Пікірлер
@dynamicoverland8650 Жыл бұрын
Ahhh I know what this is. I ran into this a couple times myself, luckily…. It’s very easy. The (2) I believe 1/2 bolts on the side of the sector shaft brace bearing is loose, when you turn as the sector shaft brass spins the pitman arm it actually move the bearing. Unfortunately I had to install a very thick washer and red lock right to mine to prevent this from happening again. I hope my diagnosis is right! Make your life easier!
@joshuamahan3403 Жыл бұрын
Squeezing noise? That’s binding. Something is misaligned or over/under torqued
@acknightabegi2650 Жыл бұрын
I installed one a few weeks ago on my 22 diesel and same thing. Removed. Regreased noise still there. Synergy said to me. Buy the sealed bearing. $100. Not the price issue but why ? Why do I need to buy something extra ? It’s a brand new truck and brand new brace /shaft brace !!
@roberteisele4015 Жыл бұрын
The sound goes away when bolts tightened up for bearing bracket? Was the sound coming from inside the cab or out, hard to tell from the video?
@bigalforsyth Жыл бұрын
I've just run into this too. From the high of no death wobble to the low of this terrible noise. I don't care if it is a jeep...not going to listen to this creaking forever
@Steve-ng1hq 2 жыл бұрын
I acually figured out my issue hope it works for you too. I noticed those two bolts by bearing one in front one in back think like 12mm were both loose even with blue loctite so I'm gonna use red this time. Sound is gone thank God
@christiancarbajal4978 Жыл бұрын
Do you know the tq for them ?
@Steve-ng1hq Жыл бұрын
@christiancarbajal4978 I know exact but think only like 25 and those dam bolts could be stronger. I didn't want to tighten to much afraid they may snap
@tjb3401 Жыл бұрын
@@Steve-ng1hq I know I'm months late to this, but same here - Every few months mine starts making this noise and those little bolts are stretched out. So annoying, and Steer Smarts says "Huh, never heard of this before."
@Steve-ng1hq Жыл бұрын
@tjb3401 FYI, keep an eye on 42 mm. Also, mine came loose adding more knocking noise. You would think they would at least add lock washers and stronger bolts. Frustrating for sure
@Steve-ng1hq 2 жыл бұрын
I just notice mine started doing same thing. Always something. Gonna take apart see wtf is wrong
@johns8759 2 жыл бұрын
Did you ever figure out the cause of this?
@brnt.9319 2 жыл бұрын
My Synergy brace has been doing this for a while, at a certain point in the steering g cycle I could hear a pop and I felt it in the wheel. I was able to trace it down to the brace. I uninstalled it, cleaned up the greasable bearing, made sure grease was entering it, reinstalled and regreased it. So far, the noise is gone and my steering is smooth…only time will tell I guess.
@9000RPM-hi9h 4 ай бұрын
@@brnt.9319지금은 괜찮은가요?
@michelkieffer928 7 жыл бұрын
super la video
@mircea-andreipastiu1095 7 жыл бұрын
Well done! Congratulations Giovanni and your team! Amazing project!