WRXDaily

Пікірлер

@SubieLifeG13 3 күн бұрын

I ❤ miss mine

@JimzOnDroid 6 күн бұрын

Is this setup on stock suspension? I’m looking to replace wheels and leave stock suspension setup. If on stock you said you could go one size sidewall larger ? Thanks

@wrxdaily 5 күн бұрын

This is on Fortune Auto coilovers! If you're on stock suspension, we would recommend increasing tire size to 265/35 to fill in more of the wheel gap.

@JimzOnDroid 5 күн бұрын

@@wrxdaily thank you for the advice bro 👊

@Menace_sti Ай бұрын

Ill take some in white haha. But man they look good

@wrxdaily Ай бұрын

The gunmetal wheels would fit your grey super well!

@Adam-ev4zt 3 ай бұрын

was the gasket you used from your car originally? Or did you purchase separately?

@wrxdaily Ай бұрын

The Remark Axleback comes with gaskets and hardware!

@azca. 5 ай бұрын

Peo0ple probably think you're doing a drive-by

@poipounderkimo 6 ай бұрын

No problem getting a smog???

@wrxdaily Ай бұрын

An axle-back would not affect the emissions of the vehicle!

@ESGR1 7 ай бұрын

do these go lower than what you set them at?

@wrxdaily Ай бұрын

Yes, these go much lower than what we set them at.

@mannyvasquez9114 7 ай бұрын

Can I use the stock hardware the car came with to instal ???

@wrxdaily Ай бұрын

As long as the hardware is in good condition, that would not be a problem.

@Subi_doo 8 ай бұрын

Cracks a lot to be stock…..

@jsijjsi4924 8 ай бұрын

Check your facts bud anyone with a wrx knows they backfire stock with a simple axle back.. so relax mr 02 civic

@Subi_doo 8 ай бұрын

@@jsijjsi4924 cool 👍

@wrxdaily Ай бұрын

We said the same! FA engines like to backfire a lot, even with the factory tune.

@tiddymoze5462 8 ай бұрын

Hey man! Just picked up a 2023 WRX and ive been thinking about making this upgrade a lot recently. Should I wait before installing it since its brand new or can I make this upgrade at any time?

@Jclipse250 7 ай бұрын

At anytime … just got mine a couple days ago and I’m bout to install mine

@wrxdaily Ай бұрын

You can make the change right away, this will not affect your warranty.

@xXpapercutsXx 9 ай бұрын

Just installed the muffled ETS on mine today. Is it just me but, I can’t remember there being factory gaskets inbetween the mufflers and the Y pipe at the connection. Or at least, I didn’t get one off it….is there one? Now I’m all paranoid 😂 thinking I woulda had to see one if there was one. My connection looked nice n flush though with the ETS supplied one 👍🏻

@wrxdaily Ай бұрын

I don't remember haha, typically Subaru has not had many gaskets in the past, but it looks like they might be changing that up with newer vehicles.

@kurtmods13 11 ай бұрын

Is the coilover already set on the ride height? Or is it rinse and repeat until you get them all lined up

@wrxdaily 11 ай бұрын

It really comes down to your style and goal with your fitment. We wanted a one finger gap more or less so it took two tries to get them to sit how we wanted!

@cristopherlopez6655 11 ай бұрын

Adrian rocks every tutorial making it easier for me to work on my WRX 🤘

@wrxdaily 11 ай бұрын

Great to hear!

@tanpham3837 11 ай бұрын

are coilovers fine with stock rear control arms?

@wrxdaily 11 ай бұрын

They are ok with stock rear control arms; however, we highly recommend adjustable ones! We currently have the factory rear control arms but will be upgrading to a set of SuperPro control arms in a video coming shortly. The factory control arms are not able to adjust you rear camber. This could become a problem depending on how long you want to your vehicle to sit.

@dann1483 Жыл бұрын

hey man I’m interested in this exhaust for my 22 Wrx but I own the gt which is automatic. Would u still get those pops and bangs?

@shuvam_gtm 11 ай бұрын

No!

@wrxdaily 11 ай бұрын

Unfortunately they would not have the pops and bangs like our shop car (manual transmission).

@CedricQuartey 10 ай бұрын

You’ll get some here and there in manual mode if you get a good up shift near the 5-6k rpm’s. I get a “pop” sound when I push my CVT hard in the 40-45 mph range when goin frkm 3-4, and sometimes hard pull on 2-3, or high rpm’s. Not as aggressive as this though

@Subi_doo 8 ай бұрын

Sell it and get a manual. Automatics are harder to tune and most don’t like adding power. It’s not like a manual where when you increase power you can upgrade the clutch. Your going to blow that car apart if you decide to tune it.

@geozhao579 Жыл бұрын

Where did you buy it?

