I have an older model AirRouter but the menus were similar enough that I was able to configure the bridge according to your instructions. Thanks!
@drcanoro5 жыл бұрын
one thing that wasn't included in the tutorial and it help me out, is that I manually copy the MAC address from the "Site Survey" window to the "Lock to AP MAC" field under the "Wireless" Tab. also, since my Internet Service Provider uses a 0 in the third set of numbers of the IP ( xxx.xxx.0.xxx ), I had to change the iP address of my Nanostation to 192.168.0.20, Subnet Mask 255.255.255.0, Gateway 192.168.0.1, Preferred DNS 8.8.8.8, Alternative DNS 8.8.4.4, that's how it worked for me.
@filippasantekelidhs1406 жыл бұрын
ty bro nc video
@hing9836 жыл бұрын
what is mean setup airgateway as client , station , brige
@chickengod1006 жыл бұрын
Hi, Do you have an operating system file to upgrade this device?
@naskodiskoto6 жыл бұрын
Again ?????
@mohsenelbialy11907 жыл бұрын
after upgrading I interned 192.168.1.1 then it gives me the main DSL router set up page not the dd-wrt setup page ... pls help
@ivokaloyanov12837 жыл бұрын
Mohsen Elbialy Hi. your adsl modem is under the same ip. switch off modem than you can access the ddwrt. change to a different IP for example: 192.168.2.1 than switch on modem. Now IP is different so won't be a problem.
@arakrachael59097 жыл бұрын
Благодаря! Това е доста полезно, особенно за нас бедните българи. Много хора ще се зарадват ако знаят че може да си направят стария рутер на репеатер или на wifi към ethernet устройство.
@adilbutt49497 жыл бұрын
thanks alot buddy. its working like a charm.
@CrazyGamer-yq9mx7 жыл бұрын
when i go to my browser to type 192.168... it wont load the airis site..can u plz help? maybe ive done smthing wrong with the IPs ive entered
@DerAdler828 жыл бұрын
Thanks man! I wasted my time looking on the dd-wrt community for an "how to" topic, then, eventually, I found this video with simple and clear steps about how to set the device to act as repeater. Too many geeks out there ^_^
@VimalesanMurugesan8 жыл бұрын
It worked for me, thanks for the video.
@karriaravind8 жыл бұрын
reset button not working ,can any one help me
@ivokaloyanov12838 жыл бұрын
make sure that your network is on chanel 1-11
@fazilbashasn8 жыл бұрын
hi, i followed all the steps but in the start survey networks list i cant find my primary network but there are some other neighbours networks. can u please suggest me to fix this.
@Morpheus2069 жыл бұрын
hello I have a question I install dd-wrt to the TPLINK WR740N has cost me much set it and do not know if this well configured in the end the question is whether when installed this firmware LEDs on the RJ45 ports ranging from 1 to 4 ?, they stopped working because mine does not work only on if the restart but not if you have the cable connected. Thank you for your attention. Regards.
@abyoommen9 жыл бұрын
I followed you steps but at last when i check the status there is no connection found.. It again shows "Survey". Please Help
@HunterRose15129 жыл бұрын
thanks you very much
@ivoivanov80809 жыл бұрын
6to pri men nese polu4ava ni6to
@arjunajn9 жыл бұрын
Thank you great video. I have something to add/ask. In Client Bridged Mode the router does not act as a range extender it simply act's as a extender of the LAN Network and a WLan Switch. I tried it range was not extended Is there any method i can use this as a repeater with the same SSID ? That would be awesome.. Thanks
@ArshdeepSingh-pi7tv9 жыл бұрын
hey after upgrading router flashing all lights again and again when it will be ready please help....
@vincentvillanueva78919 жыл бұрын
Hi! Can I get some help? I think I made a mistake.