Wrapping your board in shrink wrap is such a good idea. Great Thinking.
@alebonfantii2 жыл бұрын
Amazing video! New sub here🥰
@ellgwapo.17542 жыл бұрын
If it' is some Problem!. Meby the Start Elektronik engine. Have too' Put oud the RC Car.
@highestvirtue18922 жыл бұрын
Try using silicone caulking like the one for the shower to seal the bottom and marine waterproofing spray for the springs n bearings
@agremlin772 жыл бұрын
Nice video 😎 , liked & subscribed, thanks for sharing ‼️
@dronature2 жыл бұрын
Perfect video! Such amazing and stunning footage :)
@truculeur90562 жыл бұрын
Yes it does, but in this video everything has been done very much unprofessionally
@Eyis2 жыл бұрын
Fantastic landscape shots please add me
@bluepawn2 жыл бұрын
I don't know why there s no handlebar with disc breaks, ip68, etc (all double secured). All lights etc and an app which can slow down the max speed to 20km/h so that will be allowed in lots of countries.
@The_Dude_4202 жыл бұрын
our fucking countries should stop being gay
@marksmith51562 жыл бұрын
One way bearing is bad or been installed inside out
@doubledscoots65422 жыл бұрын
Yo your bearings gone bad replace it
@deangrimmage2042 жыл бұрын
Yes, it's your one way bearing is gone bad. You need a new one to go inside your starter case.
@coolzorex2 жыл бұрын
Connecting road broken,
@rcnitroguy93172 жыл бұрын
One way bearing
@agremlin772 жыл бұрын
Nice video, liked & subscribed, thanks for sharing ‼️
@manstone09082 жыл бұрын
Is it water/snow proof
@HauntedXXXPancake2 жыл бұрын
Good question. IP-rating ?
@LOLEK2211222 жыл бұрын
@@HauntedXXXPancake I asked Propel about it and will it hold up riding on wet surface like asphalt, when tires could shoot some water drops in the air. They said "Our waterproof rating is IP55. We would recommend a safer ride under dryer conditions.In regards to the water splash-proof, although our components are sealed, there is still the possibility of water ingress, so we do not promise or recommend wading through the waters."
@brumeme43302 жыл бұрын
The one way bearin in the starter on the motor it is one a shaft in there and the bearing is on that shaft
@cblack34702 жыл бұрын
undo glow plug an start again
@mindinmotion19502 жыл бұрын
Personally wouldn't ride my pro in the snow, but I have mountains here if I get the itch to ride. Hope those motors hold up for u. Ride-on
@rcsendandblast15792 жыл бұрын
The 3 screws on the backplate / starter assembly needs to be removed and you do not have to take the whole car apart to fit a new one way bearing. The arms on that side can be slightly squeezed and it will give enough room for the one way bearing to be removed 3 small screws one piece replace and Voilla 👌😊
@ay48582 жыл бұрын
Are your roads salted? Wondering how your boards and exposed suspension/hardware will hold up over continuous use on salted roads? Also consequences of condensation, hot battery and board in winter conditions?
@zarieb77652 жыл бұрын
Is it super cold
@2n35722 жыл бұрын
Yes a MN video
@eBoard3R2 жыл бұрын
🤙🏼⚡⚡🤙🏼
@erixfiallos5872 жыл бұрын
For those of you wondering, the board held up pretty well. We did this to both my endeavor s and my brothers pro. He hasn’t posted because we got hit with temperatures of -20 here in MN. We haven’t rode due to extremely cold weather, since hot batteries and cold weather equals condensation. But overall the boards held up well.
@MotoCrazeBat2 жыл бұрын
So what happened? Its been 2 weeks? Where's the update? Does it still run? Any warping of the board? Details!
@jimzplace2 жыл бұрын
show it to us if you dont have to return it.........
@georgemuron4822 жыл бұрын
I was doing this with my meepo hurricane with 155mm pneumatics It handled it really really well until I broke a belt
@wilsonmeredith55172 жыл бұрын
1st of all, at first glance it just looks like the drive train sitting on the snow, then I realized the deck was shrink wrapped and blended in the background. This video convinced me to keep the knobby tires on since it will probably snow at sometime this winter season in NY. I’ll swap off to 7 inch pneumatic street wheels in the spring
@eprohoda2 жыл бұрын
Yahoo- that is fantastic channel!catch you later~ Wild.
@Adrian8907223 жыл бұрын
Wat speeds do you get on this board
@wildnaturetraveler7383 жыл бұрын
Between 22 and 26 mph, it's really stable even on that speed
@LucasBuchegger3 жыл бұрын
Really cool video. You have my Like ;)
@MichasMomente3 жыл бұрын
BIG LIKE 👏👏👏What can I say .. Just a great video 👌👌👌 really great the landscape captured with the drone Greetings from the Sauerland Michas moments
@coasttocoastcaravanning61383 жыл бұрын
Brilliant video mate really nice flying all looks brilliant Jan 👍👍👍👍👍👍
@wildnaturetraveler7383 жыл бұрын
Thanks for the support 🙌🏻
@MichasMomente3 жыл бұрын
Big like 👏👏👏What can I say .. Just a great video 👌👌👌 you did really great. Greetings from the Sauerland Michas Momente
@wildnaturetraveler7383 жыл бұрын
Thanks a lot, I really appreciate it 🙌🏻
@agremlin773 жыл бұрын
Super! Nice footage 😊 liked & subscribed
@wildnaturetraveler7383 жыл бұрын
Thanks a lot 🙌🏻
@LucasBuchegger3 жыл бұрын
Great Cinematic Footage,You have my Like ;)
@wildnaturetraveler7383 жыл бұрын
Thanks for the support bro 🙌🏻
@coasttocoastcaravanning61383 жыл бұрын
Nice one mate looking good there great video really nice flying love the music thanks for the sub jan 👌👍👍👍💋🥃🥃🥃
@coasttocoastcaravanning61383 жыл бұрын
Brilliant video mate really cool flying great music really cool job on it mate jan 👍👍👍👍👍👍💋. I have subscribed
@wildnaturetraveler7383 жыл бұрын
Thanks for your words, I really appreciate it 🙌🏻
@martiesrcsstore40493 жыл бұрын
Stripped gears catching for a sec the rest off teeth are off the gear
@dajtopdog4 жыл бұрын
MTB&RC is correct, the one way bearing is the issue. Their about $20. Id buy 2 just incase
@clardyvalle68984 жыл бұрын
Buen carro.
@wildnaturetraveler7384 жыл бұрын
Gracias 😀❤️
@romeldaniel744 жыл бұрын
Your one way bearing is bad, it’s the one grab the starter shaft, replaced new one..
@wildnaturetraveler7384 жыл бұрын
Thanks, I'll try that
@romeldaniel744 жыл бұрын
Bryan Fiallos -try checking the one way maybe installed backward, the text side of bearing should face towards the engine, goo luck and thanks for the sub👍👍
@wildnaturetraveler7384 жыл бұрын
I figured out, and the bearing is bad. Already ordered a new one whit other stuff, just waiting. Thanks again bro!
@derek31547 ай бұрын
lol, pretty sure that’s the same problem with mine..will go to the RC store tomorrow. Trying to get my Revo 3.3 up and running after 10+ years😅.
@hendrix94444 жыл бұрын
Great channel, keep up the great work! Take a look at SMZeus to help grow your channel!