Chasing Gelo

Пікірлер

@PRA733P 17 күн бұрын

Can I get a quick update bro, how’s it keeping up? Is it better then plastic, Obvz plastic lets it expand and like move alil compared to metal….

@dereksmith6365 17 күн бұрын

Whats the rear tire setup

@E30Tylerrr 19 күн бұрын

700 hp w no upgraded transmission??

@nigrun50 24 күн бұрын

Can we know the part numbers in the description?

@wordtruth6116 24 күн бұрын

You don’t show how to remove anything. It would make it lot easier to learn if you show how to.

@Wh0_Me_B58 29 күн бұрын

Is that on stock trans ?

@andrynenortey3575 Ай бұрын

Bro,what kinda paint are you rocking

@Cristian-b1y2h Ай бұрын

I have a question about the aluminum coolant flange, it does NOT seem to come with a gasket and the plastic BMW one has a rubber gasket. Did you find a gasket for the upgraded flange, Thanks

@garyalarcon4332 14 күн бұрын

I had the same question and asked him, he said you would need to use atv silicone there’s a brand called reinzoil

@boostedbavarian Ай бұрын

Sounds like total shit. Wtf

@menamesframerate9136 Ай бұрын

Is it fine to run no air filter?

@destruxandexploze2552 2 ай бұрын

A bottom mount! Love that! I prefer the stealthy look.

@B58-Premo 2 ай бұрын

How much would you guys charge to replace mine?

@kuvyoghmoobamelica6883 2 ай бұрын

Don't be stupid and do pulls like that in residential streets.

@b58daddy 2 ай бұрын

Fire setup gang

@Vr30naz 2 ай бұрын

For the broken plastic piece on the block by the oil feed…did yall leave it like that. And the pcv hose did yall leave it uncapped/orange oring

@nato56table 2 ай бұрын

Where did you tap in the MAC solenoid? Doing the same set up

@davidsipkin3866 2 ай бұрын

What was the 60-130 on this setup?

@davidsipkin3866 2 ай бұрын

What was your 60-130 on this setup?

@adisayin6475 2 ай бұрын

Thanks for sharing. Six months down the line, any issues with aluminium OFH?

@ralph1rodriguez 3 ай бұрын

how did you remove the coolant connector? it has three e torx screws connecting it to the block but the screw to the left is hard to get to because of the stuff next to it.

@markminchuk4499 Ай бұрын

you need a thin torx socket. i had the same issue.

@greesemonkey1233 4 ай бұрын

Appreciate the video bro🤙🏼

@paullasky6865 4 ай бұрын

Has it gone pop yet?

@GhostX3MC 4 ай бұрын

im pissed whats the point of inline 6 when it takes 10hrs ish to do this job

@RexRogers_ 3 ай бұрын

Perks of n55

@scoobyquez16 5 ай бұрын

Bro please tell me asap how you got that bottom bolt off the flange you replaced without removing the heat management module to the left of it. I have a 540i and tried a 1/4 extension with and without a swivel and still can’t get to it.

@ChasingGelo 4 ай бұрын

I had to remove it :(

@scoobyquez16 4 ай бұрын

@@ChasingGelo I was able to get it off without removing it 😅 it worked with the 1/4 extension. the socket wouldn’t fit completely on there at first but with enough pressure and turning an angle it finally came off. Putting it back on was tricky but still got it done! If anyone tries this just make sure you don’t drop that bottom bolt and I’d recommend when installing it don’t use the same bolt that was at the bottom because you may round it off a little bit

@CS_AZOO Ай бұрын

@@scoobyquez16I need help, u got snap or sumthin so I can show u what im struggling with

@CS_AZOO Ай бұрын

@@scoobyquez16bro do u got snap or sumthing where we can talk, because I can’t figure out how to get the bottom bolt back on, I just smashed the flange to plastic pieces to get it off but idk how to put the bottom bolt back on

@caleblawson1301 9 күн бұрын

I got it off with a deepwell e-torx socket

@Kingclevvv 5 ай бұрын

You don’t need a boost controller?

@ChasingGelo 4 ай бұрын

I am running motive reflex, that is essential my boost controller

@asbd24 5 ай бұрын

Hi sir, . I really like your youtube videos. The quality of your videos is very good, but as a KZbin expert, I noticed one thing: the views of your videos are decreasing. Then I researched your channel and found that your video's SEO score is very bad. Your video and I can see that your video is not SEO optimized because your video is not for targeted audience, your video gets less views and channel subscribers get less views. I can say as a KZbin expert, if you can do SEO-friendly things for your channel and search videos like tags, hashtags, descriptions and keywords, your KZbin channel and videos will grow faster. if you want to improve KZbin channel then I can help you. thank you

@escobaros2867 5 ай бұрын

rwd ?

@andrewb232 5 ай бұрын

stock trans?

@Cybrons 5 ай бұрын

How you like 2 doors compaired to 4?

@MOPAR_scatpack 5 ай бұрын

That was weak.

@kgreersf 5 ай бұрын

Scared of that curb?? At least try to slide into your own lane... 😂

@rockharris89 5 ай бұрын

No one around. Nothing wrong with cautious

@traywalter6918 6 ай бұрын

Bro why u leave a b58 for an s55?

@AnthonyTejeda-e5g 6 ай бұрын

Where u get ur interior lighting from

@Heikichikoji 6 ай бұрын

I thought of getting 340i and doind upgrades, just got an m3 not worth it for me.

@MrGiomig 6 ай бұрын

Trash ass design smh and I know the tool is expensive but I already did a water pump on my b58 and the air operated vacuum fill tool makes any coolant job so much easier I bought one from MAC finally

@markminchuk4499 Ай бұрын

no need the car does it for you