@wrxdaily Жыл бұрын

Here's a link to purchase! wrxdaily.com/products/remark-4-burnt-stainless-single-wall-axle-back-2022-wrx?_pos=10&_sid=e6d28f9d3&_ss=r

@ndphamvanbau1 Жыл бұрын

I have a question. I just purchased 23’ model few days ago, and it already had small spoiler (oem) installed. Is there instructions how to remove the oem prior to install your CF? Please advise. Thanks..

@EdwardSteadfast Жыл бұрын

…pull the clips on the trunk lid carpet, the center of the clips lift up then you pull out the clip. Then from the inside of the trunk there are two 8mm bolts that need to come out. You will need an extension for your rachet. There are two clips that hold the spoiler down.. just pull the spoiler off there is no glue or tape. Just pull hard you’ll hear and feel two clips. 🤙🏼

@ndphamvanbau1 Жыл бұрын

Many thanks

@Tlxmiami305 Жыл бұрын

god dam those pops!!

@wrxdaily Жыл бұрын

Popcorn!

@spencertchow Жыл бұрын

paint matched fenders now??

@spencertchow Жыл бұрын

wowwww

@DaneGopaulsingh Жыл бұрын

How do you get the pops I have the same axle back but no pops

@wrxdaily Жыл бұрын

These pops were right at redline shifting from second to third. It's all about the upshifts to get the pops

@Biotired Жыл бұрын

Is there a reason you chose single wall over double wall? And is you 23’ still stock? Lots of pops 👀 if it is

@wrxdaily Жыл бұрын

The reason we went with the single wall was for purely for looks. There is no noticeable sound difference when comparing the two. Yes, it's bone stock!

@jaunc964 Жыл бұрын

Just installed Remark Muffler Axleback Exhaust Burnt Double Wall, thank you 🙏🏼 for the video. This was supper easy. The only thing I would add is to double check the bolts after testing the car out. Make sure the bolts are tight enough and no gas is leaking from the connection.

@wrxdaily Жыл бұрын

Awesome! We did double check the bolts off camera because there was a slight leak but did that off camera. We appreciate the insight!

@longshanks5531 11 ай бұрын

Should they be torqued to a certain ft lbs? Or just right? Thanks!

@WallsAndFoundations Жыл бұрын

Excited to see what yall do man! New fan, stoked to see the happenings! Eventually i wanna grab that new crazy carbon rear bumper cover yall got. Maybe we'll see a video with it installed on the shop car? 👀

@wrxdaily Жыл бұрын

Thank you for the support! We might just have to install it once they arrive! We're super excited for them.

@dimeweld Жыл бұрын

When are the taillights for the VB coming! I pre ordered, dying to know!😊

@wrxdaily Жыл бұрын

Per OLM, they are expecting to see these around early-mid August!

@daviddubail-tyler7363 Жыл бұрын

👍 thanks for all your help

@wrxdaily Жыл бұрын

You are very welcome! It's a pleasure to help

@Menace_sti Жыл бұрын

Hello guys! Looking forward to your channel!

@wrxdaily Жыл бұрын

Thanks Dennis! Loving the new color on your STI ;)

@Menace_sti Жыл бұрын

@wrxdaily thank you! And yeah loving it 👌

@EdwardSteadfast Жыл бұрын

Stoked for you guy! ❤

@wrxdaily Жыл бұрын

Thank you! It means the world to us.

@EdwardSteadfast Жыл бұрын

How to in stall.. remove four bolts… difficult level1 😂❤

@wrxdaily Жыл бұрын

Hahaha, it was a breeze. DIY Level 1/10 If the car wasn't brand new and the bolts were rusted it would maybe be a 3/10

@WallsAndFoundations Жыл бұрын

To anyone who plans on doing exhaust replacements, I HEAVILY recommend grabbing an exhaust hanger removal tool. A good one can be bought for right about $20-$30 and will become an invaluable tool in your collection. Exhaust install by myself with no lift took like an hour or so.

@EdwardSteadfast Жыл бұрын

Wd40 is a gift to the world. …witness the “removal tool extraordinaire” 😂

@WallsAndFoundations Жыл бұрын

@EdwardSteadfast it really is the best! Spray that on everything man 😂

@wrxdaily Жыл бұрын

Agreed! Exhaust removal tool will ALWAYS be your friend. It's vital with a catback exhaust install.

@techshedlington3106 Жыл бұрын

What is the cabin drone like when out on the road?? A video from inside whilst driving would be helpful... Nothing like a done headache after a few hours on the road 😵‍💫

@wrxdaily Жыл бұрын

Coming from a 2021 STI with a Tomei, there is some drone; however, it is nothing that could be found annoying. From our experience, someone who is worried about drone should look to the ETS Quiet Axleback or the Nameless 4" Axleback. These are both great systems that give you some more tone and volume, but will reduce any drone.

@spencertchow Жыл бұрын

wowwwwww