Cheers very good vid

Thanks for posting this - really helpful. I have a 2016 Combo D and really struggling to find manuals and other info! The service light video is a blessing - that's been driving me nuts for years!

Thanks for taking the time to make this video........very useful

What was the symptoms u had to show it was the inhibitor that was at fault thanks

What was the problem you were experiencing which resulted in changing this part. I have a 2011 Barbarian which sometimes will jump out of gear or stay on same gear and won’t change up. When these happen the display screen goes blank and doesn’t display any gear. I sometimes have to hold the lever in drive so it doesn’t jump out of gear. I have been told a full gearbox rebuild is the answer. Around £3000 costs.

Can this be bumped started it slowly pull out the pull start and let go it starts as I have a bad shoulder

Cheers mate, this video helped me heaps 🇦🇺🤙🇦🇺

Make sure bonnet and boot are closed to test.

Thanks for posting

Good vid. Which two springs did you leave out?

Had one for 1 day cold start fell out sent it back rubbish

I've had one for a few years (it only gets used for a couple hours at the weekends) and it works quite reliably for a cheap knock-off. I won't suggest it if you're using a chainsaw heavily, invest in sthil, huskavana or oregon for heavy use; but it works well for on off domestic. The fuel mix is 40:1 but has a fair amount of leeway, although it does drink like a fish. Only problems I have had is in the last couple of months where the oil and fuel pipes have perished causing leaks and the spring of the pull cord has slipped. Comparing it to my Husky, the P1 has parts that are made cheaper and not fit for as much use. It is very much a "get what you pay for", but again for small domestic use its much better than I thought.

Always buy a Husqvarna petrol chainsaw, or Sthil

Thanks.

Great video - great help very similar to fiat doblo thanks

Thank you

Had my inhibitor switch adjusted couple of times but vehicle still give me trouble to go into drive...could it be that the part needs cleaning or do I need to purchase a new one ?

I have the hyundai hyc6200x it has 40:1 fuel mix. Left some fuel in in the summer and it would not start in December. Took the carb out to clean following Adrian advice on how to take it out. Needed a special tool to adjust the carb as it's not supplied. The unit worked for 1h last Sunday then it stopped and would not start. Today was I hoping to adjust the carb with the tool and it started then died, then the cord seem to have broken the plastic inside that turns the thing on. Not impressed. It has been used 4 times in 2 years. See what the guarantee is like.

Soooo did it work? It's not so much the weight of the lever I don't like, it's the abruptness of the engagement. I've also read that ATF makes them more grabby so I've gone back to normal 10w40 motorcycle oil (motul 7100) for my next ride.

I have a 16 plate struggled to start on frosty mornings so I thought I change battery so I did that then it never turned over again, I basically use drums of disels to fill up could this be the fuel filter

Hi mate, did you manage to get to the wiring harness without removing the front drive shaft?

Good try mate, but no call for an open heart surgery for reaching the plugs on a CB500. See to that you blow away dirt now and then from the wells (generally clean thanks to the plastic block lids on the cables) using compressed air, and then you push in the tools from below the tank, up first, then down, there is space.

Thanks!

How did you remove the clip from the body as I have a 2006 mitsubishi Triton 3.0 transmission inhibitor switch faulty and need to get it off and replace.. Have no room to get to switch clip

sound is too low...

Hi David, your words have filled me with dread! In the past I have always bought Stihl or Husqvarna but was convinced by someone to buy one of the above. To be honest, I was shocked at how inexpensive it was to buy (under £120) but bought it anyway. I am using it for the first time over the weekend and hope it works!

Just bought one via Amazon. First one the circlips holding the chainbrake together sheared off with the vibration and shed the spring, making the brake inoperable. Amazon replaced the saw and the same thing happened to the replacement. Those retaining circlips are not fit for purpose. I would look elsewhere for a chainsaw. This is just a badged far eastern sourced product that is not fit for purpose.

Well mate could you do an update on the chainsaw thinking about buying one

What kind of brackets? Do you have a part # from Screwfix?

Breather air pull through thingy😂brilliant mate . Made my job a lot easier, do the plug caps clip onto the block or just cover the plug holes?

Do you need a ZEM to add a wireless fob to a euro 46 system?

Useful, thanks!

I can't find these either, where can I get some from?

Love the look would love these on my truck have looked all over the net with no joy any chance you could post a link as to were you purchased or equivalent car make that fits recess. Kind Regards IanH

That doesn't tell me how to remove the unit from the car. How do you unplug the harness from the unit?

In resume, what is Better?

Your boss fella but my dash lights up even when key isn’t even in ignition

Hello where do you buy the steppenmotors?

In my car prob is. Wipers start automatic. Rear wiper counties running. Sometime front wiper doed not work even. Is it usefull

Poor jojo

JoJo are u ok???

Did u fix it after I'm getting same prob with my transit clocks not working

I was there 😂

I was there on the other side it was so funny

Got 3 if them,they look class! And honestly I’ll be tempted to keep mines when it’s empty! Only one superstore had them for sale I found on the internet and it was about 6/7 miles away but I’ve not cracked in yet? Maybe Celtics next Champions league game? Drowning my sorrows or celebrating a win? But 🍺Cheers!🍺

cheers bud hopefully mine is that

did this work ? mine has that problem now

why so many dislikes? i found it usefull thx for the upload

Thank you for a good viswo....it helped me alot:-)

Stupid moron with bad diction