i downloaded the music to listen to in the car on road trips.

All that time, when you can literally just bring it out. 😂

totally wrong.. 🤡..

Just had my hotel do the hose down method I keep seeing here and it destroyed my AC and they had to replace it.

This music is horrible!

this is an ad, not a "how to" video

what kind of hotel is it

this music is what ADHD would sound like if it had a sound.

LOL.. I like how you completely skipped the blower wheel and condenser coil... the wheel is typically caked with crud and mold, making the room smell nasty! All that work for half-a$$ed cleaning!

How do you clean fan blower it's one of the main parts

My crew (ten years ago) was contracted to go around the country cleaning PTAC units at hotels. Then the hotels got cheap and maybe I got tired but This is how we did it: I believe the only good way to clean them is to haul them outside and set up a work station with a garden hose and coil cleaner in a pump up sprayer. Wet down the coils with water then spray down the evap., the condenser coils, the pan and the blower wheel with coil cleaner - wait a few minutes then spray it down with a garden hose- carefully don't get water on the controls. Wash out the drain channel between the evaporator and the outside pan. Open the vent door and throw out the shipping screw (so room has a fresh air intake). rinse and repeat- then lift unit from control end and dump out the water. Take back to room- before installing clean the wall sleeve with a wet vac. It the drain is a question pour water down the drain. A gallo gun can be used to clear the drain but it uses a lot of CO2 cartridges. Slide back in place then plug in and connect t-stat wires and turn unit to cooling to make sure it works. We did thousands of PTACs lost maybe 2 from water damage. Each unit took 1 man about 20 to 30 minutes to do- so each man could do 14 to 18 a day. Really focus on the inside of the condensing coil behind the outdoor fan that is where the heat builds up these coils tend to collect salts from the condensate water and corrode away at the bottom and the dirt is concealed by the fan blades. The indoor fan is a mildew haven. Leave the spring loaded defrost plug alone don't remove it. The outside pan is suppose to hold water and sling it on the condensing coil to help cool the coil. In some very humid locations you may have to remove it like Miami or New Orleans or Houston. The sleeve is suppose to be sloped 1/2" toward outside so water drains from evaporator pan into the outer half then overflows into the sleeve if water level gets too high (look for the slots in the back of the PTAC pan) and then there are plugs on each corner of the outside of the sleeve that can hold an optional drain tube- these will allow the condensate water to pee down the exterior of the building. Hopefully there is an internal drain on the wall sleeve and it may need to be checked to be sure it isn't leaking. - new drain kits cost around 12.00 each and have the drain elbow and gaskets. One last thought if your PTAC's have a metal base it can be removed to access the drain tube from the sleeve. I have seen hundreds of kinked drain hoses just under the sleeve.

The music. Wow

How I wish that all hotels managements understands that technicians should work like this.

I work at a hotel, not the way I do it. Pull dirty ptac clean wall shell and replace with clean ptac. No long prep. Room ready in 15 minutes. Take dirty unit outside and spray coil cleaner on coils, fan blades, pan and inside blower cage area. Tilt unit for drainage. I have a hose directly tapped into the hot water system. Rinse with 125 degree F water avoiding controls and gfi plug. Air compressor with blow gun clears coils and fans of water. shopvac water from pan. Plug in and test. Done. Your way would take too much time in prep. Only takes me 20 minutes to clean and test a ptac. Allergen and dust free, same as the cover. I have 132 rooms to take care of, and doing it your way it would take waaaay too long to clean them all. I have 5 units ready to go in storage.

Lol the video well first of all I'm one man 112 beds heated pool I kinda dont have time it's like taping off to paint who has a helper and time like that are you guys hiring

Awesome. Hope you guys are like gang busters now aith all this Covid crap! We need you!

Hi there. My question is: Where I can buy J- nut for box of this units. Fir install A/C unit

Ptac porn music must go

OMG THE MUSIC!

*Works good.>>>**nub.best/s27x** Using this in a cargo trailer/camper conversion using a 3400 watt Champion generator. The generator runs in ECO mode and ramps up when compressor kicks on then back down to idle while running with The generator slides out on heavy duty draw slides. This is a through the wall AC so the intake and exhaust are both on the back. I built a simple shoot out the rear.*

Why not just take the unit outside to get rid of prep and clean up time?

That good aircon hotel clean every April and will clean will always good health conditions and will not broken the aircon so impressive that good

That is like the slowest ptac cleaning ive ever seen

Bad music sounds like a Nintendo game

The shroud was not cleaned. That's the most important part of the Ptac

video is a waste of time just take the ptac outside and hose it down.

nice annoying music. wow.

what about the smell

what about the smell

Aren't you supposed to clean the other side too?

Did miss the video of the cleaning of the Condenser coil??

Cool music.

where do you order the eviromentally safe cleaner? Also where do i get the steam cleaner and hi pressure cleaner?

Great video! I am going to share this on www.qtech-services.com blog!

How about the sleeve? It didn't got cleaned!