6 жыл бұрын
Пікірлер
@OnlyLifts. Жыл бұрын
0:30 this song always reminds me of VR46 ☀️🌙
@Surferant666 2 жыл бұрын
Is it the ditech engine
@viktordenac2040 2 жыл бұрын
Nope, Piaggio
@augustinasmereskevicius6965 2 жыл бұрын
How can i split the case without damaging the bearing ir the crankshaft
@viktordenac2040 2 жыл бұрын
With a press. Bearings inside the crank shouldnt become an issue using this method, but i do advise changing it if it has more than 20k km on it or if it has any signs of failure on it (cracks, etc.). Also advise changing the case bearings (they are like 30 bucks (kit includes 2x bearings and "semerings" which are like seals in english i think.
@MestariT1kku 2 жыл бұрын
why u don't have air filter?
@viktordenac2040 2 жыл бұрын
It was just at the start, we couldnt wait until we turned it over haha...its on now, malossi sponge though
@dokesz530 2 жыл бұрын
I did replace my bearing today and dont ever put the bearings into the fridge.Just make sure u heat up the case to 100 celsius and bearing falls in.if is colder the bearing ll not fit.It works for me everytime.Also get some tool if the bearing get stuck in the beginning just gentle tick it out.
@viktordenac2040 2 жыл бұрын
Good tips. I found it easier doing it my way but the risk of the bearing getting stuck in the beginning (as seen in the video) is much higher yes... :(
@dokesz530 2 жыл бұрын
@@viktordenac2040 because u didnt heat up enough.one side i must reinstall it 2 times because it wasnt hot.
@stipemarinovic5032 3 жыл бұрын
I have questions abut crnackshaft can you dm me on instagram stipe_marinovic
@oskarimatikainen7136 3 жыл бұрын
Thanks this was realy helpful
@viktordenac2040 3 жыл бұрын
Your welcome mate, i did try my best to document it but while doing the conversion it's quite tough to stop working to take pictures 😅