We have been using Schedule C with Turbo tax for our business tax filing and now realize that we have to separately file 568 for our SMLLC in CA. What is the easiest way to file for multiple year 568 for FTB? We didn't see any link in the Tubrbo tax.
@will33587 күн бұрын
I too am struggling with the trim in MFS2020. When my plane (any plane) is in an approach configuration, whenever I adjust the trim the sensitivity seems to increase - so for every each time I adjust the trim no matter how gingerly I do it the plane will either pitch dramatically up or down. The problem then goes away when I put it into a clean configuration. It's only on take off and landing where this happens. I can confirm that the AI trim is not activated. By the way I am playing on an Xbox. And yes, buying the Xbox to play MFS2020 ranks among the top hundred worst decisions of my life.
@michaelblack499312 күн бұрын
What year was this?
@dannyjensen495412 күн бұрын
2004
@davidkloter197612 күн бұрын
Did you ever figure out a solution to that problem because my Ford edge has the exact same problem?
@TheCriticalWave15 күн бұрын
i have same issue do u remember how fix it?
@jcjko550419 күн бұрын
excellent.
@Se7enAv819 күн бұрын
Thanks so much! I was wondering why my F-18 wasn't letting me pitch up smoothly during takeoff.
@kevw17225 күн бұрын
THANK YOU!!! i was fed up with the controls for awhile and now I know why. The trim was a pain but this fixed it.
@alexanderbotto770327 күн бұрын
In Xbox serie x where ?
@Supanova7029 күн бұрын
Questtion on this MPPT controller. I hae 2 house to start batteries on my boat. Got to the boat and app said they were floating. Showed 20v from 2 100 watt panels 0 amps. When my boat is running my battery monitor shows -1.59 amp draw? Why? The voltage is 14.8 from motors. Shunt is installed correct to a neg bus bar. All house loads are off during readings. This also has a ACR
@aa19nnАй бұрын
Followed the instructions for my 09 CRV. Got two blinks. Thank you.
@PebbleBeachCorollaАй бұрын
Hhow long has this pump lasted? How often replace the silicone? I plan to run pump an hour daily.
@GeorgeHafizАй бұрын
Why not just use four lithium batteries? Is it because most devices expect 1.5 V per cell and the lithium cells being at 1.8 V will damage them? Could it be a straightforward modification to make such devices tolerate this higher voltage and reduce the time between battery swaps even further?
@devinkjellquist780Ай бұрын
Did you ever find the cause of this issue?
@enrfuego6040Ай бұрын
Why not to use silicon tubing since the one I’m the pump seems to be ok?
@enrfuego6040Ай бұрын
I love your idea , is still working fine? Where do you buy the hose? How do you connect the hose to the chlorine bottle?
@enrfuego6040Ай бұрын
Also, what do you use to connect the hoses?
@Olivers_RailAdventuresАй бұрын
Thanks for this worked! Was about to give up
@gloriadiaz5211Ай бұрын
Is this the one under the gas pedal or the one under the glove compartment
@dannyjensen4954Ай бұрын
Gas pedal. See my other videos showing where to look for it and twist heat knob to see if is moving.
@pennywise5095Ай бұрын
Thank you! i had it enabled somehow and it drove me nuts!
@Beba-qv3dbАй бұрын
Based on my Yanmar service manual it us just opposite: you check oil level with screwed in dipstick.
@dannyjensen4954Ай бұрын
This is not what my trusted friend says. Thanks for your comment. Can you double check the model and details in your manual?
@Beba-qv3dbАй бұрын
@@dannyjensen4954 my engine is 2GM20F. It makes sense since you check oil with dipstick fully inserted. Page 41 of operating manual, point 2.
@dannyjensen4954Ай бұрын
@@Beba-qv3dbcan you check what the transmission manual for KN2P says? Are you looking at the engine manual or transmission manual?
@Beba-qv3dbАй бұрын
@@dannyjensen4954 my gearbox is Kanzaki KM2P. I'm looking at original of my Yanmar operation manual covering engine and gearbox.
