing does just as good a job, but just because your nailed floors don’t get call backs doesn’t mean they’re done as well as a screwed floor. For the small time/cost premium screwing takes over nailing I don’t see why anyone wouldn’t do it.

Excelente trabajo felicidades saludos 💪👌🏻👏👊🔨🔨

Design of this house is great and surrounding with amazing view ❤

I’m late watcher , but I m so enjoying all of your channel , ❤

Excelente trabajo felicidades 👊 💪👌🏻👏

Excelente trabajo 👊 💪👌🏻👏

Excelente trabajo 👊 💯

Keep ‘em coming! I check for your videos everyday! Living vicariously through your experience lol.

Excelente trabajo felicidades 👊 💪 👌🏻

Laying directly on the footer, dirt and all, with no vertical tie-ins or rebar. If you ever have a mud slide or flashflood, your house will be ripped free and will float away. You can wave at your wife, as she screams out of the second story window, as your house sails away.

She needs a "sledge"

The basement waterproofing is remarkable. From my perspective, this is perfect. I have never seen the J-drain before, but I like it. I have only seen the circular drain pipe with holes at the base of the wall.

Excelente trabajo 👊 💯 🧱💪👌🏻