I feel your pain 😢

Need a new shaft it’s too long

Chains shaped maybe

Put the spark plugs back in

must of stretched timing chain or tension went bad and bent ever valve in motor

Check warpring in head line and check valve spring

I was about to say broken timing chain, because it sounded like the starter motor was spinning way too easily. But then, through that opening in the top center of the valve cover I noticed that the rocker arms were indeed moving up and down, which means that the timing chain is not broken. My next check would be engine timing, if the timing chain is stretched or the tensioner failed it could cause it to jump some teeth that could cause low or no compression in all cylinders due to the valves not closing fully during the compression stroke.

Check timing marks

Intake valve blow by duhhh

Sounds like it’s a freeze spinning no timing chain

Ain’t got no gas in it

Have you got the plugs in at least...?

Dont want copper slip in there itll turn to mud in around 6 months and be stuck again within a year . Silicone grease your needing. Copper grease for the pads to carriers

Nice

A bolt-shaver-downer is peak one-use tool, but if you don't have a vice handy and it's this or an angle grinder, I'd say this is gonna leave you with the most fingers.

I ordered one from temu, as i saw what it claimed it could do,haven't needed to try it out yet,glad to see it does 😀