very nice vid.. can you please make a new video like this with high resolution. thanks.
@adamconnolly74782 ай бұрын
M grip wont come off, any tips?
@TindaIPSC5 ай бұрын
Thank you.
@TheCalfMuscle10 ай бұрын
Can you do a video to replace slide stop please
@alfredocuomo154610 ай бұрын
So the same screw retains the firing pin & the Extractor? I watched your other video too. Nice job, good luck growing the channel.
@alfredocuomo154610 ай бұрын
That could have been a great video if there was some narration on what you were doing and a few close up would have been nice. I hope you accept it as constructive criticism because you obviously know what you're doing. Thanks for your efforts.
@adamconnolly7478 Жыл бұрын
What is the slide finished in? Is it bare?
@gunstopgr9216 Жыл бұрын
The barrel finish is DLC.
@gunstopgr9216 Жыл бұрын
Sorry, the barrel finsh is stainles steel (bare). The slide and frame is DLC.
@adamconnolly7478 Жыл бұрын
@@gunstopgr9216 thanks for replying! However my slide does not look silver like yours....
@gunstopgr9216 Жыл бұрын
@@adamconnolly7478 This slide in the video is not DLC, it's without finish probably. This slide (in the video) is a prototype slide from the factory used to show the firing pin replacement.
@SuperTjarko Жыл бұрын
thank you very much !!
@vakaleonplavac8121 Жыл бұрын
Nice video! One question, To reassemble the barrel, do you use the same factory pins or new ones?