Nice work, but where is the rest of the engine?

OLÁ mikaniko 18/06/24 Assisti seu vídeo e vos pergunto, não sabes o que fazes ou estas de brincadeira? E os diversos testes necessários antes de colocar o virabrequim não ensinas ou não sabes? Roberto Udo Krapf

Di maganda pagvivideo. Parang lasing nagvideo!😢😅

😮 nice

hello sir am really enjoying your practle lesson thank you so much

Didn’t see a timing chain there is one on that engine

I was changing my head gaskets then I realized, I mine as well change my lifters too, couple more bolts and your lifters are right there 🤷🏾‍♂️🤷🏾‍♂️

Nice bro

You good 💯💯 I was wondering if anybody could re-doo them engine

With a impact 🤔💬🫣

😂j veux même manger ça pour l amour....

Vraiment j aime trop ça comment rodé ces soupapes ?

Ilan turn kaya to sa bawat bilang ng thread?

Maybe my hearing doesn't work as well as it used to but I didn't hear any torque wrench clicks for any of this! Maybe I

Very nice KZbin video. Thank you, sir.

thank you boss ❤❤❤

Tnx❤

😅Bonjour

Hello can you explain how to adjust vvel when overhauling an engine

Non mds does it matter on what side they on or does they front rear left or right side?

Цікавлять зазори клапанів на цей двигун?

Very Nice ❤

Very nice video. Do you have a video for piston installation?

Is your number #1 piston TDC? Is it supposed to be 20 degrees past TDC?

Nice work. Filipino working in Saudi?

Tayota highlander tame

مااهميت خرم تحت السلف في السرندل

Can we replaced the head on car without engine remove , please 🥺 ans I have a car with vvel camshaft broken , please consider

How much torque on everything

Where is the cylinder head gasket????

Nice

Me gusto el video creo q seria bueno q el q arma explicara

Good work

Wondering what the warranty is with this rebuild.

The oil pump have sync With the crankshaft?

What’s the cam plate specs

I think my drivers side chain tensioner on my 5.7 is not engaging. I hear the chain slapping on cold start. are those tensioned by oil pressure or a spring? I saw you remove the keeper so it looks like it's tensioned already

zakaray

No gaskets 😳🤔

I didn't see new head gaskets on that block before putting the heads on they could have been there but it didn't look like it?

OSnap Bro, at 10:10 I can see a shot of the old lifters that have a hole for the MDS system and the new ones do not. Gonna say you put the wrong non MDS lifters in that MDS equipped engine. And yes I would say no head gaskets, new gaskets are shiny not rust colored. I can hear the head clank. Sad. My 5.7 died because the head gasket was installed backwards blocking half the water ports and the valve guide seal on #6 fell out. Catastrophic failure because of stupid.

Why problem engine?

💘

Work is good but you safty Zoor take hand golve dot not use mate hamber if theet damig what you do use Plastic hamber Safty Fist if your finger damage what you Do

Doce yeba cunas ese motor

TORQUE WRENCH.!!!

Where did you buy the parts?

A one g Mashallah

Kitna kharcha aaa jata ha total

Hi, How much the cylinder head torque setting 1st time and 2nd time you did. Please Thanks alot