@Beba-qv3dbАй бұрын
@@dannyjensen4954 it is operating manual , original, covering engine and gearbox. It says " to check with screwing the dipstick ".
@jackreinhold9053Ай бұрын
Question for anyone: When I do the test, should both fans be running or just one?
@dannyjensen4954Ай бұрын
I only have one fan that I know of. The actuators cause air flow and they are tested.
@RePhilAZАй бұрын
I had the EXACT same problem and your solution fixed it superbly on my 2007 CRV. Thanks for saving me hundreds of dollars!
@dannyjensen4954Ай бұрын
Thanks for your feedback.
@LelandHelepikoАй бұрын
I know this is old but I have a NEM 2 application in flight where we want to remove the battery from the design. Would that affect the NEM 2.0 status at all?
@dannyjensen4954Ай бұрын
No. Won’t impact I think. Just change and resubmit form with new details
@GardenGrow-usАй бұрын
Worked for me [ 1:15 ] Check the connections. Boom. Done. Thanks Danny! 🤠
@dannyjensen4954Ай бұрын
Thanks for your comment to help others.
@g7natives199Ай бұрын
Danny, can you show us how to do the NEM 2.0 SLD *with* batteries? I used your info and got my solar application approved under NEM-2, and I'm about to have a contractor build it, but I want to add a couple of batteries and need to modify my application. I don't understand any of the battery info in the application, nor how to do the SLD to include batteries. Thanks!
@dannyjensen4954Ай бұрын
I would consider the option of having the contractor create a new line drawing and filling the associated fields and submit the modified design for SCE approval BEFORE you start work. Contractor will be responsible for filling out SCE form and supplying all documents for owner builder permit before starting construction and will be responsible for obtaining approval by SCE and city. Need to add this to contract?
@dannyjensen4954Ай бұрын
I would consider the option of having the contractor create a new line drawing and filling the associated fields and submit the modified design for SCE approval BEFORE you start work. Contractor will be responsible for filling out SCE form and supplying all documents for owner builder permit before starting construction and will be responsible for obtaining approval by SCE and city. Need to add this to contract?
@aga.farhanАй бұрын
Does this problem ( blowing cold air in CRV EX ) shows CHECK ENGINE LIGHT in dashboard?
@gaafsy8546Ай бұрын
All my assists are off and I was flying the a310 today and rudder elevator trim didn’t want to go down to 0, I tried everything, I have it binded on my controller and it just won’t do anything, it stayed at -16 after taking off and didn’t change at all
@amerbualhasan8749Ай бұрын
Straight to the point! I appreciate the information shared here. My AC still blows hot air. I tried the diagnostics sequence, it worked but I got no flashes at all. The system was telling me all is well lol
@raelaws7822 ай бұрын
Thank you for taking time to go through this process, similar situation I'm looking into my mom wants to transfer 3 in msileam its sev miles in another state wash ,in Lakewood a real Beauti, but I'm I'm deturmand to go to the woods in Oregon ,LOL
@TXFarmRoad2 ай бұрын
Dielectric grease on the green actuator connector solved my problem
@TXFarmRoad2 ай бұрын
Dielectric grease on the green actuator connector solved my problem
@TXFarmRoad2 ай бұрын
Dielectric grease on the green actuator connector solved my problem
@brettwalker77712 ай бұрын
I ran this diagnostic check on my CRV, it did not blink at all yet my AC still isn’t working. Any ideas what is wrong?
@dannyjensen49542 ай бұрын
Go to an ac shop an have them test your compressor
@HNIKKOL2 ай бұрын
Dear Danny and subscribers, thank you very much for the contribution of your videos and comments, it is very creative and those of us who have a 2008 Honda CRV like mine are very happy to share the experiences. I´m watching them from Argentine.
@dannyjensen49542 ай бұрын
Thank you for leaving your kind comment.
@smarttech86842 ай бұрын
It worked, thank you !
