CrawlDaddy4x4

Пікірлер

@kraptastic333 9 ай бұрын

What grease and gear oil are recommended please?

@kraptastic333 9 ай бұрын

Ah 90w at the end there

@99FXR Жыл бұрын

what can you use for a 4wd transfer indicator switch? If the one you have is busted..Thanks

@theninja001 3 жыл бұрын

I came here for the torque spec on the drive flange nut, fail.....

@kraptastic333 9 ай бұрын

7:10 90ft lb

@MrCstone1 3 жыл бұрын

do you have an email?

@TheDarknessConsumesMe666 4 жыл бұрын

2 questions: 1 - would it have enough space for that in the engine bay? 2 - Can I put that in a car?

@stu6885 3 жыл бұрын

what car ?

@danielwilson2365 4 жыл бұрын

About 8 months ago I had to replace my 1999 Toyota Landcruiser Transfer case with a used 2001 Lexus LX470 transfer case. In the past couple of months, on two occasions, my vehicle inadvertently shifted into 4W/Low gear while slowly turning left into a parking spot. The High/Low gear shift lever however was still in the High position. The Techs who replaced the transfer case have since gone through it and cannot figure out what caused the issue since they cannot get it to duplicate the problem. Do you have any Idea as what may have caused this issue?

@unclesandcrab 4 жыл бұрын

Looking for a speedometer recalibration box for early toyota pickup

@unclesandcrab 4 жыл бұрын

Looking for a speedometer recalibration box for early toyota ?

@K37-A 4 жыл бұрын

What land cruiser is this from?

@ryanschmidt2048 4 жыл бұрын

toyota pickup 79-95

@DavesDirtyGarage 4 жыл бұрын

needed to show disassembly as well.. :(

@Crawlerjamie 4 жыл бұрын

I can hear every bit of saliva in his mouth.

@jonathancampbell5344 4 жыл бұрын

Where do i buy the counter shaft bearing that is in the front lower part of adapter

@anomilumiimulimona2924 5 жыл бұрын

Lock washers, and nylon lock nuts?

@dukenukem7183 5 жыл бұрын

Link?

@sirchase1 6 жыл бұрын

The bolts on the rear of the T-case I'm turning into the crawl box are stuck. I have an impact wrench but there are 4 bolts that are still stuck in the case. Pinion flange bolt was easy but these are preventing me from opening the case at this point. Any tricks for getting them out?

@anomilumiimulimona2924 5 жыл бұрын

Dr Scagpoople, use some heat.

@gsfbffxpdhhdf7043 4 жыл бұрын

Use pb blaster heat and a stronger impact driver. Tighten tighter one second then back it off and hold it impacting for 1 min at least