They’re Rough Country leveling springs. I bought them off some one on FB marketplace lol

I’m from Canada and got a back up camera from them

I clicked the link and it went straight to the website home page. You can just enter your vehicle info and it’ll give you options specific to your vehicle

Pro tip - when you pull the door panels, remove the rubber boot around the door lock stem that pops up as well as the window up down switch before pulling the panel. The window up down switch will just pop out and that gives you easier access to unplug it (and plug it back in when you re-assemble. Also, the bezel/trim around the door handle should be removed. That makes it a lot easier to put the door panel back on. So my procedure is: Remove upper trim piece that covers the inside of the rear door pillar (just pops off) remove boot around door lock stem, remove switch and unplug the connector, remove the plate/screw cover inside the door handle to access the screw and the the trim piece around the door handle (just pops out) remove plastic screws around outside of door panel, then lift the panel straight up and remove.

We’re you having the problem of the speaker magnet sticking to far back of the window regulator in the front?

I just looked up my truck by year and model on the AutoZone site

Came with my order when I ordered off crutchfield. Link is in my bio 👍🏼

Per pair

All the parts shown in the video are from Autozone

Yeah man I should. Stay tuned

He failed to say the reason he didn't put 6x9 in the fron its cause the magnet its too big and there's a bar that runs across the back of the speaker housing and won't fit 6x9 that's why he bought the smaller ones with the fitting plastic.

Yeah it seems that way. Unfortunately they’re just trying to make a quick buck. I’m blessed to have the knowledge and skill to work on my own vehicles. I avoid shops as much as possible

Sorry for the late response! I recommend disconnecting the battery just a precaution

I’m not too sure. I opted for the 6.5 inch speaker rather than the 6x9 for the front.

Buy a Metra 1/4 spacer off Amazon

www.crutchfield.com/S-gRUJlLMISYk/

I still really enjoy them, totally worth it. Honestly if your budget allows you, I don’t see why not. The sky is the limit with car audio

It’s a 2012 Tradesman. I didn’t change my head unit and they’re loud and clear. Not crazy bass though

Was more bass aftermarket than original (lower freq)

Was it louder (decibels) as well?

was using a homemade ned rig

Crutchfield.com check your make and model to see what fits

I wanna say about $250 for all 3 sets

Of course! Thanks for watching!

Yo it’s been a min since I handle a fish. After editing the video I did notice I was super rough with the fish and felt kinda bad. I’m usually pretty careful lol

Nice! That’s pretty smart. I wanted to do more but was just too lazy and wanted something right away lol

Thanks for watching! I ended up at the Cholla Campground

@@RobOutdoors623 We usually go to burnt corrals, closed until further notice looking for new area, really appreciate it.

@@heathergamez9512 no problem. Glad I could help

You should.

Tbh I’m not too sure, I think the magnet on those speakers are too big to fit a 6x9. I just went off Cruthfields website recommendation

@@RobOutdoors623 damn i already bought a pair of 6x9 for the front lol. I’ll update once i try to get ‘em in

@@alcatraz442 yeah I’d try it and see if they fit. The OEM speakers are 6x9 but the magnet is small so hopefully yours fit! Thanks for watching!

@@RobOutdoors623 just got done installing all 4 doors with 6x9’s, all fit like a dream! I used the KS series 6x9’s from kicker, magnet was definitely larger than the stock, but it fit just fine 👍 thanks again for the detailed vid

@@alcatraz442 of course man! Glad to hear that! I appreciate the support!

Crutchfield.com