@dannyjensen49542 ай бұрын
Thanks for taking the time to respond. Great to know!
@roialnet2 ай бұрын
I registered my LLC last January 18, 2024. Should I have file taxes before April 15, 2024 or am I due next year April 15, 2025?
@dannyjensen49542 ай бұрын
I believe it’s April 2025 filing date and you may get the first year no cost in Ca if you have a simple LLC. I’m not an expert just a DIY tax filer.
@timhoke23 ай бұрын
Danny, I also made a 97 on the IFR written using Sheppard. There are two other written exams based on the same material and I scored 98 and 100 on them using Sheppard. I'm 76 and it did take me more than 3 weeks. BIG QUESTION: Did you take your check ride yet?
@dannyjensen49543 ай бұрын
No check ride yet. I’ve been taking too much vacation. I have also been having peaks and valleys in training. I’m going to augment with MSFS 2020 and pilotedge.
@jaimetrevino36643 ай бұрын
Excelente video muy práctico 🙋🏼
@ryanhuey86513 ай бұрын
If you turn the fan off and turn the car on but don't start the engine, after the beeping stops, hold the inside air down and clock the bottom defrost 5 or 6 times then let go. The inside air button will blink a number of times. The number of the blinks will tell you what problem the AC system is having. The car manual has a list of the codes. Easiest way to tell without doing anything
@dannyjensen49543 ай бұрын
Great comment. I did a video on this. See link number 1 in description of this video and let others know if you can add anything to detail shown in the linked video.
@mikiteki25693 ай бұрын
I need only setting time after off ?
@mikiteki25693 ай бұрын
I need only timer after off signal (0-100sec)
@dannyjensen49543 ай бұрын
Yes. This will do a timed shutoff after off signal.
@mikiteki25693 ай бұрын
No parallel with load (L1), only after stop load. I this modul I must put one relay on N. @@dannyjensen4954
@azprinting91353 ай бұрын
This helped so much! Thank you!
@dannyjensen49543 ай бұрын
I’m so glad you posted this comment!
@rafajr903 ай бұрын
Does everyone have to pay the 800?
@dannyjensen49543 ай бұрын
First year is free. Then $800/yr. Don’t be late. Seems in CA you can only get a side gig if you have a LLC then you can start depreciating your home office / deducting some rent etc. IMO The ball park math works like this .. break even = ( .4 * llc expenses) - 800. If you have a positive number then LLC good else LLC bad. You need to do your own return I think. You don’t need a LLC to file a Schedule C but maybe your customer will require you to get LLC.
@user-yt3dw1ty5c3 ай бұрын
Good job on explaining what it took for you to sell your dad's plot. This is a good start for anyone in a similar situation.
@nyrubin3 ай бұрын
Thank you, almost gave away the sim to someone smh 😂
@dannyjensen49543 ай бұрын
So good to hear you like the video
@nyrubin3 ай бұрын
💪 also had problems with the throttle, it was set to automatically go idle, it had like 3 buttons assigned to it (not even with the flight sim attached to it lol)
@moniquenicoleau23603 ай бұрын
Hi! This was very helpful! Can you explain like M-N and U-V that would be so helpful
@dannyjensen49543 ай бұрын
I don’t remember reading about this when I filed. Can you let us know more info on this topic?
@jasongillis47733 ай бұрын
But you didn’t show the result?
@idohaviv44223 ай бұрын
I bought the new Boing 777-300 I did all what you said and I still have a problem. The plane goes up automatically even if I don’t touch the yoke I turned off the AI auto trim and the AI rudder, but it still goes up. What can I do?
@Funrunner0083 ай бұрын
Thanks for all the great information, I started my SMLLC December 29 2023, Do I Still need to file form 568?
@dannyjensen49543 ай бұрын
I am not an expert but I think based on my understanding, I would file. The risk of not filing is too great due to the penalty of not filing. I assume you a will also file a schedule C and this will have some net losses to write off also?